Page 3of 15
II. Equipment required for installation
You will need:
•Screws suitable for your installation and stair lighting configuration
•Adhesive tape or glue to attach motion sensors
•2 x 0.3 mm2 or 2 x 0.75 mm2 wire as required to extend the tails on the stair strips
•Two core flex of sufficient length to reach your mains supply
•Electrical connector blocks
•Suitable tools for all installation steps for your stair lighting configuration
III. Safety notices
Please read the entire manual before proceeding with the installation!
All work should be undertaken while the power supply is disconnected from electricity!
Incorrect connection of the motion sensors, lights and the power supply can damage the controller!
DIY tips and safety advice
•Personal protective equipment. Make sure that you are equipped with suitable and
sufficient personal protective equipment. This could include eye protection, face mask,
protective overalls, safety footwear and gloves.
•Consider your safety! Think about the potential risks and dangers of the work and the
steps you should take to avoid them.
•Ensure that the work area is sufficiently illuminated.
•Check that the tools you will be working with are in a good operating condition.
Electrical work safety advice and tips
•Ensure that a 220-240 V AC power source is available.
•An appropriate protective device e.g. fuse or miniature circuit breaker should be
installed at the consumer unit. We recommend a 6 A type B MCB for this purpose. If
the supply circuit to the stair lights is not dedicated, your electrician can advise on
protection arrangements.
•Before undertaking any electrical connection work, ensure the circuit is isolated at the
consumer unit by turning off the MCB and, if practicable, locking it in the OFF position.
Working live can cause injury and can damage components of your Intelligent Stair
Lighting.
