Stoltzen 4K HDMI Controller
6
Current Setting
HDMI Input - Active: The HDMI Input is active, it accept HDMI signal input.
HDMI Input - Inactive: The HDMI Input is inactive, it does not accept HDMI signal input.
HDMI Output - On: The HDMI Output is on.
HDMI Output - Off: The HDMI Output is off.
Auto Trigger - Enable: It auto trigger to send power on / power off commands as set.
Auto Trigger - Disable: It does not auto trigger to send power on / power off commands
as set, only sends out the commands manually.
Default Setting
HDMI Input - Active: When re-power on the HDMI Controller, the HDMI Input is active,
accept HDMI signal input.
HDMI Input - Inactive: When re-power on the HDMI Controller, the HDMI Input is
inactive, it does not accept HDMI signal input.
HDMI Output - On: When re-power on the HDMI Controller, the HDMI Output is on.
HDMI Output - Off: When re-power on the HDMI Controller, the HDMI Output is off.
Auto Trigger - Enable: When re-power on the HDMI Controller, it is set as to auto trigger
to send power on / power off commands as set.
Auto Trigger - Disable: When re-power on the HDMI Controller, it is set as to does not
auto trigger to send power on / power off commands as set, only sends out the
commands manually.
6.1.4 ReFresh
The ReFresh button is for checking the setting status of the HDMI Controller.
6.2 Program and Set the HDMI Controller via RS232
It also can program and set the HDMI Controller by RS232.
Baud rate: 115200 Data bits: 8 Parity: none Stop bits: 1
# Command Function Response
1 SBR:x[cr][lf]
Set baud rate of the projector
x=115200, 57600, 56000, 43000, 38400,
28800, 19200, 9600, 4800, 2400, 1200
SBR:x[cr][lf]
2 CBR[cr][lf] Check the baud rate of the projector (set in
HDMI Controller) CBR:x[cr][lf]
