SolarEdge ZigBee Manual de usuario
Disclaimers
ZigBee Repeater Installation Guide –MAN-01-00130-1.0
1
Disclaimers
Important Notice
Copyright © SolarEdge Inc. All rights reserved.
No part of this document may be reproduced, stored in a retrieval
system or transmitted, in any form or by any means, electronic,
mechanical, photographic, magnetic or otherwise, without the prior
written permission of SolarEdge Inc.
This document is solely for the use of SolarEdge customers and
employees.
The material furnished in this document is believed to be accurate
and reliable. However, SolarEdge assumes no responsibility for the
use of this material. SolarEdge reserves the right to make changes to
the material at any time and without notice. You may refer to the
SolarEdge web site (www.solaredge.com) for the most updated
version.
All company and brand products and service names are trademarks
or registered trademarks of their respective holders.
Patent marking notice: http://www.solaredge.com/groups/patent
The general terms and conditions of purchase of SolarEdge products
shall apply.
The content of these documents is continually reviewed and
amended, where necessary. However, discrepancies cannot be
excluded. No guarantee is made for the completeness of these
documents.
Disclaimers
ZigBee Repeater Installation Guide –MAN-01-00130-1.0
2
2
FCC Compliance
This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment OFF and ON, you are encouraged to try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and the
receiver and its antenna.
Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for
help.
Changes or modifications not expressly approved by the party
responsible for compliance may void the user’s authority to operate
the equipment.
Table of Contents
ZigBee Repeater Installation Guide –MAN-01-00130-1.0
3
Table of Contents
Disclaimers.......................................................................... 1
Important Notice .............................................................1
FCC Compliance ...............................................................2
Table of Contents ................................................................ 3
About This Guide................................................................. 4
Support and Contact Information ........................................ 5
Chapter 1: Introducing the SolarEdge ZigBee Repeater ........ 6
Overview..........................................................................6
Package Contents ............................................................7
Chapter 2: SolarEdge Repeater User Interfaces.................... 8
Chapter 3: Installing the Repeater ..................................... 10
Installation Guidelines ...................................................10
Connecting the Repeater ...............................................11
Verifying the Connection ...............................................12
Troubleshooting.............................................................12
Yellow LED (Link) is OFF....................................................... 12
Green LED (S_OK) is OFF ..................................................... 13
Appendix A: Technical Specifications................................. 14
About This Guide
ZigBee Repeater Installation Guide –MAN-01-00130-1.0
4
4
About This Guide
This user guide is intended for Photovoltaic (PV) system owners,
installers, technicians, maintainers and integrators who use the
SolarEdge power harvesting system.
This manual describes how to install and set up the ZigBee™
communication between a SolarEdge device (inverters or Safety and
Monitoring Interface) and the SolarEdge home ZigBee repeater). The
manual instructions and graphics refer to the inverter; however
apply to SMI as well.
This guide assumes that the SolarEdge power harvesting system is
already installed and commissioned. For additional information
about how to install and commission the SolarEdge power harvesting
system, refer to the relevant installation guide.
The guide includes the following chapters:
Chapter 1: Introducing the SolarEdge ZigBee Repeater, page 6,
describes the SolarEdge ZigBee repeater functionality and
connection.
Chapter 2: SolarEdge Repeater User Interfaces, page 8,
describes the repeater connectors and LEDs.
Chapter 3: Installing the Repeater, page 10, describes how to
mount, connect, and verify the connection of the SolarEdge
repeater.
Appendix A: Technical Specifications page 14, provides the
electrical and mechanical specifications of the SolarEdge ZigBee
repeater.
For further information, datasheets and the most up-to-date
certifications for various products in different countries, please visit
the SolarEdge website: www.solaredge.com
Support and Contact Information
ZigBee Repeater Installation Guide –MAN-01-00130-1.0
5
Support and Contact Information
If you have technical queries concerning our products, please contact
us:
US & Canada
1877 360 5292
support@solaredge.us
Germany
+49 89-45459730
support@solaredge.de
France
0800917410
support@solaredge.fr
Belgium
080073041
support@solaredge.be
Italy
800 784 824
support@solaredge.it
Netherlands
08000221089
support@solaredge.com
United
Kingdom
0800 028 1183
Greece
00800125574
Israel
+972 73 240-3118
Japan
+81.3.5530.9360
Australia
1800149229
Worldwide
+972 73 240-3118
Fax
+972 73 240-3117
Before contacting SolarEdge, ensure you have the product serial
number as appears on its label.
Chapter 1: Introducing the SolarEdge ZigBee Repeater
ZigBee Repeater Installation Guide –MAN-01-00130-1.0
6
6
Chapter 1: Introducing the
SolarEdge ZigBee Repeater
Overview
The SolarEdge ZigBee repeater (range extender) is used for
extending the wireless connectivity range between SolarEdge
devices that are equipped with ZigBee transmitters.
Figure 1: The SolarEdge ZigBee Repeater
For example, use the SolarEdge ZigBee repeater to improve
communication between the SolarEdge home gateway and a
SolarEdge inverter by placing the repeater between them (see
Figure 2).
The repeater is pre-configured as slave and will be discovered by the
device configured as master during device discovery.
Chapter 1: Introducing the SolarEdge ZigBee Repeater
ZigBee Repeater Installation Guide –MAN-01-00130-1.0
7
Figure 2: The SolarEdge ZigBee Repeater between the Home
Gateway and Inverter
Package Contents
ZigBee repeater with antenna
Power supply
This installation guide
Chapter 2: SolarEdge Repeater User Interfaces
ZigBee Repeater Installation Guide –MAN-01-00130-1.0
8
8
Chapter 2: SolarEdge Repeater
User Interfaces
The following interfaces are used in this product:
USB Connector - Connection to the power supply
LEDs - The repeater has four LED indicators, as follows:
Label and
Color
Indication
Functionality
S_OK
(green)
Communication
passing though this
device is received
by the SolarEdge
monitoring portal
ON - connection with
SolarEdge master device is
OK, and the master device is
connected to the server.
OFF - Communication with the
SolarEdge master device has
failed
Link
(yellow)
ZigBee RF
communication
with associated
master
ON - Connection with
SolarEdge master device is
OK.
OFF - Communication with the
SolarEdge master device has
failed
3x Signal
strength
(green)
Signal strength to
nearest ZigBee
device
(Low/Medium/High)
All 3 LEDs ON - High
Two LEDs ON - Medium
One LED ON - Low
Power
(green)
Power
Power supply connected to
the repeater
The other interfaces are not used in this product.
Otros manuales para ZigBee
3
Tabla de contenidos
Otros manuales de Reloj de repetición de SolarEdge
