Star Micronics SF-10HA Manual de usuario
USER’S MANUAL
BEDIENUNGSANLEITUNG
MODE D’EMPLOI
MANUALE UTENTE
SF-10HA
80825760
NOTICE
●
All rights reserved. Reproduction of any part of this manual in any form whatsoever
without STAR’s express permission is forbidden.
●
The contents of this manual are subject to change without notice.
●
All efforts have been made to ensure the accuracy of the contents of this manual at the
time of printing. However, should any errors be detected, STAR would greatly appreciate
being informed of them.
●
The above notwithstanding, STAR can assume no responsibility for any errors in this
manual.
ANMERKUNGEN
●
Alle Rechte vorbehalten. Die Wiedergabe von Teilen dieserAnleitung in jedweder Form
bedarf der schriftlichen Genehmigung durch STAR.
●
Inhaltliche Änderungen vorbehalten.
●
Diese Bedienungsanleitung wurde vor Drucklegung mit gebührender Sorgfalt überprüft.
Sollten sich dennoch Fehler eingeschlichen haben, bittet STAR um Benachrichtigung.
●
STAR übernimmt keine Gewähr für Betriebsstörungen, die sich aus etwaigen Fehlern in
dieser Bedienungsanleitung ergeben.
REMARQUE
●
Tous droits réservés. La reproduction de toute partie de ce mode d’emploi, sous quelque
forme que ce soit, est strictement interdite sans l’autorisation expresse de STAR.
●
Le contenu de ce mode d’emploi est sujet à modification sans préavis.
●
Tous les efforts ont été faits pour assurer la précision du contenu de ce manuel au
moment de l’impression. STAR serait très heureux d’être informé des erreurs qui pour-
raient y être découvertes.
●
En dépit de la remarque ci-dessus, STAR n’assume aucune responsabilité pour les
erreurs de ce manuel.
AVVERTENZA
●
Tutti i diritti sono riservati. La riproduzione di questo manuale, anche parziale, in
qualsiasi forma e senza preventiva autorizzazione scritta della STAR, è proibita.
●
La STAR si riserva il diritto di apportare modifiche in qualunque momento, senza speci-
ficarne i motivi.
●
È stato fatto il possibile per assicurare l'accuratezza del contenuto di questo manuale,
fino al momento della stampa. Si prega di communicare eventuali errori alla STAR.
●
La STAR non si assume alcuna responsabilità per possibili errori riscontrati in questo
manuale.
Copyright 1998 Star Micronics Co., Ltd.
TABLE OF CONTENTS
SF-10HA Automatic Sheet Feeder
Unpacking 1
Preparing the printer 2
Installing the automatic sheet feeder 2
Loading paper 4
Feeding a single sheet of paper 6
Operational Precautions 7
Cleaning 7
Troubleshooting 8
Specifications 9
INHALTSVERZEICHNIS
Automatischer Einzelblatteinzug SF-10HA
Auspacken 10
Vorbereitung des Druckers 11
Einbau des automatischen Einzelblatteinzugs 11
Papier einlegen 13
Einziehen eines Einzelblatts 15
Vorsichtsmaßregeln zum Betrieb 16
Reinigung 16
Fehlersuche 17
Technische Daten 18
TABLE DES MATIERES
Introducteur automatique de feuilles SF-10HA
Déballer le SF-10HA 19
Préparer l’imprimante 20
Installer l’introducteur automatique de feuilles 20
Charger du papier 22
Introduire une seule feuille de papier 24
Précautions relatives à l’utilisation 25
Nettoyer l’introducteur automatique de feuilles 25
Guide de dépannage 26
Spécifications 27
INDICE
Caricatore automatico fogli singoli SF-10HA
Disimballaggio 28
Preparazione della stampante 29
Installazione del caricatore automatico fogli singoli 29
Caricamento della carta 31
Inserimento di un singolo foglio di carta 33
Precauzioni d’uso 34
Pulizia 34
Ricerca e soluzione dei problemi 35
Specifiche tecniche 36
1
English
English
SF-10HA Automatic Sheet Feeder
The SF-10HA Automatic Sheet Feeder makes it possible to automatically feed
paper into your printer. This manual describes the operational procedures for
using the SF-10HA.
Unpacking
❏
After unpacking the contents of the carton, check to make sure you have all
five items. If anything is missing, contact your dealer.
Note:
The automatic sheet feeder is protected by packing material and tape during
shipping. Be sure to remove all of the protective material and tape before use.
Important!
The following procedure requires you to break out two small pieces in order to
expose mechanisms that the automatic sheet feeder must connect with to
operates properly. Make sure that you perform this procedure exactly as
described below.
Automatic sheet feeder
Hopper attachment
User’s Manual
Stacker attachment
2
SF-10HA Automatic Sheet Feeder
Preparing the printer
❏
Enter the printer’s EDS Mode and make the setting that tells the printer that
the ASF is installed (for example, BankA, Switch 4 is OFF on LC-1021
model). Refer to the User’s Manual that comes with the printer for details
on using the EDS Mode.
