EZ
MOUNT
BRACKET SYSTEM
NOTE: Professional
mounting
techniques
should
be
used.
Stewart
Filmscreen
cannot
be
liable
for
substandard
or
faulty
installations. Failure
to
comply
with
the
instructions
and
guidance
contained
in
this
manual may result in
voiding
your
warranty.
CAUTION
Be
careful not
to
touch or scratch the viewing surface.
To
accurately position the frame,mountthe
EZ
Mount
hanging bar and temporarily hang theframe
before attachingthe screen material. On the
bottom
of
theframe, there are magnets you can slide
to
line upthe steel pucks
to
align with wall studs. Ifthe wall
is
not perfectlyflat, the force
of
the
magnet may cause the frame
to
bend.
For
this reason, shims can be used
to
place between the wall
and the steel pucks so that theframe remains straight. The screen should not be attached
to
the
frame atthis point (see Figures 3-5).
1.
Identifythe location
of
wall studs where you
can securely mountthe
EZ
Mount hanging
bar.
2.
Use a level
to
accurately position the
EZ
Mount
hanging bar on the wall (see Figure
2).
3.
Drill holes through the bar intothe studs.
4.
Use the provided
2"
screws
or
other
appropriatefasteners
to
secure the
EZ
Mount
hanging bar
to
the wall studs.
Note:A
minimum
ofthree
(3)
screws
are
recommended to
safely
secure
the
frame.
More
screws
are
needed for heavier
screens.
5. Recheck
to
make sure the bar
is
level.
Figure
2:
EZ
Mount
is
Level and on Wall Studs
6.
Hangthe assembled frame, withoutthe screen attached, on the
EZ
Mount
hanging bar
to
ensure
that it
is
correctly mounted.
7.
Markthe wall where you will mountthe steel pucks
to
studs that will align with the magnets
fastened on theframe.
Note:
Find
studs
that allow the
pucks
and
magnets
to
be
positioned approximately
12"
to
24"
from the edge ofthe
frame
on
each
side.
8.
Remove theframe. Drill intothe studs and mountthe steel pucks with the provided 2-3/8"
screws or other appropriatefasteners. Use shims
as
needed.
Stewart Filmscreen -WallScreen Deluxe
