System Sensor DH100 Series Manual de usuario

Replacement Detector Boards

Ionization Detector Board: part number A5052

Photoelectric 2-Wire Detector Board: part number A5180

Photoelectric 4-Wire Detector Board: part number A5190

NOTE: PHOTOELECTRIC DETECTOR BOARDS CAN ONLY

BE INSTALLED IN PHOTOELECTRIC DUCT SMOKE

DETECTOR MODELS; IONIZATION DETECTOR BOARDS

CAN ONLY BE INSTALLED IN IONIZATION DUCT SMOKE

DETECTOR MODELS.

IMPROPER INSTALLATION WILL VOID ALL AGENCY APPROVALS.

Detector Board Replacement Instructions

1. Notify the proper authorities that the smoke detector system is undergoing

maintenance and that the detector will temporarily be out of service.

2. Turn off power to the duct smoke detector.

3. Remove the two detector board mounting screws.

Retain screws for installation of new board.

4. Pull gently on the board to remove it from the detector housing.

5. Align the board mounting features, holes, and interconnect terminals

with the features on the duct smoke detector housing.

6. Push the board into place.

7. Secure the board with the two board mounting screws.

8. Perform the detector checks as outlined in sections 6.2.1 and 6.2.2.1 of the Installation and Maintenance

Instructions to ensure proper detector operation. The tests performed must include:

A. Visually check to see the green power LED blinks once every ten seconds, indicating power to the duct

smoke detector. If the green LED does not flash, the detector lacks power (check wiring, panel or power

supply), the detector board is missing (install), or the unit is defective (return for replacement).

B. Perform the magnet test to initiate an alarm condition. Reset the detector using the local reset button,

remote accessory or system control panel.

Return all ionization boards to System Sensor for proper disposal: System Sensor

3825 Ohio Avenue

St. Charles, IL 60174

For additional assistance in this process or questions, please contact System Sensor Technical Service at

800-SENSOR2 (800-736-7672).

D100-71-00 1 I56-1359-01

DH100 Series Duct Smoke Detector

Replacement Detector Board

INSTALLATION AND MAINTENANCE INSTRUCTIONS

A Division of Pittway

3825 Ohio Avenue, St. Charles, Illinois 60174

1-800-SENSOR2, FAX: 630-377-6495

A5180/A5190: Photoelectric

Detector Board

A5052: Ionization

Detector Board

Replacement Power Boards

Two-Wire Power Board: part number A5061

Four-Wire Power Board: part number A5064

NOTE: TWO-WIRE POWER BOARDS CAN ONLY BE

INSTALLED IN TWO-WIRE DUCT SMOKE DETECTOR

MODELS; 4-WIRE POWER BOARDS CAN ONLY BE

INSTALLED IN 4-WIRE DUCT SMOKE DETECTOR MODELS.

IMPROPER INSTALLATION WILL VOID ALL AGENCY APPROVALS.

Replacement Power Board Installation Instructions

1. Notify the proper authorities that the smoke detector system is undergoing

maintenance and that the detector will temporarily be out of service.

2. Turn off power to the duct smoke detector.

3. Mark the location of all wires to the terminal block.

4. Disconnect all wiring from the terminal block.

5. Remove the two power board mounting screws. Retain screws for installation of new board.

6. Pull gently on the board to remove it from the detector housing.

7. Align the board mounting features, holes, and interconnect terminals with the features on the duct smoke

detector housing.

8. Push the board into place.

9. Secure the board with the two board mounting screws.

10. Reconnect all wiring to the terminal block.

11. Apply power to the duct smoke detector.

12. Perform the detector checks as outlined in sections 6.2.1 and 6.2.2.1 of the Installation and Maintenance

Instructions to ensure proper detector operation. The tests performed must include:

A. Visually check to see the green power LED blinks once every ten seconds, indicating power to the duct

smoke detector.

B. Perform the magnet test to initiate an alarm condition. Reset the detector using the local reset button,

remote accessory, removing power or system control panel.

For additional assistance in this process or questions, please contact System Sensor Technical Service at

800-SENSOR2 (800-736-7672).

D100-71-00 2 I56-1359-01

DH100 Series Duct Smoke Detector

Replacement Power Board

INSTALLATION AND MAINTENANCE INSTRUCTIONS

A Division of Pittway

3825 Ohio Avenue, St. Charles, Illinois 60174

1-800-SENSOR2, FAX: 630-377-6495

A5064: 4-Wire Power Board

A5061: 2-Wire Power Board

Tabla de contenidos

Otros manuales de Detector de humo de System Sensor

System Sensor

System Sensor Innovair SSK451 Manual de usuario

System Sensor

System Sensor 7251A Manual de usuario

System Sensor

System Sensor 2251A-COPTIR Manual de usuario

System Sensor

System Sensor 7251DH Manual de usuario

System Sensor

System Sensor 2WTR-B Manual de usuario

System Sensor

System Sensor DNRHS Manual de usuario

System Sensor

System Sensor 2100 Manual de usuario

System Sensor

System Sensor FAAST Manual de usuario

System Sensor

System Sensor 1151 Manual de usuario

System Sensor

System Sensor DH400ACDCIHT Manual de usuario

System Sensor

System Sensor Innovair DH100 Manual de usuario

System Sensor

System Sensor InnovairFlex D4240 Manual de usuario

System Sensor

System Sensor Innovair Flex D2E Manual de usuario

System Sensor

System Sensor Innovair DH100ACDCLPX Manual de usuario

System Sensor

System Sensor B402B Manual de usuario

System Sensor

System Sensor PERTRONIC DNRW Manual de usuario

System Sensor

System Sensor 2400 Manual de usuario

System Sensor

System Sensor 2251EIS Manual de usuario

System Sensor

System Sensor 1400 Manual de usuario

System Sensor

System Sensor INNOVAIR DH100ACDCP Manual de usuario

System Sensor

System Sensor 1400 Manual de usuario

System Sensor

System Sensor 2112 Manual de usuario

System Sensor

System Sensor B224RB Manual de usuario

System Sensor

System Sensor 2112 Manual de usuario

Manuales populares de Detector de humo de otras marcas

x-sense

x-sense SD19-W Manual de usuario

BRK electronic

BRK electronic First Alert P1010 Manual de usuario

FireAngel

FireAngel Thermoptek ST-622 Manual de usuario

teko

teko Astra-42A Manual de usuario

Safetec

Safetec SDS-2/6 Manual del propietario

Siemens

Siemens PE-11C Manual de usuario

Resolution Products

Resolution Products RE612 CryptiX Manual de usuario

First Alert

First Alert PC900V Manual de usuario

Eminent

Eminent EM6590 E-Domotica Manual de usuario

Ei Electronics

Ei Electronics Ei Ei168RC Manual de usuario

Carrier

Carrier Kidde Quell Q301 Manual de usuario

VESDA

VESDA VLF-500 Manual de usuario

ELRO

ELRO FS8110 Manual de usuario

Heiman

Heiman SMOKI NS-626PHS Manual de usuario

Regin

Regin SDD-S65 Manual de usuario

Family Gard

Family Gard FG225 Manual de usuario

Greystone

Greystone DSD120 Manual de usuario

Aparton

Aparton ASD-10 Manual de usuario