Sony HKSR-5804 Manual de usuario
NETWORK INTERFACE BOARD
HKSR-5804
INSTALLATION MANUAL
1st Edition
HKSR-5804
!WARNING
This manual is intended for qualified service personnel only.
To reduce the risk of electric shock, fire or injury, do not perform any servicing other than that
contained in the operating instructions unless you are qualified to do so. Refer all servicing to
qualified service personnel.
!WARNUNG
Die Anleitung ist nur für qualifiziertes Fachpersonal bestimmt.
Alle Wartungsarbeiten dürfen nur von qualifiziertem Fachpersonal ausgeführt werden. Um die
Gefahr eines elektrischen Schlages, Feuergefahr und Verletzungen zu vermeiden, sind bei
Wartungsarbeiten strikt die Angaben in der Anleitung zu befolgen. Andere als die angegeben
Wartungsarbeiten dürfen nur von Personen ausgeführt werden, die eine spezielle Befähigung
dazu besitzen.
!AVERTISSEMENT
Ce manual est destiné uniquement aux personnes compétentes en charge de l’entretien. Afin
de réduire les risques de décharge électrique, d’incendie ou de blessure n’effectuer que les
réparations indiquées dans le mode d’emploi à moins d’être qualifié pour en effectuer d’autres.
Pour toute réparation faire appel à une personne compétente uniquement.
1-1 (E)
HKSR-5804
Section 1
Installation
Purpose of this manual
This manual is an installation manual of Network I/F Board HKSR-5804.
This manual is intended for system and service engineers, so describes information regarding installation.
Related manual
Besides this installation manual, the following manual is available for HKSR-5804.
.SRW-5800 Maintenance Manual (available on request)
This manual describes the information for the maintenance of this unit and the information that pre-
mises the parts level service.
If this information is required, contact your local Sony Sales Office/Service Center.
1-1. Specifications
General
Dimensions (w/h) MY-115 Board: 355 x183 mm
Mass MY-115 Board: approx. 1.03 kg
Power requirements +6.2V dc: 5.3 A
+3.3V dc: 1.8 A
Power consumption 38.8 W
1-2. Installation Overview
Components
.MY-115 Board (x1)
.Network panel assembly (x1)
Assembly of parts listed below
. Network 2 panel (x1)
. IF-1071 Board (incl. a modular jack) (x1)
. Coaxial cables with a BNC connector (x4)
.Connection cord (with modular plugs) (x1)
A ferrite core is attached.
.Operation manual (CD-ROM) (x1)
.Installation guide (x1)
.Installation manual (x1)
Applicable model
SRW-5800
1-2 (E) HKSR-5804
Matching Connectors/Cables/Signal Inputs and Outputs
When external cables are connected to the connector of this unit, the hardware listed below (or equiva-
lents) must be used.
Panel indication Matching connector (cable) Sony part No. Signal
AUX INPUT A BNC 75 Z, MALE 1-569-370-12 HD SDI signal input
AUX INPUT B BNC 75 Z, MALE 1-569-370-12 HD SDI signal input
AUX OUTPUT A BNC 75 Z, MALE 1-569-370-12 HD SDI signal output
AUX OUTPUT B BNC 75 Z, MALE 1-569-370-12 HD SDI signal output
NETWORK 2 Commercially available
NETWORK 2: RJ-45 modular jack
Standard : Complied with IEEE 802.3ab (1000BASE-T)
Pin No. I/O Signal
1 I/O TP0 (+)
2 I/O TP0 (_)
3 I/O TP1 (+)
4 I/O TP2 (+)
5 I/O TP2 (_)
6 I/O TP1 (_)
7 I/O TP3 (+)
8 I/O TP3 (_)
81
External view
1-3 (E)
HKSR-5804
Description of the switch function on the MY-115 Board
Ref. No Name Description Factory setting
S900 PCI Factory use
S1000 Reset System reset
S1001 —Factory use
S1400 —Factory use
S1401 —Factory use
S1402 —Factory use
S1403 —Factory use
A B C D E F G H J K L M NP
1
2
3
4
5
6
7S5000
S1001
S1000
S1404
S1402
S1400
S1403
S1401
S4501
S4500
S3001
S900
S3000
1O
N
2
3
4
1O
N
2
3
4
5
6
7
8
1O
N
2
3
4
5
6
7
8
1O
N
2
3
4
5
6
7
8
1O
N
2
3
4
5
6
7
8
1-4 (E) HKSR-5804
Ref. No Name Description Factory setting
S1404 —S1401-1 OFF : Normal start
ON : Start by program of boot
S1401-2 to 8 Factory use
S3000 SW A Factory use
S3001 SW B Factory use
S4500 SW C Factory use
S4501 SW D Factory use
S5000 PLD SW A Factory use
1O
N
2
3
4
5
6
7
8
1O
N
2
3
4
1O
N
2
3
4
1O
N
2
3
4
1O
N
2
3
4
1O
N
2
3
4
1-5 (E)
HKSR-5804
1-3. Installation Procedure
1. Turn off the power of the VTR.
2. Fully loosen the fixing screw, and then slide the two
knobs on the upper lid (front) assembly each to the
inside.
Move the knobs to the outside to fix the upper lid
(front) assembly.
