Cima NT AC 5
PREPARING THE INSTALLATION
The Cima Above Ceiling Non-Tensioned product can be controlled through a number of remote control
devices, including keypads, dry contact outputs, and low-voltage trigger outputs. With the optional Cima-
Link Controller Packages, your Cima screen can be controlled by local and remote Infrared, IP ethernet,
and computer-based signaling sources such as those manufactured by Control4, AMX, Crestron, Elan
Home Systems with RS-232-C or RS-485 interfaces.
iCAUTION
To be installed and/or used in accordance with appropriate electrical codes and regulations.
You will need:
`Enough ladders for the personnel supporting the screen during the mounting process
`A level
`Fasteners appropriate for the surface on which the screen is being mounted
Note: This manual refers to “AC” to represent electrical power. Your location may use 120 V, 220 V, or
other electrical power. Screen systems are manufactured using the electrical power type specified for
the location. Use appropriate power sources for your location.
UNPACKING
1. Remove the outer plastic covering and white wrapping paper surrounding the screen case.
2. Do not remove the wrapping paper surrounding the screen roller. You should remove it only after
the unit is hung and all electrical connections have been made.
3. Remove the batten lock-down screws located on the back side of the case.
WARNING!
Failure to remove the batten lock-down screws can result in permanent damage to the screen.
MOTOR WIRING
The Cima Non-Tensioned Above Ceiling’s screen motor is pre-wired at the factory. No additional motor
assembly is required.
iCAUTION
During installation, do not place the unit on an unstable cart, stand, table, or ladder. The unit may fall,
causing injury and damage to the unit.
