MAX
FVAm
mA
20A
POWER
OFF
COM
AUTO
6
For 30sec.MAX
every 15 min.
5
MAX 400mA
FUSED
MAX 20A FUSED
!
MAX
700V
20A mA
AC
¦¸
10
9
_
+
#CYL
%ms
Hz
C
DC AC
F
¦¸
¡ãFC
mV A
¡ã
4 2
¦Ì
n
%Hz
¦¸
KM
REL
DC
3
4
2
7
8
1
SYMBOLS
This symbol adjacent to another symbol, terminal or operating device indicates that
the operator must refer to an explanation in the Operating Instructions to avoid
personal injury or damage to the meter.
This WARNING symbol indicates a potentially hazardous situation, which if not
avoided, could result in death or serious injury.
This CAUTION symbol indicates a potentially hazardous situation, which if not
avoided, may result damage to the product.
This symbol advises the user that the terminal(s) so marked must not be connected
to a circuit point at which the voltage with respect to earth ground exceeds (in this
case) 500 VAC or VDC.
This symbol adjacent to one or more terminals identifies them as being
associated with ranges that may, in normal use, be subjected to particularly hazardous voltages.
For maximum safety, the meter and its test leads should not be handled when these terminals are
energized
CONTROLS AND JACKS
Large 4000 count Liquid Crystal Display
1. with symbolic signs.
2. Function switch
3. Positive (+) input jack for DC/AC Voltage,
current, Hz/ %duty cycle, Ohms, Diode,
Continuity, Capacitance, Temperature (℃or ℉)
measurements, RPM, DWELL, Pulse width
4. COM (negative) input jack.
5. (positive) input jack for DC/AC μA/mA
6. 20A (positive) input jack for 20A DC or
7. AC measurements.
8. Data Hold and backlight pushbutton.
9. Relative pushbutton.
10. RPM, DWELL, Hz/%, mS+/_ button.
11. Mode push button.
