SMART Embedded Computing MVME3100 Manual de usuario

1 Box contents

Make sure you receive all items of your shipment:

• MVME3100 board

• One printed copy of Quick Start Guide (this document)

• One printed copy of Safety Notes Summary

When installing or servicing the system or accessories,

strictly observe the safety precautions in the Safety Notes

Summary. Ignoring these instructions can void the system

warranty and cause personal injury or property damage.

2 ESD

Electrostatic discharge and incorrect installation or

removal of the card can damage circuit or shorten its life.

Use a properly grounded ESD wrist strap or work in an

ESD-safe environment.

Connect to the ESD connector at the front or the rear of

the system.

3 Site preparation

1. Make sure that all environmental and power requirements

defined in the MVME3100 Installation and Use manual are

met.

2. Remove all items from the box.

4 Configure Hardware

To produce the desired configuration and ensure proper operation of

the MVME3100, you may need to carry out certain hardware

modifications before installing the module. For more information,

refer to the MVME3100 Installation and Use.

5 Install the Board

Note: Before removing the housing cover make sure that the

system is shut down and disconnected from AC power.

1. Attach an ESD strap to your wrist.

2. Attach the other end of the ESD strap to an electrical ground.

The ESD strap must be secured to your wrist and to ground

throughout the procedure.

3. Remove any filler panel that might fill the slot.

4. Install the top and bottom edge of the MVME3100 into the guides

of the chassis.

5. Make sure the levers of the two injector/ejectors are in the

outward position.

6. Slide the MVME3100 into the chassis until you feel resistance.

7. Simultaneously move the injector/ejector levers in an inward

direction.

8. Verify that the MVME3100 is properly seated.

9. Secure the board to the chassis using the two screws located

adjacent to the injector/ejector levers.

10.Connect the appropriate cables to the MVME3100.

11.When the MVME3100 is installed in the chassis you are ready to

connect peripherals.

6 Connect Peripherals

The following table lists the available connectors on MVME3100.

MVME3100 Single

Board Computer

Quick Start Guide

P/N: 6806800M29C September 2019

Connector Function

J4 PMC expansion connector

J11, J12, J13, J14 PCI mezzanine card (PMC) slot 1 connector

J21, J22, J23 PCI mezzanine card (PMC) slot 2 connector

J24 Boundary scan header

J25 COP header

J27 USB connector

J28 Front panel SATA connector

J29 Planar SATA connector

J30 Planar SATA power connector

J41B 10/100/1000Mb/s Ethernet connector

J41A COM port connector

P1, P2 VME backplane connectors

J1A, J1B, J1C, J1D COM port connectors

J2A 10/100/1000Mb/s Ethernet connector

J2B 10/100Mb/s Ethernet connector

J10 PIM power/ground

J14 PIM I/O

P2 VME backplane connector

MVME3100 Single Board Computer Quick Start Guide

SMART Embedded Computing, 2900 S. Diablo Way, Suite 190, Tempe, Arizona 85282

7 Complete Installation

1. Verify that the board is installed and the power/peripheral

cables connected are appropriate for your system

configuration.

2. Replace the chassis or system cover, reconnect the system to

the AC or DC power source and apply power.

For technical assistance or to report product damage or shortages,

contact your local SMART Embedded Computing sales

representative or visit https://www.smartembedded.com/ec/support/

Technical Assistance

For more information on this product, see the MVME3100

Single Board Computer Installation and Use manual

and other related technical documentation, which can be

found by using the Documentation Search at

https://www.smartembedded.com/ec/support/.

Get More Information

“SMART” is a registered trademark of SMART Modular Technologies, Inc. and “SMART

Embedded Computing” and the SMART Embedded Computing logo are trademarks of

SMART Modular Technologies, Inc. All other names and logos referred to are trade names,

trademarks, or registered trademarks of their respective owners. These materials are

provided by SMART Embedded Computing as a service to its customers and may be used

for informational purposes only. For full legal terms and conditions, visit

www.smartembedded.com/ec/legal.

Otros manuales para MVME3100

Otros manuales de Computadora de placa única de SMART Embedded Computing

SMART Embedded Computing

SMART Embedded Computing PCIE-8130-HL Manual de usuario

SMART Embedded Computing

SMART Embedded Computing MVME2500 Guía de inicio rápido

SMART Embedded Computing

SMART Embedded Computing MVME8100 Manual de usuario

SMART Embedded Computing

SMART Embedded Computing PCIE-6001 Manual de usuario

SMART Embedded Computing

SMART Embedded Computing MVME2500 Manual de usuario

SMART Embedded Computing

SMART Embedded Computing ATCA-8310 Manual de usuario

SMART Embedded Computing

SMART Embedded Computing MVME4100 Manual de usuario

SMART Embedded Computing

SMART Embedded Computing MaxCore MC3000 Hoja de datos

SMART Embedded Computing

SMART Embedded Computing MVME7100ET Guía de inicio rápido

SMART Embedded Computing

SMART Embedded Computing COMX-CORE-2610-ET Guía

Manuales populares de Computadora de placa única de otras marcas

WIN Enterprises

WIN Enterprises PL-80910 Manual de usuario

AXIOMTEK

AXIOMTEK SBC81206 Series Manual de usuario

Embest

Embest SOM-PH8800 Manual de usuario

SeaLevel

SeaLevel SBC-R9 Manual de usuario

WinSystems

WinSystems PPM-LX800-G Manual de usuario

GIGAIPC

GIGAIPC QBiX-PPC Series Manual de usuario

OLIMEX

OLIMEX A10S-OLinuXino-MICRO Manual de usuario

Commell

Commell FS-978 Manual de usuario

GIGAIPC

GIGAIPC QBiP-8665A/ Manual de usuario

VersaLogic

VersaLogic Python EBX-11 Manual de usuario

Micro Computer Specialists

Micro Computer Specialists IRV-3702 Manual de usuario

CompuLab

CompuLab SB-A510 Manual de usuario

Boser

Boser HS-7321 Manual de usuario

Premier Farnell

Premier Farnell Embest SBC8530 Manual de usuario

MicroSys Electronics

MicroSys Electronics miriac SBC-LS1043A2 Manual de usuario

Aaeon

Aaeon UP Manual de usuario

Portwell

Portwell WUX Series Manual de usuario

Lanner electronics

Lanner electronics IAC-F847 Series Manual de usuario