StarTech.com SVID2USB2NS Manual de usuario

Manual Revision: 05/08/2012

For the most up-to-date information, please visit: www.startech.com

DE: Bedienungsanleitung - de.startech.com

FR: Guide de l'utilisateur - fr.startech.com

ES: Guía del usuario - es.startech.com

IT: Guida per l'uso - it.startech.com

NL: Gebruiksaanwijzing - nl.startech.com

PT: Guia do usuário - pt.startech.com

*actual product may vary from photos

SVID2USB2NS

Video Capture Cable with

Composite and S-Video Input

Instruction Manual

FCC Compliance Statement

This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential installation. This equipment generates,

uses and can radiate radio frequency energy and, if not installed and used in accordance with

the instructions, may cause harmful interference to radio communications. However, there

is no guarantee that interference will not occur in a particular installation. If this equipment

does cause harmful interference to radio or television reception, which can be determined by

turning the equipment o and on, the user is encouraged to try to correct the interference by

one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit dierent from that to which the receiver

is connected.

• Consult the dealer or an experienced radio/TV technician for help.

Use ofTrademarks, Registered Trademarks, and other Protected Names and Symbols

This manual may make reference to trademarks, registered trademarks, and other

protected names and/or symbols of third-party companies not related in any way to

StarTech.com. Where they occur these references are for illustrative purposes only and do not

represent an endorsement of a product or service by StarTech.com, or an endorsement of the

product(s) to which this manual applies by the third-party company in question. Regardless

of any direct acknowledgement elsewhere in the body of this document, StarTech.com hereby

acknowledges that all trademarks, registered trademarks, service marks, and other protected

names and/or symbols contained in this manual and related documents are the property of

their respective holders.

Instruction Manual

Table of Contents

Introduction............................................................................................1

Installation ..............................................................................................2

Driver Installation...................................................................................................................................... 2

Application Installation........................................................................................................................... 3

Hardware Installation .............................................................................................................................. 4

Operation..................................................................................................................................................... 4

Option......................................................................................................5

General.......................................................................................................................................................... 5

Encoder Property ...................................................................................................................................... 5

Troubleshooting.....................................................................................7

Specications..........................................................................................9

Technical Support ..................................................................................10

Warranty Information............................................................................10

Instruction Manual

Introduction

The SVID2USB2NS USB 2.0 S-Video and Composite video Capture Cable lets you

connect devices that output S-Video or Composite video to a computer, through an

available USB 2.0 port.

The perfect solution for bridging a computer and an S-Video or Composite video

source, the capture cable oers real time MPEG 1, MPEG 2 and MPEG 4 recording. Small

enough to t in the palm of your hand, the Capture Cable is a great solution for mobile

applications and integrates seamlessly with laptop and desktop computers.

If you require audio with your video capture please see StarTech.com’s S-Video to USB

2.0 Video Capture Cable(SVID2USB).

Backed by a StarTech.com 2-year warranty and free lifetime technical support.

Packaging Contents

• 1 x SVID2USB2NS video capture cable

• 1 x User Manual

• 1 x Driver CD

System Requirements

• USB 2.0 equipped computer

• Pentium 4 - 1GHz or above or equivalent AMD processor

• 128MB of RAM

• Microsoft Windows® 2000 SP4, XP SP2 or above, or Vista

Instruction Manual

Installation

USB 2.0 connector: Connect to USB 2.0 port of your computer

S-Video input: S-Video input from external A/V device (e.g. VCR)

Composite video input: Composite video input from external A/V Device (e.g. VCR)

* If you want capture audio, please connect audio directly to Line-in of your Sound card.

USB 2. 0

connector

Composite

input

S-Video

input

Driver Installation

Note: Do not connect SVID2USB2NS adapter to computer USB port before driver

installation!

Note: Please make sure your computer has USB2.0 port correctly installed and

functioning !! ( Please update your Windows® XP to at least SP2, or Windows® 2000 to

SP4, and updating the USB 2.0 host controller drivers before installation to make sure

the computer’s USB 2.0 is functioning correctly)

1. Please insert “Multimedia Installation Kit” CD-ROM into your CDROM drive; AutoRun

will play; (if AutoRun does not run, please go to “My Computer” and double click the

CD-ROM drive).

2. From the menu, please select the “GrabBeeX-light” product.

3. Please select “Device Driver” on the next screen.

* Note: In Vista, windows will get a pop up dialogue box. Choose “Allow” to continue

the installation.

