Smith's Heating First Caspian 60 Manual de operación

Caspian 60, 90 & 120 Series

Fan Convector

Installation & User Guide

Dear Installer,

Than you for installing our products, we hope it gives many years of service;

In the event of items missing or visible damage please contact our After Sales Service on

01245 324560.

We would be most grateful if you would leave this Installation & User Guide and the

Guarantee Registration Card with the owner.

Than you for your co-operation

Steve Russell

Customer Service Manager

Introduction

These heaters are primarily intended for installation directly onto a wall at low level. We

recommend that this heater is stood on the floor and fixed to the wall. They must not be

installed in bathrooms or other high humidity areas. Please contact us on 01245 324900 for

details of products suitable for these applications.

These heaters are designed for use on standard two-pipe pumped central heating systems

with a maximum water temperature of 86°C and a maximum pressure of 6 bar (88lbs/in2).

Pipes are 22mm depending on model and either pipe may be used as flow or return.

These heaters are classified as a fixed appliance and electrical connection should be via a

3A-fused spur. The fused spur must not be directly above the heater but should be

accessible after completion of the installation. All heaters must be earthed.

We recommend the use of full-flow isolating valves. The valves should be accessible after

completion of the installation.

To avoid the possibility of vibration these units must be fitted on a flat even surface.

To conform to Building Regulations Part L (part J in Scotland), a remote room thermostat

can be used in conjunction with this heater. Refer to the instructions supplied with the

thermostat. For further details please contact our Technical Support on 01245 324560.

Please note the guarantee may be invalidated if this product is not installed and used in

accordance with these instructions.

Installation Guide

1. Remove the front access cover using a small coin

2. Fix the product to the wall using appropriate fixings for the wall type. Refer to the

diagram & table below for the fixing-hole positions.

3. Connect the heating system flow and return pipes to the heater pipe wor . Do not use

soldered fittings to the heater pipe wor as the heat generated could damage internal

wiring and components.

Note: We recommend the use of full flow service valves. The valves should be accessible after

completion of the installation.

4. Chec for water lea s. Remove any trapped air from the unit via the built in bleed screw

located as shown in the diagram below.

5. Isolate the electrical supply and connect the heater electric cable to the fused spur (3

amp). The fused spur must not be directly above the heater and must be accessible after

the installation is complete.

3 AMP FUSED SPUR

6. Fit a thermostat if required. There is a connection facility within the heater. Remove lin

and attach wires to terminals 6 and 7 as diagram below.

L N

E E

N L

TO FAN FROM MAINS

1 2 3 4 5 6 7 8

Commissioning

1. Turn on the electrical supply at the fused spur

2. Turn the thermostat control (if fitted) to maximum.

3. Turn on the central heating system

4. Turn on the heater – see User Guide.

5. If these heaters are installed on the same circuit as panel radiators balance the central

heating system

6. If the installation is wor ing correctly remember to reset the thermostat control (if fitted)

to its normal setting

Installation Continued

7. Replace the front access cover

8. Please leave this Installation & User Guide with the user for future reference

Heat Output Performance

Model

Heat

Output

kW)

Heat

Output

kW)

Heat

Output

kW)

High Medium Low

Caspian 60/03 3.4 3.2 2.9

Caspian 60/04 4.6 4.1 3.6

Caspian 90/06 6.7 6.2 5.6

Caspian 90/07 7.8 7.0 6.3

Caspian 120/10 11.4 10.4 8.6

Caspian 120/11 12.2 11.4 9.5

Caspian 120/12 13.1 12.2 10.4

75C inlet water temperature, 18C entering air

temperature

It is recommended that these models are capable of maintaining the calculated heat loss at

medium heat output enabling the boost setting to be used for faster heat up and the low

speed for maintaining temperature.

Fault Finding

1. Fan does not run on any switch setting.

a. Chec the power supply is switched ON.

b. Chec fuse in the fused spur.

c. Chec the wiring connections at the fused spur.

2. No heat output.

a. Vent any trapped air from the system (with the heating system turned OFF).

b. Chec the central heating is switched ON.

c. If a thermostat is fitted ensure it is calling for heat.

d. Balance the central heating system if installed on the same circuit as panel

radiators and increase the circulating pump speed if required.

e. Increase the boiler water temperature.

In the event of difficulty please contact our technical help-line on 01245 324560. It will be

helpful if you do not disconnect the heater from the central heating system.

Smith's Environmental Products Ltd.,

Blac all Industrial Estate, South Woodham Ferrers, Chelmsford, Essex CM3 5UW

Tel: 01245 324900 After Sales: 01245 324560 Fax: 01245 324422

E-mail: info@smiths-env.com Web: www.smiths-env.com

In light of our policy of continuous development Smith’s Environmental Products Ltd reserve the right to alter specifications without prior

notice.

Caspian

Fan Convector

User Guide

Dear Customer

We are delighted you have chosen our products and trust you are satisfied with the

installation. We would as you to ta e a few minutes to read through this User Guide. This

will help you gain maximum benefit from your heater.

