SMART-AVI EZWall-Pro V2 Manual de usuario
EZWall-Pro V2
User Manual
Mul‐Format Video Wall Processor
www.smartavi.com
Tel: (800) AVI‐2131 (702) 800‐0005
2455 W Cheyenne Ave, Suite 112
North Las Vegas, NV 89032
Table of Contents
TABLE OF CONTENTS / WHAT'S IN THE BOX? 2
INTRODUCTION 3
FEATURES 3
APPLICATIONS 3
TECHNICAL SPECIFICATIONS 4
HARDWARE INSTALLATION 5 - 6
FRONT PANEL CONTROL 6
ESTABLISHING AN RS-232 CONNECTION 7
IR REMOTE CONTROL 8
CONTROL VIA ETHERNET 9 - 11
FIRMWARE UPDATE 12 - 14
LIMITED WARRANTY STATEMENT 15
WHATS IN THE BOX?
Model Number Descripon
EZW3X3V3-S Mul‐Format Video Wall Processor. Includes:
[EZW3X3 and (CCPWR06)]
NOTICE:
The informaon contained in this document is subject to change without noce. Smart-AVI makes no warranty of any kind with regard to this material,
including but not limited to, implied warranes of merchantability and tness for any parcular purpose. Smart-AVI will not be liable for errors contained
herein or for incidental or consequenal damages in connecon with the furnishing, performance or use of this material. No part of this document may be
photocopied, reproduced or translated into another language without prior wrien consent from Smart-AVI.
Thank you for choosing Smart‐AVI EZWall‐Pro for your video wall soluon. The EZWall‐Pro 3x3 V2 oers
top‐notch HD‐DVI output for ve dierent type of signal inputs. Create striking 3x3 wall displays easily
with simple signal‐switching and exible connecvity. The EZWall‐Pro V2 even features a fully‐integrated
USB media player, perfect for populang your displays with encing digital content.
Capable of expanding any supported video input to nine large‐scale screens at 1080p, the EZWall‐Pro
show‐cases stunning picture quality and SmartAVI products’ signature ease of use. In this guide, you will
learn how to install and opmize your experience with the EZWall‐Pro using basic steps. We will cover set‐
ng the hard‐ware up, acvang and connecng your systems, and oer helpful ps on how to best use
EZWall‐Pro V2’s excellent selecon of picture modes to enhance your video wall. Congratulaons again
on choosing EZWall‐Pro V2 and SmartAVI as your go‐to video wall soluon!
• 9 screen (3x3) mul‐Layout, mul‐format video wall controller
• Outputs: (12) DVI single‐link
• Inputs: (3) HDMI, (1) RS‐232, (1) VGA, (1) IR input
• Integrated USB Media Player for digital video, imagery and audio
• Internal EDID learning
• 1080p (1920x1080 @ 60Hz) Full HD resoluon output
• No addional hardware or soware required
• Supports control via Front Panel Buons
• Supports control via IR Remote control
• Supports control via RS‐232
• Supports control via TCP/IP
• HDCP and HDMI 1.4 compliant
• Corporate or Educaonal Presentaons
• Airport Installaons
• Wall Displays
• Digital Signage
• Dealer Rooms
• Control Rooms
• Shopping Centers
• Security
• Point‐of‐Sale
• Entertainment Venues
• Corporate Lobbies
• Restaurants
APPLICAtions:
fEATURES:
introduction
technical specifications:
VIDEO
Output Resoluons Up to 1080P (1920x1080@60Hz)
Input Resoluons Up to 1080P (1920x1080)
Input Video Signal 1.2 volts
Input DDC Signal 5 volts
Outputs (12) DVI-D
DVI Format Single-link
Inputs (3) HDMI, (1) VGA, (1) IR, (1) RS-232, (1) USB 2.0 Type A, (1) RJ-45
HDCP Compliance 1.0/2.0
Audio (1) 3.5mm input, (1) 3.5mm output
OTHER
Power Internal 100-240 VAC
Dimensions 17.125” W x 3.625” H x 7.5” D
Weight 7.9 lbs.