3. Remove the upper lid (front) assembly in the arrow
direction.
4. Fully loosen the two fixing screws, and then remove
the upper lid (rear) assembly in the arrow direction.
Knob
Knob
Upper lid (front) assembly
Fixing screw
Removal
Installation
Upper lid (rear)
assembly Fixing screw
Fixing screw
Protrusion
Square hole
1-6 (E) HKSR-5804
5. Disconnect all coaxial cables from HIF and FC (TX)
boards. Leaving EQ and HPR boards, raise eject levers
and then pull out the other boards upward.
6. Remove the six screws to detach the blank panel from
the connector panel assembly.
Remove the ten screws to detach the connector panel
assembly.
7. Attach the network panel assembly of HKSR-5804 to
the connector panel assembly with the screws that
were used for the blank panel.
8. Pass the four coaxial cables of the network panel
assembly one by one through the chassis.
SS
APR
FC
DVP
HIF
MY
HPR
EQ
Eject lever
Eject lever
<Top view>
Blank panel Connector panel assembly
BVTT
3 x6
BVTT
3 x6
BVTT
3 x6
BVTT
3 x6
Connector panel assembly
Network panel assembly
Chassis
Coaxial cables
1-7 (E)
HKSR-5804
IF-1071 board
Connection cord
(with modular plugs)
Harness clamps
Connector panel assembly
BVTT3 x 6
BVTT3 x 6
Portion A
Portion A
9. Connect the connection cord (with modular plugs) to the IF-1071 board on the network panel.
Insert the two connectors on the back of the connector panel assembly to the mother board, and fix
the connector panel assembly with ten screws.
n
Push the portions A of connector panel assembly, and connect it firmly to the connector of the mother
board.
Pass the connection cord (with modular plugs) through the two harness clamps and draw the other
end up.
1-8 (E) HKSR-5804
10. Check the DIP switches on the MY-115 board are
correctly set as Section 1-2.
11. Insert the MY-115 board and the plug-in boards, that
were removed in the step 5, into their respective slots.
Perform in the following order.
1) Insert the MY-115 board.
n
Be sure not to catch the connection cord (with
modular plugs) in the connectors of MY/Mother
boards.
2) Connect the connection cord (with modular plugs)
to CN700 on the MY-115 board.
3) Connect four coaxial cables to the MY-115 board.
4) Insert the HIF-46 board, and connect 13 coaxial
cables.
5) Insert the DVP-43 board (HKSR-5802).
6) Insert the FC-91 board (HKSR-5001) and connect
four coaxial cables to TX-96 boards on the FC-91
board.
7) Insert the APR-81 board.
8) Insert the SS-102 board.
9) Press down the eject levers of respective boards, to
tightly connect the boards to the connectors on the
mother board.
SS
APR
FC
DVP
HIF
MY
HPR
EQ
<Top view>
Eject lever
Eject lever
L
CN700
LK76
CN2253
CN2254
CN2251
CN2250
K
7
6
MY-115 Board (HKSR-5804)
black
black
Connection cord (blue)
(with modular plugs)
CN211 CN213
CN210
F
CN209
E
CN202
D
CN205
C
CN208
B
CN203
A
CN204
1
CN200
3
CN201
2
CN207
4
CN206
black
black
black
white orange
HIF-46 Board
green
blue
J
H
CN204
CN203
TX-96
G
5
CN204
CN203
TX-96
black black
FC-91 Board/TX-96 Board (HKSR-5001)
Otros manuales para HKSR-5804
1
Tabla de contenidos
Otros manuales de Equipo de grabación de Sony
Sony
Sony PCM-D50 - Portable Linear Pcm Recorder Manual de usuario
Sony
Sony PDW-75MD Manual de usuario
Sony
Sony DMX-R100 Manual de usuario
Sony
Sony SEQ-V902 Manual de usuario
Sony
Sony SRPC-1 Manual de usuario
Sony
Sony HXR-IFR5 Manual de usuario
Sony
Sony MCS-1 Manual de usuario
Sony
Sony CFD-RS60CP Manual de usuario
Sony
Sony SEQ-711 Manual de usuario
Sony
Sony IFB-12A Manual de usuario
Sony
Sony PFV-D10 Manual de usuario
Sony
Sony UVW-1800P Manual de usuario
Sony
Sony HVR-M25C Manual de usuario
Sony
Sony SVR-HDT1000 Manual de usuario
Sony
Sony BKP-7933 Manual de usuario
Sony
Sony RCDW500C - Compact Disc Player Manual de usuario
Sony
Sony AWS-750 Manual de usuario
Sony
Sony TC-177SD Guía de configuración
Sony
Sony HSR-J2009 Manual de usuario
Sony
Sony TC-765 Manual de usuario
Manuales populares de Equipo de grabación de otras marcas
Strymon
Strymon NIGHTSKY Manual de usuario
Mitsubishi Electric
Mitsubishi Electric 16CH DIGITAL RECORDER DX-TL5000U Manual de usuario
Tews Technologies
Tews Technologies TPMC465 Manual de usuario
Honeywell
Honeywell Excel 50 Manual de usuario
SeaLevel
SeaLevel COMM+8.LPCI Manual de usuario
Arturia
Arturia AUDIOFUSE STUDIO Manual de usuario
