Start the pump with the receiving system
connected and in use (if you are using Spowdi
Drip Kit, open the valves to start irrigating), let
the pump run for a few minutes, so the
connected drip kit is filled with water, and then
look for the water level on the Pressure Vessel
(B).
When the pump is delivering water, you should
also hear a repeating beating sound from the
system. For the next steps you need to count
the beats per minute. You can measure this by
counting the beats for 15 seconds and
multiplying it by 4.
When the pump is being used to irrigate with a
dripkit or to transport water to a higher level
the water level i the Pressure Vessel (B) should
be close to ok and the same time the number
of beats per minut should be somewhere
between 100 and 200. If this is not the case,
use the following steps to optimize the system.
Otherwise, skip to step 23. Note! If you change
any part of the irrigation system, you might
need to optimize it again.
NFO! If the connected system is not a
pressurised system (like the Spowdi Drip Kit or
used for pumping water to a higher level) but
instead used for low-pressure transporting of
water, the level in the Pressure Vessel (B) will
always be low and can not be used as a
measure for optimizing the system.
PART 4 - OPTIMIZING THE SYSTEM