As with all our products your heater is covered by a free five-year parts & labour guarantee

and we would be grateful if you complete and return the Guarantee Registration Card to us

as soon as possible. This will ensure that should you require assistance we can help you

quic ly and efficiently.

Than you for your co-operation.

Steve Russell

Customer Service Manager

01245 324900

Your fan convector is designed to operate as part of your central heating system in the

same way as a panel radiator. Providing you leave the heat output switch in either the low,

medium or boost position it will switch on and off automatically with your central heating

system.

How a fan convector works

Hot water from your central heating

system passes through the heat exchanger

transferring its heat to the aluminium

fins. Cooler air is drawn in by the fan and

heated as it passes over the heat

exchanger before being expelled gently

bac into the room. This not only gives a

more even temperature spread but will

heat a room up in less than half the time

of a traditional steel panel radiator.

Fan convectors include an internal water temperature thermostat that prevents the fan

from operating until the central heating system water passing through the heat exchanger

reaches 42ºC. This prevents cooler air being circulated at start up.

Heating - see diagram

Ensure your central heating system is ON. Switch on the heater (the neon switch will

illuminate). Set the thermostat control (if fitted) to the desired temperature. Set the

heat-output switch to medium output setting. Providing the water temperature in the

central heating system is more than 42ºC and the thermostat (if fitted) is calling for heat

the product will switch on. If you require a faster warm up move the heat output switch to

boost. When the room reaches the desired temperature you may move the heat-output

switch to low.

LOW

MEDIUM

BOOST

OFF

Fault Finding

This heater is covered by a free five-year parts & labour guarantee. In the event of

difficulty please contact our After Sales Service on 01245 324560. It will be helpful if you

do not disconnect the heater from the central heating system.

Smith's Environmental Products Ltd.,

Blac all Industrial Estate, South Woodham Ferrers, Chelmsford, Essex CM3 5UW

Tel: 01245 324900 After Sales: 01245 324560 Fax: 01245 324422

E-mail: info@smiths-env.com Web: www.smiths-env.com

In light of our policy of continuous development Smith’s Environmental Products Ltd reserve the right to alter

specifications without prior notice.

04-1117 Aug 07

Este manual sirve para los siguientes modelos

Tabla de contenidos

Otros manuales de Calentador de Smith's Heating First

Smith's Heating First

Smith's Heating First SS2E/5 Manual de usuario

Smith's Heating First

Smith's Heating First Caspian 60 Manual de operación

Smith's Heating First

Smith's Heating First ECOVECTOR LL 1200 Manual de operación

Smith's Heating First

Smith's Heating First SS3E Manual de usuario

Smith's Heating First

Smith's Heating First Caspian EC Series Guía

Smith's Heating First

Smith's Heating First SS5/Dual Manual de usuario

Smith's Heating First

Smith's Heating First PWU 4/6 Manual de operación

Smith's Heating First

Smith's Heating First Caspian 60 Manual de operación

Smith's Heating First

Smith's Heating First Eco-Powerad 500 Manual de operación

Smith's Heating First

Smith's Heating First Solano Guía

Smith's Heating First

Smith's Heating First STR7-12V Manual de usuario

Smith's Heating First

Smith's Heating First Space saver SS7 Manual de usuario

Smith's Heating First

Smith's Heating First Ostro Guía

Smith's Heating First

Smith's Heating First Sterling 3 EL Manual de operación

Smith's Heating First

Smith's Heating First External Control Harness Caspian UVC Manual de usuario

Smith's Heating First

Smith's Heating First Signature Manual de operación

Smith's Heating First

Smith's Heating First SS80E Manual de usuario

Smith's Heating First

Smith's Heating First PROFILE Series Manual de usuario

Manuales populares de Calentador de otras marcas

oventrop

oventrop Regucor Series Manual de usuario

Blaze King

Blaze King CLARITY CL2118.IPI.1 Manual de usuario

ELMEKO

ELMEKO ML 150 Manual de usuario

BN Thermic

BN Thermic 830T Manual de usuario

KING

KING K Series Guía

Empire Comfort Systems

Empire Comfort Systems RH-50-5 Guía de inicio rápido

Well Straler

Well Straler RC-16B Manual de usuario

EUROM

EUROM 333299 Manual de usuario

Heylo

Heylo K 170 Manual de usuario

Eterna

Eterna TR70W Manual de usuario

Clarke

Clarke GRH15 Manual de instrucciones

IRSAP

IRSAP The Radiator Company Ovali Manual de usuario

Empire Heating Systems

Empire Heating Systems WCC65 Manual de usuario

Wetekom

Wetekom 92 86 43 Manual de usuario

Desa

Desa SPC170-F Manual de usuario

Watlow

Watlow Watrod Electric Tubular Heaters Manual de usuario

Haverland

Haverland ECO-DRY GPS Series Manual de lista de piezas

Stelpro

Stelpro ASILVC2060 Series Manual de usuario