5(615) 599-1505 www.springtree.net
1. Hold down buttons 1 and 8 to enter programming mode (light will turn red).
2. Set desired look on lighting console.
3. Press desired preset button 1-8. Light will ash. Scene is stored.
4. Set new look on lighting console.
5. Press another unused button or record over existing scene by selecting button.
6. Repeat until all 8 scenes are recorded.
7. Hold down buttons 1 and 8 to exit programming mode.
• Hold down buttons 2 and 7 to enter secondary programming mode for setting fade rate (light
turns yellow). Select 1 for 1 second. 2 for 2 seconds. 3 for 3 seconds. 4 for 4 seconds and 8 for
instant (no fade rate). Hold down 2 and 7 to exit program mode.
• If DMX is present at wall station, DMX passes and the wall station is inoperable
Programming
Installation cont.
Connecting Power
The SM-8 comes with a short power whip that connects to the power supply that is provided.
If there is power close simply connect the SM-8 to the power supply. If power is not nearby, power
can be extended with 18 gauge low voltage cable.
Be sure to ground your SM-8!
The SM-8 has a short ground
whip attached to the back. This
can be grounded to the outlet
that is providing power. See
image below.
Color Guide
Purple/Pink - DMX Present from console
Blue - No DMX from console
Red - Program mode
Green - Program mode no DMX
Yellow - Fade rate mode