4. Click “Next”.

5. Complete Setup Wizard.

6. Click “Finish”, then please restart the computer.

Instruction Manual

Application Installation

1. Please insert “Multimedia Installation Kit” CD-ROM into your CDROM drive; AutoRun

will play; (if AutoRun does not run, please go to “My Computer” and double click the

CD-ROM drive).

2. From the menu, please select the “GrabBeeX-light” product.

3. Please select “Application Software” on the next screen.

4. Please select “GrabBee”.

5. Welcome to the InstallShield wizard; Click“Next”.

6. Select the language you will use for GrabBee; then click “Set”.

7. Choose the destination location; Click “Next”.

Note: Under Windows Vista, steps 8 to 17 will automatically be skipped. Please do

not worry as this is normal.

8. Install Windows Media Format 9 Series Runtime Setup;

9. Click “Yes”.

10. License agreement; Click “Yes”.

11. Finished Windows Media Format 9 Series Runtime installation;

12. Click “OK”

13. License for Windows Media Tools Setup; Click “Yes”.

14. Windows Media Tools Setup; Click “Next”.

15. Create folder; Click “Yes”.

16. Installation Options; Click “Next”.

17. Installation Directory; Click “Finish”.

18. Setup Complete; Click “OK”.

19. InstallShield Wizard Complete; Click “Finish” then please restart the computer.

Instruction Manual

After the AP software is installed, three icons will now be shown on screen:

GrabBee : GrabBee software main program

Record Files : Click to see your record  les

Snapshot : Click to see your capture still image  les

Hardware Installation

After the computer restarts, please plug the SVID2USB2NS device into the computer’s

USB 2.0 port; System will now detect the new device and install it automatically.

Please check whether the SVID2USB2NS driver was installed successfully in your computer.

Operation

Starting : Please click the “GrabBee” icon. After starting the application, you can see

video window as below.

Video Window: Please move mouse cursor into Video window and right click, function

menu will appear as below.

Resolution : There are 4 resolution video preview you can select,

NTSC mode : 352x240, 640x480, 720x480, Full screen

PAL mode : 352x288, 640x480, 720x576, Full screen

Instruction Manual

Option

General

• Lists your hard disk space information.

• Snapshot default storage path : The location to saved captured image  les.

• Clip default storage path : Location to saved recorded video  les.

• Video Format : Choose your correct video format input.

• Set Recording Time : Sets Recording Time length.

Encoder Property

• Video Setting: Recording  le type format AVI, MPEG-1, MPEG-2, VCD, SVCD, DVD,

WMV, *MP4 selection (if you want DVD burning, please choose DVD mode)

• Prole: Video Size, Frame Rate, Video Quality, Video Bitrate setting; Information

column will display your setting

Note: File format‘MP4’will not appear as a selectable option under Windows Vista.

Schedule Record : Set One-time schedule here. Input your Start and Stop time, Date,

Video Source, and File Name. Click‘Add’ after input then ‘OK.’

Video Input : Switch between Composite or S-Video input.

Slide Bar : Move to any video position during playback.

Color Setting : Brightness/Contrast/Hue/Saturation adjustment.

Mute : Volume On/O

Pause : Pauses the playback  le

Record : Click this button to start recording a video. After you click “Stop“ button,

a table will be shown, which asks you to rename or save the  le; default  le name

format is “Mddhhmmss”.

M : Month (Jan->1, Feb->2….Oct->O, Nov->N, Dec->D)

dd : Date, hh : Hour, mm : Minute, ss : Second

Stop : Stop Recording and Playback;

Playback : Play the recorded le

SnapShot : Image capture resolution is the same as Preview mode’s

Resolution; click SnapShot and a table shows as below.

Instruction Manual

You can “Save”, “Save All”, “Delete”, “Delete All” image  les,  le name’s format is

“Mddhhmmssn”.

M : Month (Jan->1, Feb->2….Oct->O, Nov->N, Dec->D)

dd : Date; hh : Hour; mm : Minute; ss : Second

n : Number

Album: The Album will show all capture  les including image and video. Please click

“Clips” or “Images”to  nd all listed; you can nd each  le’s information, or preview the

recording video in this window.

Full Screen mode : Double click inside your video window to switch back and forth

between full screen and previous screen size.

Instruction Manual

Troubleshooting

Q1 : Why can’t my system detect the SVID2USB2NS?

A1 : Check that you’ve enabled USB 2.0 in the motherboard BIOS setup.

Please make sure that your system has the latest USB 2.0 host driver.

For Windows® XP, please upgrade to Service Pack 2 or above.

For Windows® 2000, please upgrade to Service Pack 3 or above.

