DOCS-1023 v1.0
Caution: Failure to follow the RF Coaxial manufacturer’s minimum bend radius
guidelines may result in a loss or performance or cable failure.
F.Grounding Straps and Surge Suppression
A grounding strap should be attached between the BSU Chassis and the Tower/Rooftop grounding
point. Additional cable and system surge suppression installation steps should also be completed
at this point. Please refer to Solectek document SkyWay MAX Outdoor Base Station - Surge
Suppression Guidelines DOCS-1033, or contact Solectek Technical Support for more information.
VIII. Regulatory Information
This equipment has been tested and found to comply with the limits for a Class A
digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provided reasonable protection against harmful interference when the equipment is
operated in a commercial environment. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with
the instruction manual, may cause harmful interference to radio communications.
Operation of this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the interference at
his own expense.
Warning: Changes or modifications not expressly approved by Solectek could void
the user’s authority to operate the equipment.
Warning: This product contains no user servicable parts and must be professionally
installed.
RF Exposure Requirements: To satisfy FCC RF exposure requirements for mobile
transmitting devices, a separation distance of 20 cm or more should be maintained
between the antenna of this device and persons during device operation. To ensure
compliance, operations at closer than this distance is not recommended.
The antenna used for this transmitter must not be co-located in conjunction with any
other antenna or transmitter
