SAFETY NOTICE
Read all safety warnings and instructions carefully. Failure to follow the appropriate warnings and instructions may result in electric
shock, fire and severe burns.
•Keep the device and its components out of the reach of children.
•Never charge the device outdoors or expose it to water.
•If the device overheats, it automatically shuts down.
•Never use the scissors on objects that are live.
•When you are not using the scissors, make sure the battery is disconnected.
•Check the strength and tightness of the blades before use.
•Disconnect the battery during any maintenance/manipulation of the device.
•Do not use the device on non-plant materials and do not exceed the maximum diameter allowed.
•Keep the equipment clean.
•Wear safety goggles and appropriate clothing when working.
BATTERY POWER SUPPLY
The battery of the newly purchased product is not charged. Plug the charger plug into the battery socket. Finally, plug the charger into
an electrical outlet. The charger indicator light is red. This indicates that the charger is charging. After 1.5-2.5 hours, the charger light
will turn green. Charging is complete. You can use the battery.
•When charging, the charger and battery get slightly hot.
•If the battery is not used for an extended period of time, it should be recharged every 3 months to prolong its life.
•A new battery or a battery that has not been used for a long time needs approximately 5 charge and discharge cycles to reach its
maximum capacity.
•Do not charge the battery after only a few minutes of operation, this could reduce the operating time and performance of the
battery.
•Do not store the battery in a humid environment.
•Use only the original charger from the manufacturer.
•Keep the battery away from small metal objects.
•Do not disassemble or modify the battery in any way.
•Keep the battery away from heat sources.
•Do not charge the battery outdoors.
JAW OPENING ADJUSTMENT
The jaws can be opened to several preset positions. On the switch above the battery, you can choose from four positions depending on
how thick you want to cut.
EQUIPMENT MAINTENANCE
Always disconnect the battery before performing any maintenance. Apply oil after every approximately 5 hours of work. To apply oil,
follow the steps below.
1. Unscrew the nut and remove the cotton wool (Fig. 1)
2. Drip oil into the hole and plug it with cotton wool (Fig. 2)
3. Cut several times with the scissors on empty to disperse the oil (Fig. 3).
BLADE SETTING
A blade with proper tightening will not swing from side to side. If the blade setting is normal, the shears will cut with less effort. Always
disconnect the battery and follow the steps below before checking/adjusting.
1. Loosen the top screw and remove the nut lock.
2. Tighten/loosen the nut until the appropriate condition is reached.
3. Put the bracket back on and screw in the screw.
