SW-Stahl und Werkzeugvertriebs GmbH Tel. +49 (0) 2191 / 46438-0
Leverkuser Straße 65 Fax +49 (0) 2191 / 46438-40
D-42897 Remscheid E-Mail: info@swstahl.de
BEDIENUNGSANLEITUNG / INSTRUCTION MANUAL
Handling
1. Fill some droplets of resin and acid free oil into the air inlet.
2. Before connecting the hose to the tool please check, whether the hose and the quick
coupler are clean. Do this by letting air run freely through hose and quick coupler. It
is absolutely necessary, that quick coupler and hose have a sufficient diameter.
Please note, that the hose is never too big, but mostly too small! For type S3245 an
internal diameter of the hose of 12,7 mm is recommended.
3. Airpressure at the inlet of the tool during running has to be at the maximum of 6,3
bar. When this pressure is exceeded, unnecessary wear and/or damage will occur.
At the pressure of below 5,5 bar powerloss will occur.
4. The quality of the compressed air must be good, which means clean, dry and this is
best assured by means of an airline oiler. We advise the use of a complete FRL
(filter, regulator, lubricator) unit. The oiler has to be adjusted to approx. 3 to 6
droplets per minute. The airhose between oiler and tool should never exceed a
length of 6 to 8 mtrs.
5. In those cases, where it is possible, we recommend use of a centralized oiler. This
system will allow use of less oil and assure a perfect lubrication. When using a
centralized oiler, oil consumption can be reduced by up to 80%, which greatly
improves the quality of the breathing air for the operator!
6. After each period of approx. 60 working hours lubrication of the hammer mechanism
is necessary. Light greasing is recommended. Please note, that too much grease
causes loss of power. NOTE Always remember, that the indicated torques of impact
wrenches are maximum torques, measured in so-called “hard” joints after 5 seconds
hammering.
7. If you intend not to use the tool for a longer period of time, it has to be oiled very
carefully. When using the tool again, please follow points 1 and 2.
8. By means of the adjusting screw you can regulate the airinlet and influence the
power (C).