Q2 : Why can’t I see video display?

A2 : Perhaps the video system setup is incorrect; please check your hardware

connection and choose the correct Video Format from the Options menu

Please make sure that your system has the latest USB 2.0 host driver.

For Win XP, please upgrade to Service Pack 2 or above.

For Win 2000, please upgrade to Service Pack 3 or above.

Q3 : Why is the resolution always in 320x240 under preview mode?

A3 : It’s because you plugged the SVID2USB2NS in a USB 1.1 port, or perhaps even

though your USB port is 2.0, it may not have upgraded to USB 2.0 drivers. Please make

sure your USB port is USB 2.0, and have already upgraded the USB 2.0 host driver

available from Microsoft’s Website.

Q4 : Why does the system show “High Speed device plug into Full speed USB port…”

A4 : Please make sure your system supports USB 2.0 hardware.

Please make sure that you’ve installed USB 2.0 Host drivers.

Q5 : Why do I get unstable video during preview and recording?

A5 : If you are using Ultra DMA hard disk, please updated the latest driver of IDE ATA/

ATAPI controller. Certain motherboards’bundled driver are not of the latest version, we

suggest that you use Windows’ own system bundled driver.

Q6 : Why can’t I hear anything under preview mode?

A6: The audio needs to go through sound card’s Line-in, please check your sound card

setting.

Otros manuales para SVID2USB2NS

Tabla de contenidos

Otros manuales de Cables y conectores de StarTech.com

StarTech.com

StarTech.com ICUSB232FTN Manual del sistema

StarTech.com

StarTech.com USB2LINK Manual de usuario

StarTech.com

StarTech.com USB2SATAIDE Manual de usuario

StarTech.com

StarTech.com USB2SATAIDE Manual de usuario

StarTech.com

StarTech.com 35BAYPANELBK Manual del sistema

StarTech.com

StarTech.com USB3S2SAT3CB Manual de usuario

StarTech.com

StarTech.com 35BAYPANEL Manual de usuario

StarTech.com

StarTech.com PCMACLINK2 Manual de usuario

StarTech.com

StarTech.com USBC3LINK Manual de usuario

StarTech.com

StarTech.com HDMI-SPLITTER-4K60UP Manual de usuario

StarTech.com

StarTech.com USB3S2SAT3CB Manual de usuario

StarTech.com

StarTech.com ST122PROA Manual de usuario

StarTech.com

StarTech.com SATRD30CM Manual de usuario

StarTech.com

StarTech.com ICUSBCPLLD25 Manual de usuario

StarTech.com

StarTech.com 1P3FPC-USB-SERIAL Manual de usuario

StarTech.com

StarTech.com POEKIT100 Manual de usuario

StarTech.com

StarTech.com ST122W Manual de usuario

StarTech.com

StarTech.com ICUSB232C Manual de usuario

StarTech.com

StarTech.com ICUSB1284D25 Manual del sistema

StarTech.com

StarTech.com ST122HD4KU Manual de usuario

StarTech.com

StarTech.com ST122DVI Manual

StarTech.com

StarTech.com SVID2USB23 Manual de usuario

StarTech.com

StarTech.com ICUSB232 Manual de usuario

StarTech.com

StarTech.com ICUSB232V2 Manual de usuario

Manuales populares de Cables y conectores de otras marcas

Philips

Philips SWA6310 Manual de usuario

Nohau

Nohau EMUL-IP2K-PC Manual de usuario

Foxun

Foxun SX-SP144E-HD4K2K Manual de usuario

Philips

Philips SWA3305W Manual de usuario

opticis

opticis Stretch DVIM1-1P0x Manual de usuario

Volkswagen

Volkswagen VAS 6558A Manual de usuario

NEXIBO

NEXIBO N-13 Manual de usuario

CYP

CYP PU-1H3HBTL Manual de usuario

Allen-Bradley

Allen-Bradley 1784-u2dhp Manual de usuario

Global Caché

Global Caché Flex Link Blaster Manual de usuario

Hauppauge

Hauppauge USB-Live2 Manual de usuario

Fenix

Fenix MPSV 15 Manual de usuario

BEGA

BEGA 71 085 Manual de usuario

Tesla

Tesla HPWC Manual de usuario

GAMERON

GAMERON LUXURY TV CABLE Manual de usuario

molex

molex Milli-Grid Dual row 87568 Series Manual de usuario

Burndy

Burndy Continental Industries thermOweld CRE-7 Manual de usuario

Chauvet DJ

Chauvet DJ Data Stream 8 Manual de usuario