3
TABLE OF CONTENTS
1 Introduction .....................................................................................................................6
1.1 Preface.....................................................................................................................6
1.2 Meaning of the related symbols................................................................................7
1.3 Unboxing and identification of parts..........................................................................8
1.4 Storage ....................................................................................................................8
1.5 Liability and guarantee.............................................................................................9
1.6 Warranty ..................................................................................................................9
2 SAFETY........................................................................................................................10
2.1 General..................................................................................................................10
2.2 Obligations of the operator.....................................................................................11
2.3 Recommended Use................................................................................................12
2.3.1 Typical Application Materials...........................................................................12
2.4 Work piece Clamping.............................................................................................13
2.5 Machine isolation when you interact with the machine ...........................................13
2.6 Cutting tool specification and Loading....................................................................14
2.7 Sources of Dangers................................................................................................14
2.7.1 Cutters............................................................................................................14
2.7.2 Keep away from Spindle systems when in operation.......................................14
2.7.1 Freshly Cut Materials ......................................................................................15
2.7.2 Spindle Wind down .........................................................................................15
2.7.3 Management of Particulates and Swarf around the control PC........................15
2.7.4 Manage the USB cables connected to the machine........................................15
2.7.5 Eye Ear and Dust protection............................................................................16
2.7.6 SAFETY circuits..............................................................................................17
3 Setup.............................................................................................................................17
3.1.1 System setup ..................................................................................................17
3.1.2 Resetting the software before touching the spindle.........................................19
3.1.3 SAFETY circuits..............................................................................................21
