Sunrex MLR5011 Manual de usuario
MLR5011 User Manual
HOW TO USE THE LASER PRESENTER
1. Insert the receiver into the USB port.
2. Your operation system will start to install the receiver
automatically .And you can see the information as below display in
your computer.
3. In Win98/Me operation system you need to follow the instructions on
your screen .During the install process , the O/S may ask you to put
Win98 CD into the CD-ROM .
4. After the install process finished ,the presenter will be working .
5. Press “Function button” to change mouse mode or PowerPoint mode.
Mouse Mode PowerPoint Mode
Left Button Mouse Left Button Page Down
Right Button Mouse Right Button Page Up
Better than other competition:
1. 16 direction and 3 level speed precise control.
2. RF (315 or 433 or 900MHZ) Any angle ,up to 7 Meters.
3. 256 ID and RF-technique to Anti-interference .
4. No matter what PC Off or Battery Out ,The ID will not be lose.
5. Add PowerPoint Mode .
Notice:
If the precenter is not working :
1. Maybe no power , please check your battery .
2. Maybe different ID ,please link ID.
(1).push the button on Receiver.
(2).press “left button” + “right button” within 10 SEC .
Function Button
CAUTION
LASER RADIATION. DO NOT STARE INTO THE BEAM OR VIEW DIRECTLY WITH OPTICAL INSTRUMENTS.
CLASS II LASER PRODUCT.
NEVER POINT A LASER BEAM INTO A PERSON’S EYES OR VIEW A LASER BEAM DIRECTLY, AS
PROLONGED EXPOSURE CAN BE HAZARDOUS TO THE EYES. MOMENTARY EXPOSURE FROM A LASER
POINTER, SUCH AS AN INADVERTENT SWEEP OF THE LIGHT ACROSS A PERSON'S EYES, MAY CAUSE
TEMPORARY FLASH BLINDNESS SIMILAR TO THE EFFECT OF A CAMERA FLASH BULB. ALTHOUGH THIS
CONDITION IS TEMPORARY, IT CAN BECOME MORE DANGEROUS IF THE EXPOSED PERSON IS ENGAGED
IN A VISION-CRITICAL ACTIVITY SUCH AS DRIVING.
Specifications
Electrical/Presenter
Interface USB
Buttons Mouse (3), Laser (1), Function (1)
Channel Number One
ID Number 256
Battery life Up to 60 days
Input power Two AAA batteries (3 Volt, DC)
Transmission Radio Frequency
Modulation frequency 433 MHz (Europe/Australia) 900 MHz (North America)
Effective distance Up to 16.5 feet (5 m)
Power consumption Mouse – 10 mA, Laser – 18 mA
Standby Mode 0.6 mA (two seconds)
Sleep Mode 1 uA
Compatibility Fully Compatible with PC/AT
Compatibility software Windows® 98/Me/2000/XP operating system
Laser wavelength at
peak emission 645-665 nm
Laser Spot size at
16.5 feet (5 m) 0.16 to 0.32 inch (4 to 8 mm)
Laser Cw output power 3.5 mW (maximum)
Weight (without battery) 2.1 ounces (60 g)
Dimensions (L x W x H) 5 inch x 1.8 inch x 1 inch (128 x 45 x 25 mm)
Receiver
Interface USB
Power DC 5V, 500mA Max
Button ID Setting
Weight 0.56 ounces (16 g)
Dimension (L x W x H) 3.07 inch x 1.02 inch x 0.63 inch (78 x 26 x 16 mm)
BRUSSELS HANNOVER BARCELONA TOKYO MILANO AMSTERDAM SINGAPORE LONDON PARIS NEW YORK LOS ANGELES TORONTO HONG KONG SYDNEY
Targus Wireless
Remote Presenter
USER’S GUIDE
Making Your Mobile Life Easier.
Making Your Mobile Life Easier.
Visit our Web site at: www.targus.com
Features and specifications are subject to change without notice. ©2003 Targus Corp.
400-0110-001A
2
CAUTION
LASER RADIATION. DO NOT STARE INTO THE BEAM OR VIEW
DIRECTLY WITH OPTICAL INSTRUMENTS. CLASS II LASER
PRODUCT.
NEVER POINT A LASER BEAM INTO A PERSON’S EYES OR VIEW A
LASER BEAM DIRECTLY, AS PROLONGED EXPOSURE CAN BE
HAZARDOUS TO THE EYES.
MOMENTARY EXPOSURE FROM A LASER POINTER, SUCH AS AN
INADVERTENT SWEEP OF THE LIGHT ACROSS A PERSON'S EYES,
MAY CAUSE TEMPORARY FLASH BLINDNESS SIMILAR TO THE
EFFECT OF A CAMERA FLASH BULB. ALTHOUGH THIS CONDITION
IS TEMPORARY, IT CAN BECOME MORE DANGEROUS IF THE
EXPOSED PERSON IS ENGAGED IN A VISION-CRITICAL ACTIVITY
SUCH AS DRIVING.
3
TARGUS WIRELESS REMOTE
PRESENTER
Introduction
Congratulations on your purchase of the Targus Wireless
Remote Presenter. The presenter is a combination remote
control mouse and laser pointer. With the presenter you can
control cursor movement anywhere within 16.5 feet (5 m) of
its receiver and project a red laser pointer beam.
