Sungrow SH6.0RT Guía de instalación

© 2021 Sungrow. All rights reserved. Subject to change without notice. Version 1.1

Sungrow Deutschland GmbH | Balanstr. 59 | 81541 München | www.sungrowpower.com

3-phase Hybrids-FAQ

Replacement or expansion of residential energy

storage battery module

Applicable to: SBR HV Batteries

Scenario:

1. If the customer needs to add more battery modules (for example, add two

battery modules to an existing SBR096).

2. If one battery module is faulty and new battery module needs to be

replaced.

3. If two battery modules need to be removed.

Solution:

For scenarios 1 and 2, the battery modules in use need to be charged or discharged

to SOC of the new battery. New battery’s SOC can be estimated with knowing

manufacturing date and storage time. (see below table)

© 2021 Sungrow. All rights reserved. Subject to change without notice. Version 1.1

Sungrow Deutschland GmbH | Balanstr. 59 | 81541 München | www.sungrowpower.com

Assume for example that the SOC of the new battery module is 20%, and the

battery on user site is 70%, please proceed as follows:

Select Compulsory Mode in the Energy Management Parameters and set Charge

as a charging command.

Apply the settings.

Set the SOC Upper Limit to 100% and the SOC Lower Limit to 20 % (calculated

value for the new battery). Apply the settings. By charging the battery to 100%, a

calibration is performed to improve the accuracy of SOC.

(This takes some time, can be omitted and the target SOC value can be directly set

and charged or discharged to the target SOC.)

© 2021 Sungrow. All rights reserved. Subject to change without notice. Version 1.1

Sungrow Deutschland GmbH | Balanstr. 59 | 81541 München | www.sungrowpower.com

After charging to 100%, select discharge and Apply the settings. The battery will

automatically discharge to 20% and stop.

Now the battery SOC on user site is the same as SOC of the new battery module

20%, so the installer can install the new battery module.

After replacement, stop Compulsory mode and reset Upper and Lower SOC Limit

to its original values. (default: SOC upper limit 100%, SOC lower limit 10%

For scenario 3, we can remove two modules directly, because the power of the five

modules is the same. If we remove two battery modules, the remaining three

battery modules will also work normally.

For further information, please download the user manual here.

© 2021 Sungrow. All rights reserved. Subject to change without notice. Version 1.1

Sungrow Deutschland GmbH | Balanstr. 59 | 81541 München | www.sungrowpower.com

This manual is intended for professional technicians who are responsible for

installation, operation, maintenance and troubleshooting of inverters, and users

who need to check inverter parameters. The inverter must only be installed by

professional technicians.

The professional technician is required to meet the following requirements:

•Know electronic, electrical wiring and mechanical expertise, and be familiar

with electrical and mechanical schematics.

•Have received professional training related to the installation,

commissioning and troubleshooting of electrical equipment.

•Be able to quickly respond to hazards or emergencies that occur during

installation, commissioning and troubleshooting.

•Be familiar with local standards and relevant safety regulations of electrical

systems.

•Read this manual thoroughly and understand the safety instructions related

to operations.

Este manual sirve para los siguientes modelos

2

Tabla de contenidos

Otros manuales de Inversor de Sungrow

Sungrow

Sungrow SG125HX Manual de usuario

Sungrow

Sungrow SG5KTL-MT Manual de usuario

Sungrow

Sungrow SG100K3 Manual de usuario

Sungrow

Sungrow PowerStack-ST535kWh-250kW-2h Guía del usuario

Sungrow

Sungrow SG250HX-IN-20 Manual de usuario

Sungrow

Sungrow SG1100UD Series Manual de instrucciones

Sungrow

Sungrow SG125CX-P2 Manual de usuario

Sungrow

Sungrow SG320HX Manual de usuario

Sungrow

Sungrow SH3K6-30 Manual de usuario

Sungrow

Sungrow SG5.0RT Manual de usuario

Sungrow

Sungrow SH5K Manual del propietario

Sungrow

Sungrow SH3.0RS Manual de usuario

Sungrow

Sungrow SG125HV Manual de usuario

Sungrow

Sungrow SG3KTL-M Manual de usuario

Sungrow

Sungrow SG75CX-P2 Manual de usuario

Sungrow

Sungrow SH5K+ Manual de usuario

Sungrow

Sungrow SG5.0RT-P2 Manual de usuario

Sungrow

Sungrow SH RS Series Guía de instalación

Sungrow

Sungrow SG1K5TL Manual de usuario

Sungrow

Sungrow SG5KTL-MT Manual de usuario

Sungrow

Sungrow SH5K-20 Manual de usuario

Sungrow

Sungrow SG5KTL-MT Manual de usuario

Sungrow

Sungrow SG80KTL Manual de usuario

Sungrow

Sungrow SG50KTL-M-20 Manual de usuario

Manuales populares de Inversor de otras marcas

Fourgroup

Fourgroup Easy Manual de usuario

Velleman

Velleman PI300M Manual de usuario

WilTec

WilTec 61897 Manual de usuario

SMA

SMA SUNNY BOY STORAGE 2.5 Manual de usuario

Simplicity

Simplicity LANDLORD 316 Manual de usuario

Santak

Santak SMAX 3000 Manual de usuario

ATON

ATON RA.Store-3 Manual de usuario

ZIEHL-ABEGG

ZIEHL-ABEGG FXET4AMQ Manual de usuario

Tektronix

Tektronix CFG250 Manual de usuario

Champion

Champion 200989 Manual de usuario

Vanner

Vanner 20-500 Series Manual de usuario

GE

GE GEP Manual de usuario

Astrel Group

Astrel Group Power Reducer Guía rápida

MULTIQUIP

MULTIQUIP GDP-5H Guía

GoWISE

GoWISE PS1007 Manual de usuario

Promate

Promate PM13500D ES Manual de usuario

Mastervolt

Mastervolt WHISPER 3.5M3000 RPM Manual de usuario

Mitsubishi Electric

Mitsubishi Electric FR-A7AZ Manual de usuario