8
Quick start procedure
• Install the controller on top of the reel if desired (optional on the
P341 models).
• With no power on, attach the camera and accessories to the pushrod.
• Connect the link cable to the connectors on the rear of the controller
and on the pushrod reel.
• Ensure a compatible removable storage device, FAT32 formatted, is
loaded into the controller (Compact Flash or USB Flash Drive).
• Connect the power supply to the controller. If using the optional internal
battery, check you have enough power remaining to perform your survey.
• Switch the controller on.
• Press OK to clear the splash screen.
• Calibrate and zero the camera’s position. Press F10 on the keyboard
or and on the keypad simultaneously.
• Deploy the camera into the pipe as required.
• If required zero the camera’s position by pressing F10 on the keyboard or
press and on the keypad simultaneously.
• On the keypad, press the key to record the inspection.
Enter job details if required:
• Review Client Name, Site Address and Survey Start and Finish Survey
references by pressing the and keys. Press OK to Edit and press
OK, again, to accept the changes.
• On the keypad, press the key again to start recording the
inspection.
• Press the key to take screen captures (if required review Client Name,
Site Address and Survey Start and Finish references as described for
video recording).
• Press OK or enter to make an observation.
• To add text to your videos either:
• Press PG UP or PG DN on the keyboard, or
• Press the key on the keypad, followed by the F1 (EDIT) key
• To pause a recording, press .
• To stop a recording, press .
NOTE: Do not extract the removable storage device during recording or
playback. Doing so may corrupt all data on the storage device and crash
the controller.
