Smartech UltraTec-8000 Manual de usuario

User Guide
Guía del usuario
Rechargeable LED Flashlight / Portable Power
Bank / Jump Starter
Model/Modelo: UltraTec-8000
LUMEN OUTPUT: 8000
PEAK STARTING CURRENT: 500 Amps
USB OUTPUT: (2)x5V/2.4A
BATTERY CAPACITY: 10000mAh
FULLY CHARGE IMMEDIATELY AFTER PURCHASE.
Fully recharge after each jumpstarting, or every 3 months to ensure
long battery life.
ILLUMINATE • POWER • CHARGE • JUMP

USER GUIDE PAGE 2ULTRATEC-8000
DANGER
Please read and understand all important
safety and operating instructions before
using this charger. In addition, please
read and follow all battery and vehicle
manufacturer’s instructions and
cautionary markings. Failure to follow the
instructions may result in ELECTRICAL
SHOCK, EXPLOSION, or FIRE, which
may result in SERIOUS INJURY, DEATH,
DAMAGE TO DEVICE or PROPERTY. Do
not discard this information.
This operating manual has been designed to instruct you on the correct
use and operation of your product. Your satisfaction with this product and
its safe operation is our ultimate concern. Therefore please take the time to
read the entire manual, especially the Safety Precautions. They will help you
to avoid potential hazards that may exist when working with this product.
RISK OF EXPLOSIVE GASES
WORKING IN THE VICINITY OF A LEAD-ACID BATTERY
IS DANGEROUS. BATTERIES GENERATE EXPLOSIVE GASES
DURING NORMAL BATTERY OPERATION. FOR THIS REASON,
IT IS OF UTMOST IMPORTANCE THAT YOU FOLLOW THE
INSTRUCTIONS EACH TIME YOU USE THE CHARGER.
To reduce risk of battery explosion, follow these instructions and those
published by battery manufacturer and manufacturer of any equipment
intended to be used in vicinity of battery. Review cautionary marking on these
products and on engine.

USER GUIDE PAGE 3ULTRATEC-8000
SAFETY INFORMATION
Please read this entire manual before using this product.
1. Avoid dangerous environments. Do not charge this item in rain,
snow, damp or wet environments.
2. Do not use this item or charger in the presence of explosive
atmospheres (gaseous fumes, dust or ammable materials) since
sparks may be generated when attaching or removing this item,
possibly causing re.
3. Charge in a well-ventilated area. Do not allow smoking or open ames
near a charging battery. Vented gases may explode.
4. Do not burn or incinerate this item. This item may explode, causing
personal injury or damage. Toxic fumes and materials are created
when batteries are burned.
5. Do not crush, drop or damage this item.
6. Do not use this item or a battery charger that has received a sharp
blow, been dropped, run over or damaged in any way (e.g. pierced with
a nail, hit with a hammer or stepped on).
7. WARNING: Do not disassemble. Disassembly may result in the risk of
electric shock, re or exposure to battery chemicals.
8. Battery chemicals cause serious burns. Never allow contact with skin,
eyes or mouth. If this item leaks battery chemicals, use rubber or
neoprene gloves to dispose of it. If skin is exposed to battery uids,
wash with soap and water and rinse with vinegar. If eyes are exposed
to battery chemicals, immediately ush with water for 20 minutes and
seek medical attention. Remove and dispose of contaminated clothing.
9. Do not short circuit. This item will short circuit if a metal object makes
connection to the power cable port. Do not place this item near
anything that may cause a short circuit, such as coins, keys or nails. A
shortcircuited battery may cause re and personal injury.
10. When jump starting your vehicle do not place Jump Starter on the
ground or at a height less than 18 inches.
11. Never charge or jump start a frozen battery. Store this item and
charger in a cool dry place.

USER GUIDE PAGE 4ULTRATEC-8000
SAFETY INFORMATION (continued)
12. Do not store this unit for more than 10 days where temperatures may
exceed 120 Degrees F (50 Degrees C) such as direct sunlight, a
vehicle, or metal building during the summer as it may cause damage
to the unit.
13. This product is intended for private use only and should not be used
in any commercial applications. Use of this product to start multiple
vehicles over a short period of time may damage the jump starter/
charger.
14. WARNING: Before attempting to start a vehicle, be sure the blue plug
of the Smart Jumper Cables is rmly secured into the Smart Jumper
Cable Input Socket and be sure that the battery clamps have a good
connection with the proper battery terminals. Clean rusted or dirty
terminals before attempting to jumpstart the vehicle.
15. WARNING: Remove the jump starter from the vehicle battery within 30
seconds of successfully restarting. To do so, remove the Smart Jumper
Cables from the Jump Starter. Then remove the Smart Jumper Cables
from the battery terminals.
16. WARNING: Only use the provided charging cords with this product
17. WARNING: Disposal of this Device. This device contains a non-
replaceable Lithium Polymer battery. It is not user replaceable. Battery
must be disposed of properly when it no longer holds a charge. This
product should be recycled or disposed of as per state and local
guidelines.
18. WARNING: This product is not a toy and is not intended for use by
children.
19. PROPOSITION 65 WARNING: This Product contains chemicals
known to the State of California to cause cancer and birth defects
or other reproductive harm (California law requires this warning to
be given to customers in the State of California). Wash hands after
handling.

