STO N SHO SNS 289 Guía de referencia

Installation Procedures

2021 Ford Bronco

With Metal Bumper

SNS 289

Warning: Please read directions completely before starting. If you have any

questions, please contact STO N SHO, LLC before beginning your installation. Also,

please check our website (www.stonsho.com)for any updates or changes. Thank

You.

Parts Included: License Plate mounting bracket Assembly. Includes Base Plate and

License Plate Holder.

License Plate mounting Screws: (4) 6mm X 12mm (Phillips head) and

6mm nuts (10mm wrench size)

Base plate mounting screws: (1) Factory screw.

Tools Needed: T40 Torx socket with ratchet, and 10mm wrench.

Step 1: Ensure all parts listed above are accounted for. Note: If at any time during the

installation process you need assistance please call (408) 776-4080.

Step 2: Separate the license plate holder from the base by simply pulling the pull pin ring

outward and sliding apart.

Step 3: Remove the center 8mm bolt using the T40 Torx as shown in figure 1. Position the base

mount over the hole where the factory screw was just removed. See figure 2.

Step 4: Using the factory bolt removed, secure the base plate to the vehicle ensuring the base

plate remains level while tightening.

Step 5: Secure the license plate and frame (optional) to the license plate bracket using the

screws and nuts provided. Requires the Phillips screwdriver and 10mm wrench (Not included).

Step 6: Slide the license plate rods into the two tubes located on the base plate. Slide the rods

into the tubes until the rods hit the pull pin. Simply pull the ring on the pull pin and advance the

rods. Release ring and continue to advance rods until the pull pin locks into place. Note: The

rods and spring-loaded pull pin are required to be sprayed periodically with WD-40 or any

other silicone type spray lube. Failure to do so could result in either the failure of the pull pin

or the rods becoming difficult to remove or reinsert. Note: In harsh environments, such as

areas where roads are either salted or sanded in the winter, spraying of the rods and pull pin

should be performed on a regular basis. Failure to provide this maintenance may void your

warranty. See figure 3. In some occasions the license plate may require a little adjustment to

level. Simply pull pin and slide plate out approximately two inches, grab frame at arrows (See

figure 4) and rotate. If plate is high on left or right side, rotate high side down slightly and

release. Verify alignment and repeat as necessary. Once leveled plate will remain level.

Congratulations! You have just installed the STO N SHOTM (Patented) front license plate

mounting system. Thank You for your purchase.

Caution: Bracket lowers ground clearance by approx 1/2 inch.

Remove prior to entering automated car wash

Exercise care when entering or exiting steep driveways or damage will occur

Parking Stops or high curbs stop well before or damage will occur

Remove prior to running on track or racing

Moderate skill level required. If unsure, have bracket installed by your local Dealer or Body

shop.

Limited Lifetime Warranty (Excluding Pull-pin). Pull pin will be warrantied for a period of 1 year

(12 months) from the date of purchase.

STO N SHO, LLC warrants to the original purchaser only that this product will be free of

manufacturing defects in material and workmanship for the life of the product (Excluding pull-

pin, see above) provided all maintenance is performed as required to the limitations and

exclusions set forth below:

Return product to any authorized dealer. Contact STO N SHO, LLC for the dealer nearest you.

Upon examination, STO N SHO, LLC or its representative will, at its sole option and expense,

repair or replace any product found to be defective. If product to be replaced via mail, STO N

SHO, LLC will return the repaired or replaced unit to you via its usual shipping method from the

factory to your address in the United States of America or Canada only. Any shipping costs for

addresses outside of the United States or Canada shall be the responsibility of the purchaser.

This warranty is not transferable.

REMEDIES FOR BREACH OF WARRANTY.

This Warranty does not include repair for damage caused by improper use or handling,

including but not limited to damage caused by accident, mishandling, improper installation,

abuse, negligence, or any defect caused by repair to the product by anyone other than STO N

SHO, LLC.

This warranty does not cover reimbursement for your costs of removing and transporting the

product for warranty service evaluation, or installation of any replacement product provided

under this warranty.

This Warranty will be void if the product was not purchased from an authorized dealer or

reseller.

