SolarEdge SE-RGMTR-3D-208V-A Manual de usuario

Installation Guide

Revenue Grade Energy Meter

with Modbus Connection

For North America

Version 1.0

Disclaimers

Important Notice

No part of this document may be reproduced, stored in a

retrieval system or transmitted, in any form or by any means,

electronic, mechanical, photographic, magnetic or otherwise,

without the prior written permission of SolarEdge Inc.

The material furnished in this document is believed to be

accurate and reliable. However, SolarEdge assumes no

responsibility for the use of this material. SolarEdge reserves

the right to make changes to the material at any time and

without notice. You may refer to the SolarEdge web site

(https://www.solaredge.com/us/) for the most updated

version.

All company and brand products and service names are

trademarks or registered trademarks of their respective holders.

Patent marking notice: see

https://www.solaredge.com/us/patent

The general terms and conditions of delivery of SolarEdge shall

apply.

Revenue Grade Energy Meter with Modbus Connection Installation Guide MAN-01-00609-1.0

Disclaimers1

The content of these documents is continually reviewed and

amended, where necessary. However, discrepancies cannot be

excluded. No guarantee is made for the completeness of these

documents.

The images contained in this document are for illustrative

purposes only and may vary depending on product models.

FCC Compliance

This equipment has been tested and found to comply with the

limits for a Class B digital device, pursuant to part 15 of the FCC

Rules.

These limits are designed to provide reasonable protection

against harmful interference in a residential installation. This

equipment generates, uses and can radiate radio frequency

energy and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio

communications. However, there is no guarantee that

interference will not occur in a particular installation. If this

equipment does cause harmful interference to radio or

television reception, which can be determined by turning the

equipment off and on, you are encouraged to try to correct

the interference by one or more of the following measures:

Revenue Grade Energy Meter with Modbus Connection Installation Guide MAN-01-00609-1.0

2 FCC Compliance

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and the

receiver.

Connect the equipment into an outlet on a circuit different

from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician

for help.

Changes or modifications not expressly approved by the party

responsible for compliance may void the user’s authority to

operate the equipment.

Version History

Version 1.0 (July 2019) - Initial release

Revenue Grade Energy Meter with Modbus Connection Installation Guide MAN-01-00609-1.0

Disclaimers3

Support and Contact Information

If you have technical problems concerning SolarEdge

products, please contact us:

USA and Canada: 1 510 498 3200

Worldwide: +972 073 2403118

Fax: +1 (530) 273-2769

Email: ussupport@solaredge.com.

Support Center:

https://www.solaredge.com/us/service/support



Revenue Grade Energy Meter with Modbus Connection Installation Guide MAN-01-00609-1.0

4 Support and Contact Information

Before contact, make sure to have the following information at

hand:

Model and serial number of the product in question.

The error indicated on the Revenue Grade Energy Meter

with Modbus Connection SetApp mobile application LCD

screen or on the monitoring platform or by the LEDs, if

there is such an indication.

System configuration information, including the type and

number of modules connected and the number and

length of strings.

The communication method to the SolarEdge server, if the

site is connected.

The Revenue Grade Energy Meter with Modbus

Connection software version as appears in the ID status

screen.

Revenue Grade Energy Meter with Modbus Connection Installation Guide MAN-01-00609-1.0

Support and Contact Information5

Contents

Disclaimers 1

Important Notice 1

FCC Compliance 2

Support and Contact Information 4

Contents 6

HANDLING AND SAFETY INSTRUCTIONS 8

Safety Symbols Information 8

Chapter 1: Introduction 10

Terminology 10

The SolarEdge Revenue Grade Energy Meter with

Modbus Connection 12

Meter Connection Options 13

Meter Interfaces 15

Chapter 2: Meter Installation 19

Installation Guidelines 19

Installing and Connecting the Meter 20

Chapter 3: Configuration 28

SolarEdge Device Firmware Version 28

Device Configuration 31

Appendix A: Troubleshooting the Meter 45

Troubleshooting the Meter using SetApp 45

Troubleshooting the Meter using the Device Display 50

Appendix B: Installing Two Meters 55

Revenue Grade Energy Meter with Modbus Connection Installation Guide MAN-01-00609-1.0

6 Contents

Connecting Two Meters 55

Configuring the Dual-Meter Connection 57

Verifying Meter Connection 62

Troubleshooting Dual-Meter Connection 64

Appendix C: Monitoring Platform - Meter Data 66

Appendix D: External Lightning Protection 68

Revenue Grade Energy Meter with Modbus Connection Installation Guide MAN-01-00609-1.0

Contents7

HANDLING AND SAFETY

INSTRUCTIONS

During installation, testing and inspection, adherence to all the

handling and safety instructions is mandatory. Failure to do so

may result in injury or loss of life and damage to the

equipment.

