Form 1807 (09.22) ©SOR Inc.
1/16
These instructions provide information for installation,
process connection, electrical connection, configuration,
operation and maintenance of the 1800PT and 1800HP
Pressure Transmitters. The 1800 Series Pressure
Transmitters are offered with either a standard over
pressure (model 1800PT) or a high over pressure
(model 1800HP); the information contained
in this document applies to either version.
1800PT and 1800HP
Pressure Transmitters
General Instructions
Registered Quality System to ISO 9001
NOTE: If you suspect that a product is defective, contact the
factory or the SOR
®
Representative in your area for a return
material authorization number (RMA). This product should
only be installed by trained and competent personnel. Product
specifications and important information provided on the device
nameplate should be carefully reviewed before installation.
Design and
specifications are
subject to change
without notice.
For latest revision, go to
sorinc.com
Table of Contents
Installation.......................................1
Electrical Connections .........................2
Configuration with Push-Buttons .............2
Factory Settings and Reset....................7
ATEX and IECEx Marking Details .............8
Maintenance.....................................9
Dimensions .................................... 10
Manifolds ...................................... 12
1800HP
High Over
Pressure
1800PT
Standard
Over Pressure
Installation
Normally, line mounting provides adequate support for the instrument.
n
The process connection is threaded onto a fitting within an adequately supported
process piping system.
o
Use two open end wrenches when connecting the pressure port to a process piping
system: one wrench to hold the process fitting, the other at the hex flat to tighten the
gauge pressure transmitter.
p
Process connection pipe or tubing may be rigid or flexible.
q
If ordered with the PK accessory, ensure the device is securely fastened to the pipe
mounting bracket.
