7
NOTE: BEFORE MOUNTING YOUR RECEIVER, TEST YOUR
RANGE.
Place the Transmitter with remote Sensor in the area needed and
place Receiver in desired location (up to 50 eet away). Turn ON
Receiver. Switch Transmitter to TEST mode. I the units are within
range, the Receiver will also sound. You can now mount your
Receiver. To start operation: Switch Transmitter to "ON" then Reset
and Switch ON the Receiver (see page 6).
WALL MOUNTING: To mount the mounting bracket (Holder)
o the Receiver, drill two holes in the desired location, ensure
hole centers align vertically, insert screws into the mounting holes,
letting the screw's head extend about 3mm ( 1/8" ) rom the
sur ace, then place the Receiver mounting bracket (holder) and
tighten the two screws. Place the Receiver into the mounting
bracket, the mounting bracket will sel -lock the Receiver.
TEST THE RANGE: BEFORE MOUNTING YOUR RECEIVER
AND/OR TRANSMITTER, TEST YOUR RANGE.
MOUNTING THE RECEIVER
RE EIVER MOUNTING
BRA KET
55 mm (2-3/16 inch)