THE FOREGOING WARRANTIES ARE EXCLUSIVE AND IN LIEU OF ALL OTHER EXPRESSED AND

IMPLIED WARRANTIES. ALL SUCH OTHER WARRANTIES, INCLUDING BUT NOT LIMITED TO

IMPLIED WARRANTIES OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE AND NON-

INFRINGEMENT, WITH RESPECT TO THE PRODUCT. TO THE MAXIMUM EXTENT PERMITTED BY

LAW, STO N SHO, LLC SHALL NOT BE RESPONSIBLE FOR ANY INCIDENTAL OR CONSEQUENTIAL

DAMAGES EXCEPT TO THE EXTENT PROVIDED (OR PROHIBITED) BY APPLICABLE LAW, EVEN IF

STO N SHO, LLC HAS BEEN ADVISED OF THE POSSIBILITY OF SUCH DAMAGES.

Notwithstanding the above, if you qualify as a “consumer” under the Magnuson-Moss

Warranty Act, or applicable state laws, then you may be entitled to any implied warranties

allowed by law for the Warranty Period. Further, some states do not allow limitations on how

long an implied warranty lasts or allow the exclusion or limitation of consequential damages, so

such limitations may not apply to you. This warranty gives you specific legal rights, and you may

also have other rights which vary from state to state.

For the name of your nearest authorized STO N SHO dealer, contact: STO N SHO at (408)776-

4080 or go to www.stonsho.com

Fig 1

Fig 2

T50 Torx

Fig 3

Fig 4

Tabla de contenidos

Otros manuales de Accesorios para automóviles de STO N SHO

STO N SHO

STO N SHO SNS 34 Guía de referencia

STO N SHO

STO N SHO SNS 236 Guía de referencia

STO N SHO

STO N SHO SNS 27 Guía de referencia

STO N SHO

STO N SHO SNS 353a Guía de referencia

STO N SHO

STO N SHO SNS 175 Guía de referencia

STO N SHO

STO N SHO SNS 154 Guía de referencia

STO N SHO

STO N SHO SNS 214 Guía de referencia

STO N SHO

STO N SHO SNS 276 Guía de referencia

STO N SHO

STO N SHO SNS 166 Guía de referencia

STO N SHO

STO N SHO Big Mike's Performance Parts SNS 73 Guía de referencia

STO N SHO

STO N SHO SNS 367 Guía de referencia

STO N SHO

STO N SHO SNS 19 Guía de referencia

STO N SHO

STO N SHO SNS 146 Guía de referencia

STO N SHO

STO N SHO SNS 289b Guía de referencia

STO N SHO

STO N SHO SNS 14 Guía de referencia

STO N SHO

STO N SHO SNS 234 Guía de referencia

STO N SHO

STO N SHO SNS 144 Guía de referencia

STO N SHO

STO N SHO SNS 172 Guía de referencia

STO N SHO

STO N SHO SNS 110 Guía de referencia

STO N SHO

STO N SHO SNS 203 Guía de referencia

STO N SHO

STO N SHO SNS 326 Guía de referencia

STO N SHO

STO N SHO SNS 235 Guía de referencia

STO N SHO

STO N SHO SNS 246 Guía de referencia

STO N SHO

STO N SHO SNS 275 Guía de referencia

Manuales populares de Accesorios para automóviles de otras marcas

James Baroud

James Baroud Odyssey Manual de usuario

Motorola

Motorola i50sx Manual de usuario

Yakima

Yakima 9MM STANDARD BIKE MOUNT Manual de usuario

Feniex

Feniex T3 Manual de usuario

Renault

Renault 77 11 423 180 Manual de usuario

Kia

Kia E8300-4D000 Manual de usuario

Brink

Brink 756843 Manual de usuario

Whispbar

Whispbar K085W Manual de usuario

v.link

v.link CI-VL2-PC-HSD Manual de usuario

Viking

Viking Stack-Rack Guía de configuración rápida

Aries

Aries 203015 Manual de usuario

Choetech

Choetech AT0005 Manual de usuario

ZZ2

ZZ2 ZZAIR-PRO Manual de usuario

Holman

Holman 4A80L Manual de usuario

Thule

Thule 2075 Manual de usuario

Motorola

Motorola T325 Manual de usuario

TAUBENREUTHER

TAUBENREUTHER 16-3950 Guía de instalación

DV8

DV8 FBJL-02 Manual de usuario