USER GUIDE PAGE 5ULTRATEC-8000
Features 8000 lumen recharable LED ashlight with 10000mAh
power bank with Built-In jump starter function. The jump starter
features: Spark Proof Protection, Reverse Polarity Protection, Short
Circut Protection, Over Current Protection, Over Discharge Protec-
tion, Over Charge Protection, Self Discharging Protection and Over
Heat Protection. This product can instantly jump start most single
battery vehicles, up to 24+ (over 24) times on a full charge. This
product is also equipped with 2 USB power output ports to power/
charge USB devices.
ABOUT THE ULTRATEC-8000

USER GUIDE PAGE 6ULTRATEC-8000

USER GUIDE PAGE 7ULTRATEC-8000
Battery Type Lithium-ion Polymer
Battery Capacity 10000mAh Rechargeable
Starting Current 200A
Peak Current 500A
Jump Start Gas Engine Up to 4.0L
Jump Start Diesel Engine Up to 3.0L
USB Output (2) 5V/2.4A, 5V/2.4A
LED Flashlight 8000 Lumens Max. Brightness
Light Modes 6 - Turbo/High/Medium/Low/Strobe/
SOS
Turbo Brightness 8000 Lumens
High Brightness 3000 Lumens
Medium Brightness 1500 Lumens
Low Brightness 150 Lumens
Operating Temperature -22°F - +122°F
Charging Temperature 32°F - +104°F
Storage Temperature -22°F - +122°F (For 3 months)
TECHNICAL SPECIFICATIONS
Flashlight Specications:
Brightness
in Lumens
Beam
Distance
Hours of
Operation

USER GUIDE PAGE 8ULTRATEC-8000
CHARGING THE ULTRATEC-8000
Option 1: Home Charging
To charge the UltraTec-8000, plug the USB C to USB charging
cable into the back of the UltraTec-8000 ashlight. Plug the other
end of the cable into the wall charger adaptor. Plug the wall charger
adaptor into a wall outlet. There are 4 blue LED charging indicators
that will show the charging status of the UltraTec-8000.
See image below:

USER GUIDE PAGE 9ULTRATEC-8000
Option 2: Car Charging
To charge the UltraTec-8000 from your car, plug the USB C to
USB charging cable into the back of the UltraTec-8000 ashlight.
Plug the other end of the cable into the 12V to USB adaptor.
Plug the USB adaptor into the car cigarette lighter socket power
outlet. There are 4 blue LED charging indicators that will show the
charging status of the UltraTec-8000.
See image below:
USB C TO USB
CHARGING CABLE
USB C
CHARGING
PORT
12V TO USB
ADAPTOR

USER GUIDE PAGE 10ULTRATEC-8000
The UltraTec-8000 has 6 light modes.
1. Turbo (highest brightness)
2. High
3. Medium
4. Low
5. Strobe
6. S.O.S
To turn on the ashlight, press the round power button. Press the
power button repeatedly to cycle through the High/Medium/Low/
Strobe/S.O.S. modes.
Quick Access:
Double click to Strobe mode. One more click to S.O.S mode.
To turn on “Turbo” mode: From any mode (including OFF), press
and hold the power button for 1 second.
See image below:
Quick Access:
Double click to Strobe mode, one more click to S.O.S mode
POWER BUTTON
6 LIGHT MODES
TURBO MODE:
Press repeatedly to cycle through
the following modes:
• High
• Medium
• Low
• Strobe
• S.O.S.
Press and hold for 1 second to turn flashlight
on in Turbo mode:
USING THE LED FLASHLIGHT
Tabla de contenidos
Otros manuales de Arranque remoto de Smartech

Smartech
Smartech GSK-8000 Manual de usuario

Smartech
Smartech GSK-6000 Manual de usuario

Smartech
Smartech JS-15000N Manual de usuario

Smartech
Smartech JS-8000N Manual de usuario

Smartech
Smartech JSL-1250 Manual de usuario

Smartech
Smartech GSK-10000 Manual de usuario

Smartech
Smartech JSL-950 Manual de usuario

Smartech
Smartech SBC-125 Manual de usuario

















