Sony WM-EX570 Manual de usuario

MICROFILM

SERVICE MANUAL

CASSETTE PLAYER

AEP Model

E Model

Tourist Model

SPECIFICATIONS

WM-EX570

Dolby noise reduction manufactured under license

from Dolby Laboratories Licensing Corporation.

“DOLBY” and the double-D symbol aare trade-

marks of Dolby Laboratories Licensing Corporation.

Model Name Using Similar Mechanism NEW

Tape Transport Mechanism Type MT-WMEX550-125

Photo: Black model

Ver 1.0 1999. 02

– 2 –

Flexible Circuit Board Repairing

• Keep the temperature of the soldering iron around 270 ˚C dur-

ing repairing.

• Do not touch the soldering iron on the same conductor of the

circuit board (within 3 times).

• Be careful not to apply force on the conductor when soldering

or unsoldering.

Notes on chip component replacement

• Never reuse a disconnected chip component.

• Notice that the minus side of a tantalum capacitor may be dam-

aged by heat.

TABLE OF CONTENTS

1. SERVICING NOTES............................................... 3

2. GENERAL ................................................................... 5

3. DISASSEMBLY ......................................................... 6

4. MECHANICAL ADJUSTMENTS....................... 11

5. ELECTRICAL ADJUSTMENTS......................... 11

6. DIAGRAMS

6-1. Block Diagram ................................................................ 12

6-2. Printed Wiring Board ...................................................... 14

6-3. Schematic Diagram ......................................................... 17

6-4. IC Pin Function Description ........................................... 23

7. EXPLODED VIEWS................................................ 25

8. ELECTRICAL PARTS LIST ............................... 28

SAFETY-RELATED COMPONENT WARNING!!

COMPONENTS IDENTIFIED BY MARK !OR DOTTED

LINE WITH MARK !ON THE SCHEMATIC DIAGRAMS

AND IN THE PARTS LIST ARE CRITICAL TO SAFE

OPERATION. REPLACE THESE COMPONENTS WITH

SONY PARTS WHOSE PART NUMBERS APPEAR AS

SHOWN IN THIS MANUAL OR IN SUPPLEMENTS PUB-

LISHED BY SONY.

– 3 –

SECTION 1

SERVICING NOTES

1. Setting

1) Refer to “3. DISASSEMBLY”, and remove the cabinet and

open the MAIN board.

2) Connect the MAIN board to the M901 (motor) and PM901

(plunger) using jumper wires.

3) Short the ATS terminals.

4) Press and fixed the S701 (CASSETTE HOLDER).

5) Supply 1.5V to the battery terminals ‘and ’using a stabi-

lized power supply.

2. FF, REW Modes

1) Input a square wave to the TP35 (PHOTO IN) and TP23

(GND). (See figure below)

2) Press the S704 (STOP) for selecting STOP mode.

3) Press the S706 (FF) or S707 (REW).

3. PLAY mode

1) Input a square wave to the TP35 (PHOTO IN) and TP23

(GND). (See figure below)

2) Press the S704 (STOP) for selecting STOP mode.

3) Press the S705 (PLAY). (Each time the switch is pressed, the

mode is changed over)

This set detects the rotation of GEAR (S) using the PH701 (photo

reflector). The PH701 is mounted on the MAIN board, and there-

fore the GEAR cannot be detected with the MAIN board removed.

As a result, the motor cannot be controlled, causing malfunction.

Further, the S702 (FWD/REV switch) is also mounted on the MAIN

board, and with the board removed, the mechanism position

cannnot be detected and the operation is not changed over.

Therefore, when the voltage check is executed with the MAIN

board removed, follow the procedure provided below.

Note : Do not move the S702 swithc position when removing the MAIN

board.

If it is moved, the set will not be changed over to the selected mode.

In this case, reconnect the MAIN board to the set and retry the

work from the beginning.

— MAIN BOARD (Side B) —

oscillator

square wave

10 Hz, – 3.5 dB

S702

IC701

S705 (PLAY)

S704 (STOP)

TP23

(GND)

FWD

→

REV

S706 (FF)

S707 (REW)

RV601

connect to

M901 (motor)

battery terminal

PH701

TP35

PHOTO

battery terminal

ATS terminals

(to S901)

connect to

PM901 (plunger)

S701

CASSETTE

HOLDER

–

– 4 –

Lever (SW) Rotation system

Rotation system during PLAY.

Rotation system during FF. Rotation system during REW.

senter

lever (SW)

side R side F

Pulley (reverse)flywheel (R) assy

flywheel (N) assy

gear (Y)

gear (TA)

gear (TB) gear (S) motor pulle

gear (REEL)

(S side)

gear (NR)

(REV: right side/

FWD: left side)

gear (REEL)

(T side)

clutch assy (M)

gear (TB)

gear (REEL)

(T side)

gear (Y)

gear (NR) motor pulley

pulley (reverse)

clutch assy (M)

flywheel (R) assy

flywheel (N) assy

gear (FR)

(FF: left side)

gear (NR)

gear (Y)

gear (S)

flywheel (N) assy flywheel (R) assy pulley (reverse)

clutch assy (M)

motor pulley

gear (REEL)

(S side)

gear (FR)

(REW: right side)

– 5 –

SECTION 2

GENERAL This section is extracted from

instruction manual.