Safety Symbols Information

The following safety symbols are used in this document.

Familiarize yourself with the symbols and their meaning before

installing or operating the system.

WARNING!

Denotes a hazard. It calls attention to a procedure

that, if not correctly performed or adhered to, could

result in injury or loss of life. Do not proceed beyond a

warning note until the indicated conditions are fully

understood and met.

AVERTISSEMENT!

Dénote un risque: il attire l'attention sur une opération

qui, si elle n'est pas faite ou suivi correctement,

pourrait causer des blessures ou un danger de mort.

Ne pas dépasser une telle note avant que les

conditions requises soient totallement comprises et

accomplies.

Revenue Grade Energy Meter with Modbus Connection Installation Guide MAN-01-00609-1.0

8 HANDLING AND SAFETY INSTRUCTIONS

CAUTION!

Denotes a hazard. It calls attention to a procedure

that, if not correctly performed or adhered to, could

result in damage or destruction of the product. Do

not proceed beyond a caution sign until the indicated

conditions are fully understood and met.

ATTENTION!

Dénote un risque: il attire l'attention sur une opération

qui, si elle n'est pas faite ou suivi correctement,

pourrait causer un dommage ou destruction de

l'équipement. Ne pas dépasser une telle note avant

que les conditions requises soient totallement

comprises et accomplies.

NOTE

Denotes additional information about the current

subject.

IMPORTANTSAFETYFEATURE

Denotes information about safety issues.

Revenue Grade Energy Meter with Modbus Connection Installation Guide MAN-01-00609-1.0

HANDLING AND SAFETY INSTRUCTIONS9

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Instrumento de medición de SolarEdge

SolarEdge

SolarEdge SE330K Instrucciones de instalación y funcionamiento

SolarEdge

SolarEdge RGM Instrucciones de funcionamiento

SolarEdge

SolarEdge SE-MTR-3Y-400V-A Manual de usuario

SolarEdge

SolarEdge SolarEdge SE-MTR240-2-400-S1 Manual de usuario

SolarEdge

SolarEdge SE-WND-3Y400-MB-K2 Manual de usuario

SolarEdge

SolarEdge MTR-240-3PC1-D-A-MW Manual de usuario

SolarEdge

SolarEdge SE-MTR240-NN-S-S1 Manual de usuario

SolarEdge

SolarEdge AS4034-1 Manual de usuario

Manuales populares de Instrumento de medición de otras marcas

Suaoki

Suaoki D40 Manual de usuario

Elster

Elster BK-G1.6 Manual de usuario

Endress+Hauser

Endress+Hauser Deltabar FMD71 Manual

Duratool

Duratool D03128 Manual de usuario

Vega

Vega VEGAPULS 65 Manual de usuario

Tonghui

Tonghui TH2618B Manual de usuario

Tenmars

Tenmars TM-801 Manual de usuario

MSR

MSR 145 Manual de usuario

TPS

TPS WP-82 Manual de usuario

ELMETRON

ELMETRON CP-511 Manual de usuario

PCB Piezotronics

PCB Piezotronics 003C30 Manual de usuario

Tenma

Tenma 72-10465 Manual de usuario

Endress+Hauser

Endress+Hauser Proline Promag 50 Especificaciones técnicas

Siemens

Siemens SITRANS F Coriolis FCT030 Manual de lista de piezas

KLINGER

KLINGER CMF V Series Manual de usuario

EXFO

EXFO FTB-2 Manual de operación y mantenimiento

Keysight

Keysight M8290A Manual de usuario

ADTEK

ADTEK MW-5 Manual de usuario