Smeg 910TB124 Manual de usuario

Contents

1. INSTRUCTIONS FOR SAFE AND PROPER USE_______________ 29

2. INSTALLATION _________________________________________ 31

3. DESCRIPTION OF CONTROLS ____________________________ 35

4. USE OF THE OVEN______________________________________ 41

5. AVAILABLE ACCESSORIES _______________________________ 42

6. COOKING HINTS________________________________________ 43

7. CLEANING AND MAINTENANCE ___________________________ 49

8. ADDITIONAL MAINTENANCE ______________________________ 51

INSTRUCTIONS FOR THE INSTALLER: these are intended for the

qualified technician who must install the appliance, set it functioning

and carry out an inspection test.

INSTRUCTIONS FOR THE USER: these contain user advice,

description of the controls and the correct procedures for cleaning and

maintenance of the appliance.

Introduction

1. INSTRUCTIONS FOR SAFE AND PROPER USE

THIS MANUAL IS AN INTEGRAL PART OF THE APPLIANCE AND

THEREFORE MUST BE KEPT IN ITS ENTIRETY AND IN AN ACCESSIBLE

PLACE FOR THE WHOLE WORKING LIFE OF THE OVEN. WE ADVISE

CAREFUL READING OF THIS MANUAL AND ALL THE INSTRUCTIONS

THEREIN BEFORE USING THE OVEN. INSTALLATION MUST BE CARRIED

OUT BY QUALIFIED PERSONNEL IN ACCORDANCE WITH THE

REGULATIONS IN FORCE. THIS APPLIANCE IS INTENDED FOR DOMESTIC

USES AND CONFORMS TO CURRENT REGULATIONS IN FORCE. THE

APPLIANCE HAS BEEN BUILT TO CARRY OUT THE FOLLOWING

FUNCTIONS: COOKING AND HEATING-UP OF FOOD. ALL OTHER USES

ARE CONSIDERED IMPROPER.

THE MANUFACTURER DECLINES ALL RESPONSIBILITY FOR IMPROPER

USE.

DO NOT LEAVE THE PACKING IN THE HOME ENVIRONMENT. SEPARATE

THE VARIOUS WASTE MATERIALS AND TAKE THEM TO THE NEAREST

SPECIAL GARBAGE COLLECTION CENTRE.

IT IS OBLIGATORY FOR THE ELECTRICAL SYSTEM TO BE EARTHED

ACCORDING TO THE METHODS REQUIRED BY SAFETY RULES.

WHEN LINKING UP TO MAINS BY PLUG AND SOCKET, MAKE SURE THAT

BOTH ARE COMPATIBLE AND CONNECT BY MEANS OF A POWER CABLE

COMPLYING WITH APPLICABLE REGULATIONS.

THE SOCKET MUST BE ACCESSIBLE AFTER THE APPLIANCE HAS BEEN

BUILT IN.

NEVER UNPLUG BY PULLING ON THE CABLE.

DO NOT OBSTRUCT VENTILATION OUTLETS AND HEAT DISPERSAL SLITS.

IMMEDIATELY AFTER INSTALLATION CARRY OUT A BRIEF INSPECTION

TEST OF THE OVEN, FOLLOWING THE INSTRUCTIONS BELOW. SHOULD

THE APPLIANCE NOT FUNCTION, DISCONNECT IT FROM THE SUPPLY AND

CALL THE NEAREST TECHNICAL ASSISTANCE CENTRE.

NEVER ATTEMPT TO REPAIR THE APPLIANCE.

ALWAYS CHECK THAT THE CONTROL KNOBS ARE IN THE “ZERO” (OFF)

POSITION WHEN YOU FINISH USING THE OVEN.

Introduction

NEVER PUT INFLAMMABLE OBJECTS IN THE OVEN: THEY COULD BE

ACCIDENTALLY CATCH LIGHT AND CAUSE FIRES.

DURING USE THE APPLIANCE BECOMES VERY HOT. TAKE CARE NOT TO

TOUCH THE HEATING ELEMENTS INSIDE THE OVEN.

THE I.D. PLATE WITH TECHNICAL DATA, REGISTRATION NUMBER AND

BRAND NAME IS POSITIONED VISIBLY ON THE OVEN DOOR FRAME.

THE PLATE MUST NOT BE REMOVED.

THE OVEN IS DESIGNED FOR USE BY ADULTS. DO NOT ALLOW CHILDREN

TO GO NEAR OR PLAY WITH IT.

THIS APPLIANCE IS MARKED ACCORDING TO THE EUROPEAN DIRECTIVE

2002/96/EC ON WASTE ELECTRICAL AND ELECTRONIC EQUIPMENT

(WEEE).

