Sper scientific 860041 Manual de usuario

3 Axis EMF Meter

860041

Instruction Manual

CONTENTS

INTRODUCTION .............................................4

APPLICATION..................................................5

FEATURES.......................................................6

IDENTIFYING PARTS .....................................7

MEASUREMENT PROCEDURES..................9

CLOCK SETUP.............................................. 11

AUTO POWER OFF SETUP.........................12

CONTINUITY DATALOGGING SETUP........13

CLEAR DATALOGGER MEMORY ...............14

SINGLE DATA MEMORY ..............................16

VIEW LOGGED READING CONTROL KEY..16

BATTERY REPLACEMENT .......................... 16

EXTERNAL DC POWER...............................17

SAFETY PRECAUTIONS .............................18

SPECIFICATIONS .........................................19

WARRANTY ...................................................20

INTRODUCTION

Safety precautions should be taken against

electric appliances in places including medical

institutions, schools and residential districts,

where people usually stay a long time, to prevent

patients, babies and snior citizens from exposure

to high electromagnetic waves.

An electromagnetic wave simply means the wave

motion of the electromagnetic eld (EMF).

The change in electric elds produces magnetic

elds, and the change in magnetic elds can

also generate electric elds. The uctuation

of correlation between each other is known

as “electromagnetic waves”, which is a form

of energy simular to light and heat that can be

transmitted either bt radiation in the air or by an

electric conductor.

It is suggested that rearragements should be

made in homes and work locations where the

strongest electromagnetic elds are detected in

order to avoid prolonged esposure to excessive

electromagnetic elds

APPLICATIONS

• This meter is applied to measuring magnetic

elds of extremely low frequency (ELF) of

30 to 200 Hz.

• It is capable of measuring the magnetic eld

radiation intensity that is produced from electric

transmission equipment, power lines, microwave

ovens, air conditioners, refrigerators, computer

monitors, video/audio devices and so forth.

• The magnetic eld unit is Tesla (T), Gauss (G),

milli-Gauss (mG) or micro-Tesla (µT).

1 T = 10,000 G

1 G = 1,000 mG

1 µT = 10 mG

FEATURES

• Uses three (3) internal orthogonal sensors to test

a wide range of ELF magnetic elds, independent

of measurement angle.

• The tester is designed to provide a quick, reliable

and easy way to measure magnetic eld radiation

levels around power lines, home appliances and

industrial devices.

• The tester is a cost-e󰀨ective hand-held instrument

that was designed and calibrated to measure

magnetic eld radiation at di󰀨erent bandwidths

from 30 Hz to 2000 Hz.

•

Display micro-Tesla (µT) or milli-Gauss (mG) units.

• Data hold (HOLD), maximum Hold (MAX), and

minimum Hold (MIN) function.

• Autorange and manual rage select mode.

• Datalogging capacity memory size: 500 data sets

• Time and Calendar fuction

• Low battery indication

• Overload display “OL”

• Auto power OFF function

IDENTIFYING PARTS

1. LCD display

2. Power key

3. Maximum Hold & Minimum Hold key

4. Data Hold key

5. Record Data & Setup function Left key

6. Range & Setup function Up key

7. Reading & Setup function Right key

8. Setup function key

9. Units & Setup function Down key

10. Enter key

11. Calibration point for triple axis

12. External power DC 9V

13. Tripod Mounting screw

14. Battery cover

MEASUREMENT PROCEDURES

• Press key turn on the meter, press turn

key again to OFF the meter.

• Press key to select milli-gauss (mG) or

micro-tesla (µT)

• Position the front of the meter to measure the

electromagnetic waves.

• Read the measured value. When manual range

select mode. LCD will shown the ®mark. The

display of “OL” on the highest position indicates

there is an overload on the reading. Press

to select a higher range for measurement again.

• This meter displays the default value is triaxial

total magnetic eld reading, press key to

independent three single-axis magnetic eld

readings and triaxial total magnetic eld reading.

• To permanently lock and keep the reading

displayed on the LCD, press or press

again to unlock.

MEASUREMENT PROCEDURES

• To retain the maximum and minimum value,

press key and the reading value displayed

on the LCD will keep updating to the maximum

value. Press again to select minimum value,

press and hold down key 2 seconds to exit

the maximum and minimum mode.

• Due to the magnetic interference of the

environment eld factors, this magnetic eld

meter could display a reading value that is

lower than 0.5 mG prior to measuring. This is

not a malfunction of the tester.

• With the tester in hand, move slowly towards

to the object under measurement until it is

physically touched.

• Notice how the eld intensity increases as you

move closer to the object.

• If the power of object was turned o󰀨 during the

measurement, the reading of tester should return

to zero, unless there is the electromagnetic from

other sources are detected.

Tabla de contenidos

Otros manuales de Instrumento de medición de Sper scientific

Sper scientific

Sper scientific 800050 Manual de usuario

Sper scientific

Sper scientific 840007 Manual de usuario

Sper scientific

Sper scientific 300003 Manual de usuario

Sper scientific

Sper scientific 800015 Manual de usuario

Sper scientific

Sper scientific 800047 Manual de usuario

Sper scientific

Sper scientific 850097 Manual de usuario

Sper scientific

Sper scientific 850068 Manual de usuario

Sper scientific

Sper scientific 850070 Manual de usuario

Sper scientific

Sper scientific 840062 Manual de usuario

Sper scientific

Sper scientific 850007 Manual de usuario

Sper scientific

Sper scientific 850071 Manual de usuario

Sper scientific

Sper scientific 840063 Manual de usuario

Sper scientific

Sper scientific 800046 Manual de usuario

Sper scientific

Sper scientific 800019 Manual de usuario

Sper scientific

Sper scientific 840060 Manual de usuario

Sper scientific

Sper scientific 850019 Manual de usuario

Sper scientific

Sper scientific 860043 Manual de usuario

Sper scientific

Sper scientific 800052 Manual de usuario

Sper scientific

Sper scientific 850081DOK Manual de usuario

Sper scientific

Sper scientific 840022 Manual de usuario

Sper scientific

Sper scientific 840020 Manual de usuario

Sper scientific

Sper scientific 840010 Manual de usuario

Sper scientific

Sper scientific 850051 Manual de usuario

Sper scientific

Sper scientific 840029 Manual de usuario

Manuales populares de Instrumento de medición de otras marcas

Suaoki

Suaoki D40 Manual de usuario

Elster

Elster BK-G1.6 Manual de usuario

Endress+Hauser

Endress+Hauser Deltabar FMD71 Manual

Duratool

Duratool D03128 Manual de usuario

Vega

Vega VEGAPULS 65 Manual de usuario

Tonghui

Tonghui TH2618B Manual de usuario

Tenmars

Tenmars TM-801 Manual de usuario

MSR

MSR 145 Manual de usuario

TPS

TPS WP-82 Manual de usuario

ELMETRON

ELMETRON CP-511 Manual de usuario

PCB Piezotronics

PCB Piezotronics 003C30 Manual de usuario

Tenma

Tenma 72-10465 Manual de usuario

Endress+Hauser

Endress+Hauser Proline Promag 50 Especificaciones técnicas

Siemens

Siemens SITRANS F Coriolis FCT030 Manual de lista de piezas

KLINGER

KLINGER CMF V Series Manual de usuario

EXFO

EXFO FTB-2 Manual de operación y mantenimiento

Keysight

Keysight M8290A Manual de usuario

ADTEK

ADTEK MW-5 Manual de usuario