System air VTK Airvent Manual de usuario

Document in original language | · A001

VTK Airvent

Installation instructions GB

| A001

E&OE

Systemair AB reserves the rights to alter their products without notice.

This also applies to products already ordered, as long as it does not affect the previously agreed specifications.

| A001

Contents

1 Making holes for the duct..................................1

2 Mounting ......................................................1

3 Function........................................................1

4 Accessories....................................................2

4.1 Mounting washers..................................2

4.2 Filter change .........................................2

Making holes for the duct | 1

1 Making holes for the duct

Drill holes through the inner wall, dimensions according to the table. See image for suitable location.

VTK ø (mm)

80 85

100 105

125 130

160 165

2 Mounting

1. Cut the duct to adjust to the thickness

of the wall

2. Mount the duct through the wall and

use the fastening lugs to attach the duct

with two screws.

3. From the outside, push the wall grid

with extension against the wall duct. Use

filling material against the outer wall if

needed.

4. From the inside, push the airvent into

the duct. The gasket keeps the airvent in

place, no screws are necessary.

3 Function

VTK has a temperature sensitive and automatic thermostat that regulate the airvent plate and adjust the air gap and al-

so the amount of air depending on the outside temperature. The airvent opens less when cold outside. If the airvent is

in auto mode the supply of outside air decrease gradually down to -5° C.

When the temperature rises the airvent opens gradually and are fully open at +10° C. The setting can easily be ad-

justed. By turning the airvent’s plate from auto position; clockwise if you need it to close earlier or counter clockwise if

it should stay slightly open at temperatures under -5° C.

Locknut

Spring

Thermostat bulb Plate

Valve

Guide notch for auto mode

Condensation insulation

Guide

Stop for locking

guide notch

Drive pin

| A001

2|Accessories

4 Accessories

Filter and accessories are available at www.systemair.com.

4.1 Mounting washers

1. Turn the airvent’s plate counter clockwise from auto mode and detach.

2. Mount the washers to desired gap opening on the guide, add 2 mm (the stud on

the washer shall run in the track of the guide).

3. The washers are available in 2 and 4 mm thickness. A 4 mm washer provides 2

mm gap opening. One 4 mm + 2 mm washer provides a 4 mm gap opening.

4. Turn the plate to auto mode.

4.2 Filter change

It is recommended to change the filters between 1-3 years interval depending on placement and air quality.

1. Mount the filter first on the airvent. Ensure that the

filter encloses the venting house and the rubber seal.

2. Push the airvent and filter in to the duct.

3. If correctly mounted, the gasket should hold the

airvent firmly in the duct, no screws are necessary.

| A001

VTK Airvent · Installation instructions · · en_GB · 01-06-2017 · A001

Systemair Sverige AB

Industrivägen 3

SE-739 30 Skinnskatteberg, Sweden

Phone +46 222 440 00

Fax +46 222 440 99

www.systemair.com

Tabla de contenidos

Otros manuales de Admirador de System air

System air

System air Topvex SX/C Guía de solución de problemas

System air

System air KBR Series Manual de usuario

System air

System air fantech CSF4 Manual

System air

System air RS Series Manual

System air

System air Multibox MUB Manual

System air

System air SAVE VTC 200-1 Manual de usuario

System air

System air VEF 1 Manual

System air

System air SAVE VTR 200/B Manual de usuario

System air

System air Ex 140-2 Guía de solución de problemas

System air

System air 445307 Manual de usuario

System air

System air Ex 140-4 Guía de solución de problemas

System air

System air VSR 300 Manual de usuario

System air

System air Essvent S Manual

System air

System air SAVE VTC 500 Manual de usuario

System air

System air DVS series Manual de usuario

System air

System air ORV Series Manual de usuario

System air

System air SYSVRF2 DUCT HP 71 Q Manual de usuario

System air

System air KDRE Manual de usuario

System air

System air Topvex SoftCooler SR11 Manual de usuario

System air

System air fantech bathfan Select Fit SF Series Manual

System air

System air EE VTR 250/B Manual de usuario

System air

System air EX Series Manual de usuario

System air

System air DVCI Manual de usuario

System air

System air Fantech ATMO Series Manual de usuario

Manuales populares de Admirador de otras marcas

ELTA FANS

ELTA FANS H03VV-F Manual de usuario

Hunter

Hunter 20714 Manual de instrucciones

Emerson

Emerson CARRERA VERANDA CF542ORB00 Manual de usuario

Hunter

Hunter Caraway Manual de instrucciones

Panasonic

Panasonic FV-15NLFS1 Manual de usuario

Kompernass

Kompernass KH 1150 Manual de usuario

VES

VES FALA100/12V/TR Manual de usuario

Vertiv

Vertiv Liebert DCD Manual de usuario

Westinghouse

Westinghouse GFP Series Manual de usuario

Venmar

Venmar KUBIX HRV PLUS Series Manual de usuario

Maico

Maico ECR 31 Manual de usuario

Sonnenkonig

Sonnenkonig Dinky Manual de usuario

S&P

S&P ECOWATT HXBR Manual de usuario

Wider

Wider IMP03369BH Manual de usuario

Panasonic

Panasonic F-60DHN Manual de usuario

Hinkley

Hinkley HIGHLAND Manual de usuario

Broan

Broan 766BN Manual de usuario

Premium

Premium PFS16022 Instrucciones de montaje