❏
Unplug the printer from its AC power source.
❏
Open the mute cover of the printer.
❏
Push the release lever back to the cut-sheet position.
❏
Open the rear cover by pushing it back so the cover swings back and down.
❏
Break away the two small pieces from the rear cover as shown in the
illustration above.
Repeatedly press down where indicated by the arrows a number of times
until the tabs weaken and the pieces break free.
❏
Close the rear cover.
Installing the automatic sheet feeder
❏
If you have not already done so:
✓
Make sure that the printer is unplugged from its AC power source.
✓
Open the mute cover and rear cover of the printer.
✓
Push the release lever back to the cut-sheet position.
✓
Remove the small pieces from the rear cover.
✓
Close the rear cover.
See the procedure under “Preparing the printer” in the previous section for
details.
Mute cover
Rear cover
Release lever
Installing the automatic sheet feeder
3
English
English
❏
Lower the auto sheet feeder into the printer so the two round tabs on its
arms enter into grooves in the printer mechanism that was exposed when
you removed the two small pieces (see “Preparing the printer” in the
previous section). The top of the automatic sheet feeder angled towards the
front of the printer when you do this.
❏
Swing the back of the automatic sheet feeder down, and press down gently
until it settles securely in place.
❏
Close the mute cover.
❏
Insert the two hopper attachments on top of the hopper support as shown
below.
❏
Insert the stacker attachment into the holes on the paper tray cover.
Hopper attachment
Stacker attachment
4
SF-10HA Automatic Sheet Feeder
Loading paper
❏
Pull the paper tray cover of the automatic sheet feeder forward.
❏
Align the left paper guide with the scale mark that matches the size of the
paper you are using.
For A4, B5 and legal, align the left paper guide with the A4 mark. For US
letter paper, align the paper guide with the LT mark.
❏
Adjust the right paper guide so there is enough space to insert the paper.
❏
Pick up a stack of paper with both hands and fan through it with your
thumb. This prevents paper from sticking together when it is fed by the
automatic feeder.
Note:
The auto sheet feeder can hold about 50 sheets of 64g/m
2
(30 sheets of 80g/m
2
)
paper.
❏
Tap all four edges of the stack of paper on a table or desk to make sure they
are smooth and even.
Paper guides
Loading paper
5
English
English
❏
Carefully place the paper into the paper tray against the stationary paper
guide on the right side. Make sure that the left and right edges of the paper
stack are under the retaining clips inside the tray.
❏
Close the paper tray cover.
❏
Make sure that the release lever is pushed back to the cut-sheet position.
You are now ready to print with the auto sheet feeder.
Paper guide
Retaining clip
6
SF-10HA Automatic Sheet Feeder
Feeding a single sheet of paper
Use the following procedure to manually feed a single sheet of paper while the
auto sheet feeder is installed.
❏
Insert the paper into the slot behind the stacker as shown below.
For any paper size of A4, B5 and legal, align the paper with the A4 mark
when you insert it. For US letter paper, align the paper with LT mark.
❏
Press the control panel’s
ON LINE
button to put the printer off line.
❏
Press
FORM FEED
button to feed the paper into the printer.
LTA4
Tabla de contenidos
Idiomas:
Otros manuales de Impresora de Star Micronics
Star Micronics
Star Micronics gemini-10X Manual de usuario
Star Micronics
Star Micronics NP-226 Instrucciones de instalación
Star Micronics
Star Micronics DP-8340 FM-120 Manual de usuario
Star Micronics
Star Micronics futurePRNT TSP100 Manual de usuario
Star Micronics
Star Micronics LaserPrinter4 Manual de usuario
Star Micronics
Star Micronics futurePRNT TSP100 Manual
Star Micronics
Star Micronics SB-15 Manual de usuario
Star Micronics
Star Micronics NP-266 Instrucciones de instalación
Star Micronics
Star Micronics TSP700 Series Manual de usuario
Star Micronics
Star Micronics HSP7000 Series Manual de usuario
Star Micronics
Star Micronics TSP143IIIBI Manual de usuario
Star Micronics
Star Micronics TSP1000 Series Guía de referencia rápida
Star Micronics
Star Micronics Multi-Font XR-1000 Manual de usuario
Star Micronics
Star Micronics FVP-10U Manual de usuario
Star Micronics
Star Micronics NX-100 Manual de usuario
Star Micronics
Star Micronics TSP700 Series Manual de usuario
Star Micronics
Star Micronics Radix Manual de usuario
Star Micronics
Star Micronics Star DP8340 Manual de usuario
Star Micronics
Star Micronics TSP600 Series Manual de usuario
Star Micronics
Star Micronics TSP743II Series Manual de usuario