– 6 –

Note: Follow the disassembly procedure in the numerical order given.

SECTION 3

DISASSEMBLY

•This set can be disassembled in the order shown below.

LID ASSY, CASSETTE

Case AssySet

Lid Assy,

Cassette Ornament Assy Belt

Holder

Motor (Capstan/Reel)

(M901)

Head, Magnetic

Main Board,

Note for Installation

Open the cassette lid assy

Remove the cassette lid assy to

direction of the arrow

screw

(M1.4

1.6)

screw

(M1.4

2.0)

– 7 –

CASE ASSY

ORNAMENT ASSY

case assy

two claws

two screws

(M1.4

2.2)

two screws

(M1.4

2.2)

Remove the reel ornament to

direction of the arrow

Push to the direction of the arrow

remove the claw of knob (OPEN).

four claws

– 8 –

BELT

HOLDER

belt

Remove two

solders of battery terminal.

screw

two claws

holder

– 9 –

MAIN BOARD

NOTE FOR INSTALLATION

•MAIN BOARD

On installation MAIN board adjust

the S702 and lever (SW)

Remove four

solders of motor.

screw

(M1.4

1.6)

MAIN board

flexible boar

(CN301)

three screws

Remove two

solders of

plunger solenoid.

lever (SW)

S702

– 10 –

MOTOR (CAPSTAN/REEL) (M901)

HEAD, MAGNETIC

two screws (M1.4)

Remove the motor (M901) t

direction of the arrow.

two pinch levers

bracket ass

head, magnetic

(HP901)

flexible board

(CN301)

two screws

(M1.4

7.2)

screw

(M1.4

1.6)

Otros manuales para WM-EX570

Tabla de contenidos

Otros manuales de Reproductor de casetes de Sony

Sony

Sony Walkman WM-EX2000 Manual de usuario

Sony

Sony DXA-WZ5 Manual de usuario

Sony

Sony J10 Manual de usuario

Sony

Sony TC-WR901ES Manual de usuario

Sony

Sony TC-RX300 Manual de usuario

Sony

Sony Walkman WM-EC1 Manual de usuario

Sony

Sony TC-FX211 Manual de usuario

Sony

Sony CFS-B15 - Am/fm Stereo Cassette Recorder Manual de usuario

Sony

Sony WM-20 Manual de usuario

Sony

Sony SLV-M20HF - Video Cassette Recorder Manual de usuario

Sony

Sony TC-WE675 - Dual A/r Cassette Deck Manual de usuario

Sony

Sony MW-FX277 Manual de usuario

Sony

Sony TCM-210DV Operating Instructions (primary... Manual de usuario

Sony

Sony CFD-S07CP Manual de usuario

Sony

Sony Sports Walkman WM-FS421 Manual de usuario

Sony

Sony TC-WE435 Manual de usuario

Sony

Sony TC-D3 Manual de usuario

Sony

Sony SLV-ED100ME Manual de usuario

Sony

Sony Walkman WM-FX473 Manual de usuario

Sony

Sony TC-WA8ESA Manual de usuario

Sony

Sony Walkman WM-FX28 Manual de usuario

Sony

Sony SLV-SE220 Manual de usuario

Sony

Sony CFS-616S Manual de usuario

Sony

Sony Walkman WM-EX2000 Manual de usuario

Manuales populares de Reproductor de casetes de otras marcas

Aiwa

Aiwa TP-VS535 Manual de usuario

Philips

Philips AW 7300 Manual de usuario

Philips

Philips Video Cassette Recorder Manual de usuario

Yamaha

Yamaha MT8X Manual de usuario

Manta

Manta MA408 Manual de usuario

Sherwood

Sherwood Newcastle D-480 Manual de usuario

Tascam

Tascam 122MKIII Guía

GPO

GPO W0162B Manual de usuario

Sharp

Sharp JC-AV1 Manual de usuario

Pioneer

Pioneer CT-W103 Manual de usuario

Aiwa

Aiwa HS-JX899 Manual de usuario

Aiwa

Aiwa HS-TA21 Manual de usuario

Sanyo

Sanyo MCD-ZX700F Manual de usuario

Aiwa

Aiwa CS-P77 Manual de usuario

THOMSON

THOMSON RK101CD Manual de usuario

Pioneer

Pioneer CT-S920S Manual de usuario

Pioneer

Pioneer KEH-P7035 Manual de usuario

Sanyo

Sanyo MCD-Z7F Manual de usuario