Do this:
1: Connect the SControl with 12
volts from the power supply. If
you do not have electricity in
the room, use a 12 volt baery.
During the normal operaon of
the SControl, the status screen is
displayed.
If no buon is pressed for 2
minutes, the display light goes o.
2: To reacvate the background
light, press any key.
To switch between menu items,
turn the dial.
The screen shows:Explanaon:
Auto 12.21
Room 1 22,50C
Sengs
Apparatus info
3: When you see you can
press here on the OK key and get
into the submenu. Do this at the
sengs point. Each me you
have selected a value - press the
OK key, and the value is saved.
Here these opons are shown:
Language selecon, summer
me seng, clock, date, desired
mode of operaon (- choose 4),
Sengs 12.22
Language
Summer me
Clock
4: First select your preferred
language and conrm with the
OK key - and proceed through the
menu to set the clock etc. Under
system, select No. 4.
Do you have the me and curiosity to look
more into the opportunies that the SControl
oers, you will nd that there are many ways
to use a good solar air collector.
It is, for example, excellent in keeping houses
and cellars dry, fresh and free of dangerous
radon.
A SolarVen can do much more than just
create heat. For example, the fresh air is also
cleaned of pollen and dust parcles down to
5µM in size - and the lter stays clean with
the heat from the sun.
See much more at www.solarven.dk
- A genuine Danish product
Factory sengs that you can change:
Factory: Possibility:
Max allowed moisture in
the room: 70% RH 30 - 90%
Fan rotaon: High Low stand. high max
(20% 50% 80% 100%)
Start temperature in collector: 50C 10 - 400C
+ dierenal control before start. (It must be warmer in the collector than
inside the garage. )
When set in menu for garages, the fan will automacally start at a
humidity level above 70% regardless of the temperature in the
collector. If the humidity level does not begin to fall within a few
minutes, the fan will stop again.
-
See the full descripon in the installaon and user manual
System 4 in general (Moisture in basement)
a
The fans always run when it is warmer in the collector than in the room where
the SCon controller is placed. That means that it also adds heat.
The fan stops again when it is colder outside than inside.
a
The mer funcon i acve at night: The fan will run some minutes every hour
to remove extra moisture. Please read the Textbook from SolarVen to un-
derstand this special procedure.
Fan also starts when there is more than the allowable moisture (RH > 70%)
The fan stops again when the moisture level is brought down to the desired
level or if no improvement is achieved by driving within fx. 20 minutes. (Can
be set).
This can be expanded with several operang modes such as cooling.
