IMPORTANT SAFETY INFORMATION
PRODUCT STRUCTURE
Filling with water
No filters required, works best with cold water.
DO NOT fill with hot or warm water.
• For best performance use cold distilled water
1. Place the Diuser on a flat level surface and ensure it is stable.
2. Insert the DC jack of the adaptor into the Diuser DC socket.
3. Remove the cover and using the measuring cup, fill the water
tank to the max mark on the inner tank, 200ml
4. Add 2-4 drops of Essential Oil into the water.
5. Close with the inner cover and then the top cover.
6. Plug the adaptor into the wall socket and switch on.
OPERATING THE DIFFUSER
This Essential Oil Diuser is for indoor domestic use only. When
using with essential oils, the diuser creates a relaxing mind and
body aromatherapy experience.
The diuser can be used without essential oils to humidify/add
moisture to the air. Dry air can cause your skin to crack.
Add
water
Add
essential oil
Air inlet vent
DC socket
Water
drainage
holes
Top cover
Measuring
cup
Inner cover
Drain side
Water tank
Base
Power
adaptor
DC
Jack
Aroma
button
Indicator
lights
Light button
MAX
MAX
Thank you for your purchase of this AlvaAir Essential Oil Diuser.
You can rest assured that this product has been designed
to meet international safety standards and that you have
purchased a quality product.
Page 2 Page 3 Page 4
•Please read these instructions carefully before using
your Essential Oil Diuser. The operator must understand all
safety requirements as detailed in this manual before using
the unit.
•The manufacturer’s warranty may be void by incorrect use
of this product. If you have any queries regarding these
instructions, contact your local dealer for clarification before
using your Essential Oil Diuser.
•This product is for general domestic, indoor use only. Using
for any other purpose will void the warranty.
•Keep the Diuser out of the reach of children and pets.
This product is not intended for use by children.
•This appliance is not intended for use by persons (including
children) with reduced physical, sensory or mental capabilities
or lack of experience and knowledge, unless they have been
given supervision or instruction concerning use of the
appliance by a person responsible for their safety.
•Always operate the Diuser on a flat, level, stable,
waterproof surface.
•DO NOT move the Diuser when switched on.
•Only fill with cold water, DO NOT use or hot or warm water.
•DO NOT add essential oil when the Diuser is working.
•Only use plant essential oil, DO NOT use non-volatile mineral
oil and viscous oil.
•If use of essential oils causes discomfort or reaction, stop using
immediately and consult your doctor.
•Keep the power cord and product away from sharp edges,
heated surfaces and areas where it can be stepped on.
•Do not operate the Diuser if the power cord is cut, damaged,
or if the wires are exposed. Contact 086 100 ALVA (2582) or
an Authorised Service Agent to replace the power cord/
adaptor unit.
•Only use the power adaptor supplied with the product. Using
any Power Adaptor other than the one supplied in the box will
void the warranty and may damage the Diuser.
•Always unplug the Diuser from the electrical outlet when
cleaning/filling it.
•Do not plug/unplug the Diuser from the electrical outlet with
wet hands.
•Do not operate the Diuser if it has a damaged power cord or
Power Adaptor, malfunctions, is dropped, or damaged.
This product has no user–serviceable parts.
•Do not attempt to examine or repair this Diuser yourself.
Qualified service personnel should perform any servicing.
Mist and light functions can be used together or independently
of each other.
Mist Operation
3 modes to diuse mist – continuously, 2 hours or 4 hours
1. Press Aroma button once; the mist will run continuously.
2. Press Aroma button a second time; the Diuser will
automatically switch o after 2 hours.
3. Press Aroma button a third time;
the Diuser will automatically
switch o after 4 hours.
4. Press Aroma button a fourth
time; the mist will stop. Aroma Button
How to unplug your Diffuser correctly
To remove from the socket pull on the
plastic power adaptor, not the electrical cord
