© stilum GmbH, 56271 Kleinmaischeid • Tel. +49 (0) 2689 92790-0 • All rights and product modications reserved State: 16.02.2018 p. 5
Mounting instruction large play equipment „silva 1“
Item-no. 51 5520 601
In order to preserve a good visual appearance of your stilum playground equipment
over a long period one should take care of maintenance of the stainless
surface even despite of their corrosion resistance. Especially areas, which can not
be reached by rainfall, should be frequently cleaned from dirt and deposits due to air
pollution and dirt caused by the atmosphere. Light soiling can easily be removed by
using a high pressure cleaner. For persistent deposits use a clean cloth moistened
with a special liquid cleaner (e.g. on phosphoric acid) and rinse off with clear water
after a short application time. During cleaning with mild abrasive components, only
wipe over stainless steel surface in polishing direction. For heavily soiled surfaces,
polishes can be used (e.g. for cleaning chrome on cars) or for greasy and oily dirt
alcoholic cleaning agents and solvents (e.g. ethyl alcohol, isopropyl alcohol or ace-
tone). However, it should be noted that the dissolved soiling is not spread over the
surface again. Do not use any chloride or hydrochloric containing cleaning products
nor scouring powder, bleaching - or silver polish cleaner. Cleaning intervals depend
on type and degree of soiling as well as on demands made on optical characteris-
tics. Therefore cleaning is advisable at intervals of six to twelve months – whereby in
the case of strong soiling it is appropriate to clean the playground equipment at inter-
vals of 3 to 6 months.
MAINTENANCE OF WOODEN ELEMENTS
To ensure a long life of stilum playground equipment, wooden surfaces should be
regularly re-glazed. This provides the wooden surfaces with the necessary protec-
tion and preserves the look. Areas which are not exposed to rain should be regular-
ly freed from deposits.
The cleaning intervals depend on the degree and type of soiling as well as on the
exigencies on cleanliness. It is recommended to clean and / or glaze at every 6
to 12 months, or to shorten the cleaning interval to 3 to 6 months if the wheather
conditions are bad.
LASUR APPLICATION
Use a soft and at brush or / and a glaze application roll to paint.
The wood should be cleaned a few hours before glazing. That can be done with
mild javel water, which should in any case be rubbed off afterwards. For resistant
dirt use a wood cleaner. Eventually a light abrasion is necessary. If water-based de-
tergents are used for cleaning, please ensure that the wood elements are thorough-
ly dried before the glazing is done.
Always brush in one direction, so that the glaze can spread evenly. Apply very
thinly!
Remove glaze with a soft cotton cloth.
Then let the freshly glazed wood dry for at least one day and prohibit the use of the
equipment for this duration.
