Swingline Stack-and-shred60x Manual de instrucciones

start here

démarrez ici

empieza aquí

comece aqui

SHREDDERS

™

STACK-AND-SHRED60X

2min

MAX

SHREDDERS

™

STACK-AND-SHRED60X

English instruction manual 6

Francais manuel d’utilisation 12

Español manual de instrucciones 18

Português manual de instruções 24

6register this product online at www.accobrands.com

To guard against injury, the following basic safety precautions must be observed in the set-up of this

product.

• Ensure the machine is plugged into an easily accessible power outlet, and ensure the cable is not

likely to trip up a passer by.

• Any attempt to repair this unit by unqualied personnel will invalidate the warranty. Please return to

supplier.

• Unplug your shredder before moving it or when it is not in use for an extended period of time.

• Do NOT operate with a damaged power supply cord or plug, after it malfunctions, or after it has

been damaged in any manner.

• Do NOT overload electrical outlets beyond capacity as this can result in re or electrical shock.

• The socket-outlet should be installed near the equipment and shall be easily accessible.

• Do NOT alter the attachment plug. The plug is congured for the appropriate electrical supply.

• Do NOT use near water.

• Do NOT use aerosol dusters or cleaners.

• Do NOT spray anything into the shredder.

• Do NOT load the auto-feed chamber with unopened junk mail, magazines, bound documents etc.

Although this shredder has been designed to comply with UL 60950-1 EN 60950-1 safety standards

including the “probe accessibility tests”, do not operate the shredder near children or pets.

autofeed technology

The Stack and Shred 60X has been designed to automatically shred up to 60 sheets from the

auto-feed chamber and up to 5 sheets through the manual feed slot. The auto-feed mechanism has

been designed to handle paper fastened with staples and paper clips and to only pull a few sheets

of paper into the cutting mechanism to minimise the risk of paper jams.

Sheet capacity:

Manual feed slot

5 sheets (80gsm)

Sheet capacity:

Autofeed chamber

60 sheets (80gsm)

Duty Cycle 6 min ON / 40 min OFF

technical specifications

Swingline Stack and Shred 60X

Run time from cold 8 minutes

Volts / Hz 120V / 60Hz

Amperage 0.8 Amps

Motor Watts 180 Watts

English

STACK-AND-SHRED 60X™SHREDDERS 7

control panel and indicators

Continuous Jam BoostReverse Auto

warning symbols

This means no aerosols.

This means keep children away

from shredder.

This means you should be careful

because long hair can become

entangled in the cutting head.

This means don’t reach into the

feed opening of the cutting head.

This means be careful of loose

jewellery which could become

entangeld in the cutting head.

This means no oil lubrication,

use Swingline oil sheets only.

This means be careful of ties and

other loose clothing which could

become entangled in the cutting

head.

This means the shredder can

accept small paperclips.

This means the shredder can

accept small staples.

Safety First

Sheet capacity of manual feed

entry slot.

English

Cool Down indicator – This means

the machine is cooling down.

8register this product online at www.accobrands.com

Stack and Shred 60X shredding capability

Stack and Shred 60X CAN shred the following:

• 60 sheets

• Stapled paper, 25mm within the corner

• 26/6 and 24/6 or smaller staples

• Small sized paper loaded centrally

• 60 sheets

• Paper clip paper, 25mm within the corner

• Capable of shredding small/medium paper clips (max. wire thickness = 0.9 mm)

• >100gsm paper (through manual feed slot ONLY)

• A3 folded in half max. 2 sheets

• 60 sheets

• 80 gsm paper

- Letter and Legal

- A3 single sheet folded in half to make A4

Stack and Shred 60X CAN shred (through the manual feed slot):

Thick paper or

card.

Multiple folded

sheets (e.g. A3

sheets folded in

half).

Unopened mail

(e.g. junk mail).

Glossy paper or

a sheet covered

with print on both

sides.

Stack and Shred 60X CANNOT shred the following:

Large clips.

Check the length

of the paperclip

is not longer than

32mm.

Heavy duty

staples. Check

the staple leg

length is not

greater than

6mm.

Bound

documents

Bulldog clips

Magazines or

other documents

bound by multiple

staples or clips.

Adhesive labels.

Plastic sheets,

laminated

documents,

plastic folders.

English

STACK-AND-SHRED 60X™SHREDDERS 9

1. operation

1 Unpack the product.

2Connect the shredder to mains supply.

3 Ensure the on/o switch on the back of the shredder is in the ‘ON’ position.

4 To commence shredding, move the slide switch to the Auto position ( ) which sets the

shredder into auto mode. You are now ready to shred.

5To load the shredder, simply lift the loading door catch to open the loading door and insert

documents. You can open the door further to 90 degrees for easier access if required. Load

up to 60 sheets at a time into the feed chamber. Do NOT ll above the MAX level, this could

damage the shredder.

6 The shredder will start shredding automatically ONLY after closing the loading door.

7 If there is still paper in the Autofeed tray after rst attempt, open and re-close paper loading door

a second time.

8 If you only have up to 5 sheets to shred, you can use the manual feed slot, provided the auto

feed chamber is empty.

2. reverse function

1 Should you wish to reverse paper out whilst shredding, a reverse button ( ) has been tted for

your convenience.

2 Reverse the paper out then turn the shredder o using the ON/OFF switch at the rear of the

shredder. Remove the paper from the manual feed slot (if being used) or open the loading door,

remove the remaining stack of paper, then pull the jammed paper free of the cutting mechanism.

3 To resume shredding return the slide switch to the auto position ( ) and turn on the machine by

using the ON/OFF switch at the rear of the shredder.

