StetSom Bravo BASS Flex 3K Manual de usuario
USER MANUAL
MANUAL DO USUÁRIO • MANUAL DE USUARIO • MANUALE UTENTE
3K
2
Introduction
Thank you so much for choosing a Stetsom
impedance system, which adjusts the parameters when using various
speakers on the market.
Before installing
Read this manual carefully before using the product.
OFF.
wiring to avoid interference and noise in your audio system.
If you have quesons, contact the store where the purchase or
installaon was done. For more informaon, please contact our
Customer Service: BR +55 18 2104-9412.
EN-US
3
1. INPUT (IN):
2. OUTPUT (OUT):
systems.
3. LEVEL:
4. CROSSOVER:
▪FILTRO SUBSONIC: 5Hz
to 40Hz
▪FILTRO LOW PASS (L.P.F.):
of 30Hz to 200Hz
5. BASS BOOST:
▪BASS: 0dB to +10dB.
▪FREQ:
accentuated with BASS of 30Hz to 70Hz.
6. SPEAKERS:
Input, output and audio controls
32 6
venlaon
1
venlaon
4 5
4
Power input
7. COOLER:
8. POSITIVE POWER SUPPLY CONNECTOR:
terminal using a minimum 4 AWG
(200A)
9. REMOTE CONNECTOR (REM):
18 AWG.
10. NEGATIVE POWER SUPPLY CONNECTOR:
4 AWG.
987 10 7
5
LED indicators
POWER (blue LED):
when it is lit up.
PROT (top red LED):
mode, forcing it to shut down. Use the protecon
table below
CLIP (lower red LED):
Smart protection system
and the PROT LED
Blink
1x
Blink
3x
Blink
4x
Blink
2x
Problem: Short circuit or output overload.
Problem: Supply voltage less than 9V.
Solution: Check that the speaker cables are well insulated and that the
impedance at the output does not exceed that supported by the amplier.
Solution: Check baery voltage or power supply.
Solution: Check if the amplier is in a venlated place or if the fans are not
obstructed. Keep the amp on for a few minutes, so the fans can help with the
cooling process.
Solution: Check baery voltage or power supply.
Problem: Excessive temperature. When the amplier reaches approximately
194ºF, the audio is interrupted, and the fans run at full speed to accelerate the
process of cooling the internal components.
Problem: Supply voltage higher than 17V.
6
Installaon should only be done by qualied professionals with the
product turned OFF.
REM
Radio / Player
18 AWG cable
Baery
RECOMMENDED USE
OF AUXILIARY BATTERY.
(maximum
12” of baery)
STETSOM
REM (remote)
POSITIVE
NEGATIVE
4 AWG cable
4 AWG cable
Fuse
200A
Installation
...........................................
Remote connector ........................................................................
..............................
....................................................................
Theuseofafuseorcircuitbreakerismandatorytoprotectthesystemfromshort
circuitsandoverload.Installthemasclosetothebaeryaspossible.
4 AWG
18 AWG
0.5 Ohm: 7 AWG
Other impedance: 9 AWG
200A
7
Output for connecon
of mul-amps
SPEAKERS
IN
OUT
Rádio / Player
STETSOM
7 AWG cables
(using 0.5 Ohm)
9 AWG cables
(other impedances)
Check the minimum impedance
supported by the amplier
Resultant
Impedance
Quantity of speakers Speaker
impedance
Speakers Association
1 OHM 0.5 OHM
2 OHMS
4 OHMS
4 OHMS
4 OHMS
6 OHMs
1.33 OHMs
1.5 OHMs
1 OHM
3 x speakers
2 x speakers
2 x speakers
4 x speakers
4 x speakers
8
Troubleshooting
DOES NOT TURN ON:
have electrical and mechanical contact.
NO SOUND:
LEVEL control is not at a minimum.
PROTLEDFLASHING:
SOUNDDISTORTIONS:
a)
b)
9
Nominal power based on equipment of Stetsom Laboratory.
Analyzer AMPLIFIER DYNO AD-1 SMD: test reference of frequency 40Hz with THD+N to ≤1%. The
electronic components and the manufacturing process can vary slightly and may cause a slight
variaon, even with the same measurements.
Imagescontainedinthismanualaremerelyillustraveandmaydierfromtheactualproduct.
Any updates made in this manual will be available for customers to consult free of
charge on the Stetsom website. It is recommended that the updated manual be
consulted whenever needed.
WEAK OF BASS:
NOISEANDFAILUREINSOUND:
as it may cause interference and noise in the audio signal.
10
Technical specications
1
0,2V ~ 3V
>90dB
5Hz ~ 200Hz
30Hz ~ 200Hz
5Hz ~ 40Hz
Freq: 30Hz ~ 70Hz
Boost: 0dB ~ +10dB
7K Ohms
9V ~ 17V DC
160A
320A
3,1” x 9.2” x 9.1”
6.6 lb
3000W RMS @ 0.5 Ohm
3500W RMS @ 1 Ohm
3000W RMS @ 2 Ohms
0.5 OHM ~ 2 OHMS (AUTO)
Level (db)
Frequency (Hz)
fc= 200Hz
FREQUENCY
RESPONSE
Tabla de contenidos
Idiomas:
Otros manuales de Amplificador de StetSom
StetSom
StetSom BRAVO FULL 5000 Manual de usuario
StetSom
StetSom HIGH LINE HL2000.4 Manual de usuario
StetSom
StetSom HIGH LINE 1200.4 Manual de usuario
StetSom
StetSom V 1000.5 - STEREO Manual de usuario
StetSom
StetSom EXPORT LINE Manual de usuario
StetSom
StetSom V 1300.4 Manual de usuario
StetSom
StetSom EXPORT LINE EX5000EQ Manual de usuario
StetSom
StetSom EXPORT LINE EX1600EQ Manual de usuario
StetSom
StetSom VENOM LINE V 800.4 Manual de usuario
StetSom
StetSom BRAVO 1200 Manual de usuario
StetSom
StetSom DB500.1 Manual de usuario
StetSom
StetSom PA2500.2 Manual de usuario
StetSom
StetSom 3K7 ES Manual de usuario
StetSom
StetSom R400.4 Manual de usuario
StetSom
StetSom EXPORT Series Manual de usuario
StetSom
StetSom EXPORT LINE EX1600EQ Manual de usuario
StetSom
StetSom DIGITAL LINE 2K5 ES-2 OHMS Manual de usuario
StetSom
StetSom Export Line EX8000EQ Manual de usuario
StetSom
StetSom Venom V 1000.5 Manual de usuario
StetSom
StetSom HIGH LINE HL800.4 Manual de usuario
