suprema XPass D2 Manual de usuario
2021/03/01 06:25 / How to Configure D2 Keypad
- https://kb.supremainc.com/knowledge/
Table of Contents
How to Configure D2 Keypad 1 ..............................................................................................................
Adding as a Slave Device 1 ................................................................................................................
Using the device as a Wiegand Reader 2 ...........................................................................................
2021/03/01 06:25 1/3 How to Configure D2 Keypad
- https://kb.supremainc.com/knowledge/
System Configuration, BioStar 2, “D2, Keypad”
How to Configure D2 Keypad
Xpass D2 Keypad is a new device introduced with BioStar 2.6.2.
It is a dummy reader for reading cards or PIN, which means it doesn’t perform data matching on the
device.
The device can be used as slave device, or a Wiegand reader to send Wiegand output.
The device sends out a Wiegand signal with the default 26bit format and the Wiegand configuration
will be done with a separate tool.
Adding as a Slave Device
You will need a master device to add the slave D2 Keyapd device.
Refer to the article below to learn how to search a slave device.
RS485 Mode (Master, Default, Slave)
If you enable the option 'Input card ID from keypad', user can authenticate by entering the card
number on the D2 Keypad.
2021/03/01 06:25 2/3 How to Configure D2 Keypad
- https://kb.supremainc.com/knowledge/
Possible key input ranges
The range of numbers that can be received by the keypad is 8 bytes (0 to
18,446,744,073,709,551,615)
Using the device as a Wiegand Reader
If you have already used the device as a slave device before, you must reset the device to use it as a
Wiegand reader (sending Wiegand output).
1. Delete the device from BioStar 2 client as a slave device.
2. Detach the metal bracket from the device.
3. Press the reset button.
4. Use the device as a Wiegand reader by adding it as a Wiegand Device on a master device.
2021/03/01 06:25 3/3 How to Configure D2 Keypad
- https://kb.supremainc.com/knowledge/
You cannot use the device as a slave device and use Wiegand output at the same time.
From:
https://kb.supremainc.com/knowledge/ -
Permanent link:
https://kb.supremainc.com/knowledge/doku.php?id=en:how_to_configure_d2_keypad
Last update: 2019/02/26 22:36
Otros manuales para XPass D2
3
Tabla de contenidos
Otros manuales de Lector de tarjetas de suprema
suprema
suprema X-station Manual de usuario
suprema
suprema Xpass S2 Manual de usuario
suprema
suprema XPass D2 Manual de usuario
suprema
suprema XPass D2 Manual de usuario
suprema
suprema Xpass Manual de usuario
suprema
suprema RealPass-F Manual de usuario
suprema
suprema Xpass Manual de usuario
suprema
suprema bioentry PLUS Manual de usuario
suprema
suprema WEBtec-4X Guía de instalación