Swingline encourages customers to recycle shredded paper.

Please note that shredded paper cannot be recycled if mixed with credit card shards.

If recycling, please separate shredded paper and credit cards.

3. credit card shredding

The Stack and Shred 60X can shred credit cards. Switch the shredder to auto mode and insert the

credit card between the markings in the manual feed slot. Only shred one credit card at a time.

English

10 register this product online at www.accobrands.com

5. maintenance

The rollers on the auto-feed mechanism may become dirty over time, please wipe clean with a dry

cloth to maintain maximum product performance.

service

We recommend these machines are serviced every 6 to 12 months by a Swingline service

engineer – see back of this booklet for the contact details of your local service centre and for

enquiries about maintenance contracts.

over heating

If the Stack and Shred 60X is used continuously for over 8 minutes the shredder may overheat

and the cool down indicator will ash red ( ). Please allow the shredder to cool down. When

the shredder is ready to be used the thermometer symbol will no longer illuminate. If the shredder

needs to cool down while shredding, no action is needed.The shredder will automatically restart

shredding paper once it has cooled down after periods of continuous use. All you need to do is

ensure paper is loaded into the chamber and the bin is empty when the machine is cooling down.

rare occasions of jamming

In the unlikely event of the shredder jamming, the Stack and Shred 60X will stop shredding. Check

that the bin is not full then try clearing the jam using the reverse ( ) and continuous jam boost ( )

switch then return to Auto mode ( ). If this is unsuccessful follow the reverse function instructions.

4. bin full

Should the shredder stop shredding, the bin may be full. Check rst by looking through the viewing

window and if full you should empty the bin.

• Pull open the bin slowly to empty.

• Push the empty bin back into place and the machine will resume shredding.

bin or loading door open safety function

As a safety precaution, if the bin or loading door is opened during shredding, the shredder will stop.

English

lubrication of the shredder

Only use oil sheets to lubricate. ACCO Brands accepts no liability for product performance or

safety when other types of lubricants are used on any part(s) of this machine. Insert the oil sheet

into the manual feed slot and NOT in the auto-feed chamber. Using an oil sheet in the auto-feed

chamber will contaminate the feed rollers preventing the auto-feed mechanism shredding. Follow

the maintenance instructions if the rollers become contaminated. Do not directly oil the shredder.

Tabla de contenidos

Idiomas:

Otros manuales de Trituradora de papel de Swingline

Swingline

Swingline Stack-and-Shred 250X Manual de usuario

Swingline

Swingline EX10-05 Manual de usuario

Swingline

Swingline STACK-AND-SHRED 100X Manual de instrucciones

Swingline

Swingline STACK-AND-SHRED 500X Manual de usuario

Swingline

Swingline CM15-30 Manual de usuario

Swingline

Swingline Stack-and-Shred 175X Manual de usuario

Swingline

Swingline DS22-13 Manual de usuario

Swingline

Swingline SC170 Manual de usuario

Swingline

Swingline Stack-and-Shred 230X Manual de usuario

Swingline

Swingline Stack-and-Shred 250X Manual de usuario

Swingline

Swingline DS22-13 Manual de usuario

Swingline

Swingline STACK-AND-SHRED200X&200XL 60X Manual de instrucciones

Swingline

Swingline STACK AND SHRED 80X Manual de usuario

Swingline

Swingline Stack-and-Shred 80X Manual de usuario

Swingline

Swingline STACK-AND-SHRED 230XL Manual de usuario

Swingline

Swingline STACK-AND-SHRED 200X Manual de usuario

Swingline

Swingline Stack-and-Shred Manual de usuario

Swingline

Swingline EX12-05 Manual de usuario

Swingline

Swingline Stack-and-Shred 750X Manual de usuario

Swingline

Swingline Stack-and-Shred 80X Manual de usuario

Swingline

Swingline Stack-and-Shred 60X Manual de usuario

Swingline

Swingline Stack-And-Shred 600X Manual de usuario

Swingline

Swingline STACK-AND-SHRED 500X Manual de usuario

Swingline

Swingline STACK-AND-SHRED750X Manual de instrucciones

Manuales populares de Trituradora de papel de otras marcas

GBC

GBC ShredMaster CC055 Manual de usuario

UNITED OFFICE

UNITED OFFICE UAV 190 A1 Manual de usuario

UNITED OFFICE

UNITED OFFICE UAV 190 A1 Manual de usuario

Rexel

Rexel Optimum AutoFeed+ 45X Manual de usuario

Martin Yale

Martin Yale 227284S1 Manual de usuario

Bonsaii

Bonsaii DocShred C223-A Manual de usuario

HSM

HSM Pure 740 max Manual de usuario

TRU RED

TRU RED TR-BMC20A Manual de usuario

Fellowes

Fellowes 50S Manual de usuario

GBC

GBC SHREDMASTER 1236SE Manual de usuario

Gude

Gude GH 2600 P Manual de usuario

Ativa

Ativa DQ80M Manual de usuario

Q-Connect

Q-Connect Q8CC Manual de usuario

Fellowes

Fellowes POWERSHRED C-325CI Manual de usuario

Olivetti

Olivetti Privacy 5000C Guía de inicio rápido

UNITED OFFICE

UNITED OFFICE UAV 190 A1 Manual de usuario

Dahle

Dahle paperSAFE 22022 Manual de usuario

Formax

Formax OnSite FD 87 Manual de usuario

Swingline stack-and-shred60x Manual de instrucciones

Manuales populares de Trituradora de papel de otras marcas