USB MEDIA PLAYER
Signal Type USB 2.0, 1.1, and 1.0 (Type A)
Video Formats MJPEG, MPEG-1, MPEG-2, MPEG-4, Vvid, DivX H.264
Max Resoluon 1920x1080 @30fps
Max Data Rate 20 Mbps
Audio Formats* MP3, WMA, AAC, MP2, PCM, AC3
Photo Max Resoluons JPEG - 15360x8640, BMP - 9600x6400, PNG - 9600x6400
OTHER Max TXT resoluon: 1200x800
Max ANSI/UNICODE GB/UTF8 le size: 1MB
CONTROL
Front Panel Tacle Switches
RS-232 DB9 Female, 9600 bps, N, 8 1, No ow control
TCP/IP RJ-45
IR Remote Control EZ-RMT (NEC 38 KHz)
*PLEASE NOTE: EZWall‐Pro 3x3 V2 only supports the primary formats listed above. Any unlisted formats are
not compatible with EZWall‐Pro 3x3 V2.
1. Posion EZWall‐Pro 3x3 V2 conveniently and keep it unplugged.
2. Connect DVI output cables between the EZWall‐Pro 3x3 V2 and your video wall screens
3. Connect any input to their corresponding signal source (Blu‐Ray player, computer, etc)
4. Oponally connect the IR receiver to the IR input jack at the back of the EZWall‐Pro 3x3 V2.
5. Oponally connect an RS‐232 cable from a PC to the RS‐232 port of the unit for addional
control.
6. Oponally connect an Ethernet cable to the EZWall‐Pro for addional control over the internet (TCP/IP)
7. Turn on the EZWall‐Pro 3x3 V2.
8. Wait for a few seconds for the unit to inialize
hardware installation
HARDWARE INSTALLATION notice:
The Smart‐AVI EZWall‐Pro 3x3 V2 is available in several conguraons; For this parcular
setup, ports 4, 8, and 12 are oponal. The remaining ports; 1,3,5,7,9,11,2,6 and 10 are
funconal and are required for displaying nine large‐scale screens.
To switch to Video Wall mode, press the WALL buon.
To switch to Clone mode, press the CLONE buon.
FRONT PANEL CONTROL
To switch between listed sources, press:
1. VGA
2. HDMI 1
3. HDMI 2
4. HDMI 3
5. USB *
6. WALL MODE
7. CLONE MODE (See above)
8. LOCK (See above)
Before you start:
The EZWall‐Pro 3x3 V2 may also be controlled via RS‐232 commands. This feature requires that an
RS‐232 card is installed in your computer or a USB to RS‐232 adapter. Check the RS‐232 connecons
on your computer and the EZWall‐Pro 3x3 V2 to determine if you need a male to male, female to female
or male to female cable.
ESTABLISHING AN RS-232 CONNECTION
Establish a connecon to the Smart‐AVI device:
1. Connect an RS‐232 cable to the RS‐232 connector on the PC.
2. Connect the other end of the cable to the RS‐232 port of the Smart‐AVI device.
3. Use Windows Control Panel / Device Manager to idenfy the Com port number. See instrucons and
Figure 9‐2 below.
4. Power on the device.
If you are using a USB to COM port adapter on a Windows PC and need to idenfy the COM port used,
do the following:
1. Click on the start buon.
2. Click on Control Panel.
3. Click on Device Manager.
4. Click on the arrow next to Ports (COM & LPT).
You should see the name of your adapter and the
COM port number in use.
Seng up the Terminal Applicaon:
Run the terminal client of your choice such as HyperTerminal or PuTTY.
Select the correct COM port on the PC.
Use the following connecon sengs: 9600, N, 8, 1, no ow control.