THIS GUIDELINE IS THE FRAME OF A EUROPEAN-WIDE VALIDITY OF

RETURN AND RECYCLING ON WASTE ELECTRICAL AND ELECTRONIC

EQUIPMENT.

BEFORE THE APPLIANCE IS PUT INTO OPERATION, ALL THE LABELS AND

PROTECTIVE FILMS APPLIED INSIDE OR OUTSIDE MUST BE REMOVED.

The manufacturer declines all responsibility for damage to persons

or things caused by non-observance of the above guidelines or by

interference with any part of the appliance or by the use of non-original

spares.

Instructions for the installer

2. INSTALLATION

2.1 Electrical connection

Check that the mains voltage and power cable ratings are as per the

information provided on the label attached to the oven door frame.

This label must never be removed.

It is obligatory for the electrical system to be earthed according to the

methods required by safety rules.

If a plug and socket connection is being used make sure that the plug

and socket are compatible. Avoid use of adapters and shunts as these

could cause overheating and risk of burns.

If a fixed connection is being used fit cable with an omnipolar circuit

breaker with a contact opening gap equal to or greater than 3 mm in an

easily accessible position near to the oven.

For operation on 230V

∼

:use an H05RR-F

/ H05RN-F type three-core cable (3 x 1.5

mm2).

The cable end to be connected to the

appliance must be provided with an ground

wire (yellow-green) at least 20 mm longer.

2.1.1 Ovens with hob controls

In the ovens with hob controls the power cable is not supplied. Use a

H05RR-F or H05RN-F rubber-sheathed cable making sure that it does

not come into contact with any external metal parts of the oven when

routing.

Remove rear cover by loosening relevant screws to gain access to the

terminal strip. If necessary change jumper configuration as shown in the

diagram and then connect wires making sure that the earth wire is at

least 20 mm longer than the others. Secure power cable to oven by

means of an appropriate fitting.

Instructions for the installer

For operation on 220-240V

∼

:use an

H05RR-F / H05RN-F type three-core cable

(3 x 4 m2).

For operation on 380-415V2N

∼

:use an

H05RR-F / H05RN-F type four-core cable

(4 x 2.5 mm2).

For operation on 380-415V3N

∼

:use an

H05RRF / H05RN-F type five-core cable

(5 x 1.5 mm2).

The cable end to be connected to the

appliance must be provided with an ground

wire (yellow-green) at least 20 mm longer.

Instructions for the installer

2.2 Installing the oven

The oven is designed for installation into any piece of furniture as long as

it is heat-resistant. Proceed according to the dimensions shown in

Figures 1, 2and 3. For installing under a work top, follow the dimensions

given in Figure 1-3. For installing under a work top beneath a hob with

controls connected to the oven, ensure a minimum clearance from any

side walls of at least 110 mm as shown in Figure 1.

For installing in a column, follow the dimensions given in Figure 1-2

allowing for a clearance of 80 to 90 mm at the top and sides of the

column. Tighten the four screws Ainside the frame to secure (Fig. 1).

For installing beneath a separate hob, allow for a rear and bottom

clearance as shown in Figure 1(ref. B). See relevant instructions for

fitting and securing the hob.

Instructions for the installer

Never use the oven door to lever the oven into

place when fitting.

Avoid exerting too much pressure on the oven door

when open.

2.3 Connecting the hob to the oven

Once installed, the hob must be connected to the oven. Install the oven

allowing enough room for the following operations to take place.

•Connect the earth wire (yellow-green) of the hob to the earth terminal

Aof the oven (see figure).

•Fit the hob connectors into the appropriate sockets in the top cover

of the oven. Make sure that the colours and symbols of the

connectors match those of the oven sockets.

•If the hob is equipped with a connector for the residual heat indicator,

this must be fitted into the free socket on the right handside.

The oven can now be fully mounted into the cabinet; make sure that the

power cable is properly routed and does not come into contact with parts

which may become hot during operation.

Instructions for the user

3. DESCRIPTION OF CONTROLS

3.1 Front control panel

All the oven controls are grouped together on the front panel.

STATIC MODEL

5- FUNCTION MODEL

6- FUNCTION MODEL

8- FUNCTION MODEL

6-FUNCTIONS MODEL + HOB CONTROLS

Instructions for the user

FUNCTION CONTROL KNOB

(static oven)

Cooking temperature is selected by turning the

knob clockwise to the desired setting, between

50° and 250°C.

This knob allows selection of either the

bottom( ) or top (grill) ( ) heating element.

