9
Established Retriever/Pup network
- Use the Retriever and Pup Launch Utility (RPLU) to confirm the
mesh network is still functioning and that all the Pups are report-
ing to the Retriever. Consult the “Retriever & Pup Wireless Net-
work” Product Manual for complete details.
- Check the Retriever firmware version. The firmware version can
be checked in the Retriever tab of the RPLU by floating your
mouse over the serial number.
- If necessary, update the Retriever to the latest firmware ver-
sion. Firmware updates are available at www.specmeters.com.
- Remove power (batteries or solar panel) from the Retriever.
- Proceed to Installation instructions (p. 14).
Caution: Failure to remove the batteries from the Retriever
or Weather Station before connecting the DataScout modem
will lead to equipment damage.
Retriever/Pup Network being set up at time of DataScout installa-
tion
Once the mesh has been confirmed with the Retriever and Pup
Launch Utility (RPLU), be sure to unplug PC cable from Retriev-
er. Leaving it connected will prevent data from transmitting to
SpecConnect.net. Connect modem to Retriever and power cycle
it. See “Retriever & Pup Wireless Network” Product Manual for
complete details.
WatchDog 2000-series Weather Stations
No pre-deployment configuration is necessary for the WatchDog
Weather Stations. Note that the Weather Station firmware ver-
sion must be 7.6 or higher (Full Station), 4.1 or higher (Mini Sta-
tion), or 3.5 or higher (Model 2800 Weather Station) for use with
the DataScout.
Caution: Failure to remove the batteries from the station be-
fore connecting the DataScout modem will lead to weather
station damage.
Cellular (CDMA, HSPA, LTE-M Models)
The Cellular Models come pre-configured with cellular access.
No additional network setup is necessary.
Pre-Deployment
Configuration