Once the connecon is established type //? And hit enter. The EZWall‐Pro 3x3 V2 should respond with a
rmware version number and a list of available commands.
COMMANDS DESCRIPTION
// ? Help (List of Commands)
// B Boot EZWall-Pro 3x3 V2
// C Clone display mode
//I# Select input (# = 1=HDMI1, 2=HDMI2, 3=VGA, 4=AV1, 5=AV2, 6=YPBPR, 7=USB*
// Q A Query IP Address
// Q C Query available video Conguraons
// Q M Query current Mode
// Q F Query Firmware version
// Q S Query current Status
// V Default Video Conguraon (3X3)
// W Wall
// Z Sleep
* USB player requires the IR Remote Control for navigation and media selection.
IR Remote Control
BUTTON DESCRIPTION
WALL Video Wall Mode
CLONE Clone Mode
SOURCE Pressing SOURCE followed by pressing a
number will select the source port number.
USB Player Remote Control**
BUTTON DESCRIPTION (Navigang Menus)
USB Pressing USB followed by pressing number 1 or 2 will select the USB port.
[OK] Center Buon Enter or Select
CH+ Navigate UP
CH- Navigate DOWN
Navigate LEFT
Navigate RIGHT
BUTTON DESCRIPTION (Navigang while Displaying)
[OK] Center Buon Display Menu
[OK] Center Buon (x2 while in menu) Turn o Menu
Volume Up
Volume Down
* Note that when not using all three displays the unused displays will be a clone of output #1
** e USB player requires the IR Remote Control for navigation and media selection.
EZWall‐Pro 3x3 V2 TCP/IP control is a feature that allows mode switching and other conguraons to be
controlled remotely via HTTP. Manage your EZWall‐Pro 3x3 V2 with ease from anywhere in the world.
First you must nd the IP address for the EZWall‐Pro 3x3 V2. Finder.exe (Smart IP‐Finder) is convenient‐
ly available on our website; please visit www.smartavi.com/helpful‐links.html for this and our full list of
compable third‐party soware. Download and execute the IP address Finder soware for your product.
The EZWall‐Pro 3x3 V2 and its IP address should appear in the display as shown in Figure 9‐1.
CONTROL VIA ETHERNET
Tabla de contenidos
Otros manuales de Convertidor de medios de SMART-AVI
SMART-AVI
SMART-AVI AVS4P Manual de usuario
SMART-AVI
SMART-AVI SMCYPB2VGA Manual de usuario
SMART-AVI
SMART-AVI EZWALL-pro 3x3 v3 Manual de usuario
SMART-AVI
SMART-AVI SM-HDMV-16X-PLUS Manual de usuario
SMART-AVI
SMART-AVI SMCVG2DVI Manual de usuario
SMART-AVI
SMART-AVI UHDN-4P Duo Manual de usuario
SMART-AVI
SMART-AVI DVS2P Manual de usuario
SMART-AVI
SMART-AVI HDN-4P Manual de usuario
SMART-AVI
SMART-AVI SMCVG2DVI Manual de usuario
SMART-AVI
SMART-AVI V2V-SC4KUHD Manual de usuario
SMART-AVI
SMART-AVI V2V Series Manual de usuario
SMART-AVI
SMART-AVI CVH-01 Manual de usuario
SMART-AVI
SMART-AVI DVS2P Manual de usuario
SMART-AVI
SMART-AVI SaviStreamer E300 Manual de usuario
SMART-AVI
SMART-AVI HSA-100-S Manual de usuario
SMART-AVI
SMART-AVI HDX-400S Manual de usuario
SMART-AVI
SMART-AVI SaviStreamer E300 Manual de usuario
SMART-AVI
SMART-AVI VS2P Manual de usuario
SMART-AVI
SMART-AVI V2V-H2V-01 Manual de usuario
SMART-AVI
SMART-AVI VS4PS Manual de usuario