A further symbol at end of knob rotation permits to turn on the spit

motor and the top grill heating element.

FUNCTION CONTROL KNOB

Rotate the knob in either direction to select desired function from the

following:

NO FUNCTION SET

LOWER HEATING ELEMENT +

VENTILATION

OVEN LIGHT (NO

ELEMENT ENGAGED)

GRILL ELEMENT + VENTILATION

UPPER AND LOWER

HEATING ELEMENT

UPPER AND LOWER HEATING

ELEMENT + VENTILATION

LOWER

HEATING ELEMENT

VENTILATED HEATING ELEMENT

GRILL ELEMENT

VENTILATED HEATING ELEMENT

WIDE GRILL

ELEMENT

UPPER AND LOWER HEATING

ELEMENT + VENTILATED HEATING

ELEMENT

DEFROSTING

Instructions for the user

THERMOSTAT KNOB

(multifunction oven)

Cooking temperature is selected by

turning the knob clockwise to the desired

setting, between 50° and 250°C.

HOB CONTROL KNOB

Used to control the temperature on the hob. Rotate

clockwise to set to desired value (2to 12).

HOB CONTROL KNOB

WITH DUAL ZONES

Used to select heating zone in plates

with dual heating zones.

Rotating the knob clockwise from

between 2to 12 heats the inner zone

within the small diameter.

Setting knob to or and releasing it (knob returns to 12) causes both

zones to be heated. To adjust heat intensity, turn the knob anticlockwise

to the desired value.

To return to heating inside the inner zone only, set knob first to 0and

then to any value between 2and 12 as desired.

THERMOSTAT INDICATOR LIGHT

When this light comes on, the oven is heating up.

When this light goes out, the preset heating

temperature has been reached.

When the light flashes, the temperature inside the

oven is steady at the set temperature.

Este manual sirve para los siguientes modelos

100

Tabla de contenidos

Otros manuales de Horno de Smeg

Smeg

Smeg DUSF6300X Manual de usuario

Smeg

Smeg Free-standing Fan Oven 100.700 Instrucciones de montaje

Smeg

Smeg SC45VK Manual de usuario

Smeg

Smeg Built-in Microwave Oven Manual técnico

Smeg

Smeg Oven Manual de instrucciones

Smeg

Smeg JRP30GIBB Manual de usuario

Smeg

Smeg SA109-8 Manual de usuario

Smeg

Smeg SE995XT-5 Manual de usuario

Smeg

Smeg SOP6302TX Manual de usuario

Smeg

Smeg SF4303WMCX Manual de usuario

Smeg

Smeg SF750AS Manual de usuario

Smeg

Smeg Linea SFA6101TVB Manual de usuario

Smeg

Smeg SFA9315XR Manual de usuario

Smeg

Smeg SCA706X Manual de usuario

Smeg

Smeg SA240X-5 Manual de usuario

Smeg

Smeg ALFA135BM Manual de usuario

Smeg

Smeg Commercial Oven ALFA41UK Manual de usuario

Smeg

Smeg Oven Manual de usuario

Smeg

Smeg Four Oven Manual del sistema

Smeg

Smeg 9FAGON Manual de usuario

Smeg

Smeg SFA4140VC1 Manual de usuario

Smeg

Smeg SFA562X2 Manual de usuario

Smeg

Smeg SFP6390XE Manual de usuario

Smeg

Smeg SF7390X Manual de usuario

Manuales populares de Horno de otras marcas

Bosch

Bosch HVA531NS0 Manual de usuario

Electrolux

Electrolux EOF6P46X Manual de usuario

NEFF

NEFF B44S32 5GB Series Manual de usuario

Combi

Combi BLODGETT BC142GDS Manual de usuario

AEG

AEG COMPETENCE 311704300 Manual de usuario

Falcon

Falcon DOMINATOR PLUS G3106 Series Guía del usuario

Rational

Rational SCC WE 61G Manual de usuario

Electrolux

Electrolux air-o-convect 20 GN 2/1 Manual de usuario

Miele

Miele HR 1954-2 Manual de usuario

KHIND

KHIND OT50 Manual de usuario

Henny Penny

Henny Penny Smoker Box Manual de usuario

Lang

Lang ECOD-AP Manual de usuario

AEG

AEG BEK455310M Manual de usuario

Frigidaire

Frigidaire FNGE90JGR Manual de usuario

Hotpoint

Hotpoint FE9 S831 JSH IX Manual de usuario

GE Advantium SCB2000 Manual de usuario

AEG

AEG DE401301DM Manual de usuario

DeLonghi

DeLonghi XA660 Manual