NOTE: The actual effective distance may increase or decrease
depending on the surrounding environment.
The Targus Wireless Remote Presenter also features a sixteen
point, directional cursor pad and primary and secondary
buttons (left and right mouse click buttons) that emulate the
page up and down keys when in PowerPoint®mode.
In addition to this user’s guide, this package contains the
TargusWirelessRemote Presenter, it’sreceiverandan
extension cable.
4
Targus Wireless Remote Presenter
System Requirements
To use the presenter, your computer must meet the following
hardware requirements and run one of the operating systems
listed below.
Connecting the Receiver and
Installing the Default Driver
To connect the receiver to your computer, plug the standard
USB end of the receiver into an available USB port on your
computer. Alternatively, you can use the supplied USB
extensioncable to connect thereceiver toyourcomputer for
additionallength.
Your computer’s operating system identifies the receiver as a
“USB Human Interface Device” and begins installing the
default driver. Follow any on-screen procedures to complete
the default driver installation.
NOTE: If you are running the Windows®98/Me operating
system, you may be prompted to insert the installation
CD-ROM that came with your computer.
You are now ready to begin using the presenter.
Hardware Operating System
•PCwithanIntel
®Pentium®
processor or equivalent and a hard
disk drive
• 64 MB RAM or higher, depending
on the operating system
• USB interface
• Windows®98
• Windows®Millennium
Edition
• Windows®2000
• Windows®XP
5
Targus Wireless Remote Presenter
Using the Targus Wireless Remote
Presenter
Targus Wireless Remote Presenter
Changing Modes
To maximize its features, the presenter has two modes of
operation, Mouse and PowerPoint. The presenter’s default
setting is Mouse mode. To change modes, press the Function
button.
The various mode features are listed in the table below.
Button Mouse Mode PowerPoint Mode
Laser pointer Activates the laser
pointer beam
Same as Mouse
mode
Main mouse Controls cursor
movement
Same as Mouse
mode
Laser
pointer
button Main
mouse
button
Left
mouse
button
Right
mouse
button
Function
button
Laser
beam
6
Targus Wireless Remote Presenter
Safety Measures
• Never point the presenter at people, especially their faces, or
look directly into the presenter’s laser beam, to avoid
possible eye damage.
• Avoid pointing the presenter’s laser beam at a mirror or other
highly reflective surface.
• Keep the presenter away from young children.
• Never view the presenter’s laser beam using telescopic
devices, such as a microscope or binoculars.
• Any attempt to disassemble, adjust or repair the presenter
may result in exposure to laser light or other safety hazards.
• This is a Class II Laser Product.
Specifications
Electrical/Presenter
Left mouse Primary mouse
button
Emulates the Page
down key
Right mouse Secondary mouse
button
Emulates the Page
up key
Interface USB
Buttons Mouse (3), Laser (1), Function (1)
Channel Number One
ID Number 256
Battery life 30-60 days,depending on amount
of use
Button Mouse Mode PowerPoint Mode
7
Targus Wireless Remote Presenter
Receiver
Input power Two AAA batteries (3 Volt, DC)
Transmission Radio Frequency
Modulation frequency 433 MHz (Europe/Australia)
900 MHz (North America)
Effective distance Up to 16.5 feet (5 m)
Power consumption Mouse – 10 mA, Laser – 18 mA
Standby Mode 0.6 mA (two seconds)
Sleep Mode 1 uA
Compatibility Fully Compatible with PC/AT
Compatibility software Windows®98/Me/2000/XP
operating system
Laser wavelength at
peak emission 645-665 nm
Laser Spot size at
16.5 feet (5 m) 0.16 to 0.32 inch (4 to 8 mm)
Laser Cw output power 3.5 mW (maximum)
Weight (without battery) 2.1 ounces (60 g)
Dimensions (L x W x H) 5 inch x 1.8 inch x 1 inch
(128 x 45 x 25 mm)
Interface USB
Power DC 5V, 500mA Max
Button ID Setting
Weight 0.56 ounces (16 g)
Dimension (L x W x H) 3.07 inch x 1.02 inch x 0.63 inch
(78 x 26 x 16 mm)
8
Targus Wireless Remote Presenter
Troubleshooting
The presenter is not working or is interfering with another
remote device – what should I do?
The presenter has 256 identification codes that allow it to
operate without interference from other radio frequency
devices. The presenter and its receiver must be set to the same
identification code to function properly. To set the
identification code:
1 Using a bent paper clip or similar object, press and release
the red ID button on the top of the receiver.
Receiver
2 Within ten seconds, press and hold the presenter’s left and
right mouse buttons at the same time for two seconds, then
release both keys.
3 Press any mouse key to capture the presenter’s new
identification code.
ID button
USB
connector
Tabla de contenidos
Otros manuales de Presentador digital de Sunrex
Manuales populares de Presentador digital de otras marcas
Samsung
Samsung SDP-850 Manual de usuario
Dukane
Dukane DV-P303A Manual de usuario
RemotePoint
RemotePoint Presenter Global Manual de usuario
Kensington
Kensington Wireless Presenter with Laser Pointer Instrucciones de funcionamiento
NEC
NEC DS1-MP10RX2 Manual de funcionamiento
Logitech
Logitech R800 - Professional Presenter Presentation Remote... Manual de usuario