SMA DATA MANAGER L Manual de usuario
DATA MANAGER L
EDML-10-BE-en-10 | Version 1.0ENGLISH
Operating manual
SMADATAMANAGERL
Legal Provisions SMA Solar Technology AG
Operating manualEDML-10-BE-en-102
Legal Provisions
The information contained in these documents is the property of SMA Solar Technology AG. No
part of this document may be reproduced, stored in a retrieval system, or transmitted, in any form or
by any means, be it electronic, mechanical, photographic, magnetic or otherwise, without the prior
written permission of SMA Solar Technology AG. Internal reproduction used solely for the purpose
of product evaluation or other proper use is allowed and does not require prior approval.
SMA Solar Technology AG makes no representations or warranties, express or implied, with
respect to this documentation or any of the equipment and/or software it may describe, including
(with no limitation) any implied warranties of utility, merchantability, or fitness for any particular
purpose. All such representations or warranties are expressly disclaimed. Neither SMA Solar
Technology AG nor its distributors or dealers shall be liable for any indirect, incidental, or
consequential damages under any circumstances.
The exclusion of implied warranties may not apply in all cases under some statutes, and thus the
above exclusion may not apply.
Specifications are subject to change without notice. Every attempt has been made to make this
document complete, accurate and up-to-date. Readers are cautioned, however, that product
improvements and field usage experience may cause SMA Solar Technology AG to make changes
to these specifications without advance notice, or per contract provisions in those cases where a
supply agreement requires advance notice. SMA Solar Technology AG shall not be responsible for
any damages, including indirect, incidental or consequential damages, caused by reliance on the
material presented, including, but not limited to, omissions, typographical errors, arithmetical errors
or listing errors in the content material.
SMA Warranty
You can download the current warranty conditions from the Internet at www.SMA-Solar.com.
Software Licenses
The licenses for the installed software modules (open source) can be found in the user interface of
the product.
Trademarks
All trademarks are recognized, even if not explicitly identified as such. Missing designations do not
mean that a product or brand is not a registered trademark.
SMA Solar Technology AG
Sonnenallee 1
34266 Niestetal
Germany
Tel. +49 561 9522-0
Fax +49 561 9522-100
www.SMA.de
Email: [email protected]
Status: 12/12/2019
Copyright © 2019 SMA Solar Technology AG. All rights reserved.
Table of Contents
SMA Solar Technology AG
Operating manual EDML-10-BE-en-10 3
Table of Contents
1 Information on this Document................................................. 6
Information on this Document ....................................................... 6
1.1 Validity........................................................................................................................ 6
1.2 Target Group.............................................................................................................. 6
1.3 Content and Structure of this Document ................................................................... 6
1.4 Levels of Warning Messages.................................................................................... 6
1.5 Symbols in the Document .......................................................................................... 7
1.6 Typographies in the Document.................................................................................. 7
1.7 Designation in the document..................................................................................... 7
1.8 Additional Information............................................................................................... 8
2 Safety ........................................................................................ 9
Safety............................................................................................... 9
2.1 Intended Use .............................................................................................................. 9
2.2 IMPORTANT SAFETY INSTRUCTIONS.................................................................... 9
2.3 Supported Products.................................................................................................... 12
3 Scope of Delivery ..................................................................... 14
Scope of Delivery ........................................................................... 14
4 Product Overview .................................................................... 15
Product Overview........................................................................... 15
4.1 Product Description.................................................................................................... 15
4.2 Symbols on the Product ............................................................................................. 16
4.3 LED Signals................................................................................................................. 17
4.4 Sunny Portal................................................................................................................ 18
4.5 Interfaces and Functions ............................................................................................ 18
5 Mounting................................................................................... 21
Mounting ......................................................................................... 21
5.1 Requirements for Mounting ....................................................................................... 21
5.2 Mounting the Product on the DIN Rail...................................................................... 23
5.3 Mounting the Product on the Wall............................................................................ 25
6 Connection ................................................................................ 27
Table of Contents SMA Solar Technology AG
Operating manualEDML-10-BE-en-104
Connection ...................................................................................... 27
6.1 Overview of the Connection Area ............................................................................ 27
6.2 Preparing the Connection Cable............................................................................... 27
6.3 Connecting Signal Source to Digital Input ............................................................... 28
6.4 Connecting the network............................................................................................. 29
6.5 Connecting the Voltage Supply ................................................................................ 31
7 Commissioning ......................................................................... 34
Commissioning................................................................................ 34
7.1 Establishing a Connection via Ethernet in the local network................................... 34
7.2 Establishing a Direct Connection via Ethernet.......................................................... 34
7.3 Commissioning the Product ....................................................................................... 35
7.4 Registering in Sunny Portal........................................................................................ 36
8 Operation ................................................................................. 38
Operation........................................................................................ 38
8.1 Design of the User Interface...................................................................................... 38
8.2 Configuring Limitation of Active Power Feed-In........................................................ 39
8.3 Configuring Reactive Power as a Function of Grid Voltage.................................... 40
8.4 Configuring Modbus Devices.................................................................................... 41
8.5 Configuring a System with several Data Managers................................................ 42
8.6 Resetting the Product.................................................................................................. 43
8.7 Deleting the Admin Account...................................................................................... 43
9 Firmware Update ..................................................................... 45
Firmware Update ........................................................................... 45
9.1 Updating the Product Firmware ................................................................................ 45
9.2 Updating the Firmware of Connected SMA Products ............................................. 46
10 Troubleshooting........................................................................ 47
Troubleshooting.............................................................................. 47
11 Decommissioning the Product ................................................. 49
Decommissioning the Product ....................................................... 49
12 Technical Data .......................................................................... 51
Technical Data................................................................................. 51
Table of Contents
SMA Solar Technology AG
Operating manual EDML-10-BE-en-10 5
13 Accessories ............................................................................... 53
Accessories...................................................................................... 53
14 Contact ...................................................................................... 54
Contact............................................................................................. 54
15 EU Declaration of Conformity ................................................. 57
EU Declaration of Conformity........................................................ 57
16 Compliance Information .......................................................... 58
Compliance Information ................................................................ 58
1 Information on this Document SMA Solar Technology AG
Operating manualEDML-10-BE-en-106
1 Information on this Document
1.1 Validity
This document is valid for:
• EDML-10 (Sunny Data Manager L) from firmware version 1.00.01.R.
1.2 Target Group
The tasks described in this document must only be performed by qualified persons. Qualified
persons must have the following skills:
• Training in the installation and configuration of IT systems
• Training in how to deal with the dangers and risks associated with installing, repairing and
using electrical devices and installations
• Training in the installation and commissioning of electrical devices and installations
• Knowledge of all applicable laws, standards and directives
• Knowledge of and compliance with this document and all safety information
• Knowledge of operation and control of PV power plants on medium-voltage grids and high-
voltage grids
1.3 Content and Structure of this Document
This document describes the mounting, installation, commissioning, configuration, operation,
troubleshooting and decommissioning of the product as well as the operation of the product user
interface.
You will find the latest version of this document and further information on the product in PDF format
and as eManual at www.SMA-Solar.com. You can also call up the eManual via the user interface
of the product.
Illustrations in this document are reduced to the essential information and may deviate from the real
product.
1.4 Levels of Warning Messages
The following levels of warning messages may occur when handling the product.
DANGER
Indicates a hazardous situation which, if not avoided, will result in death or serious injury.
WARNING
Indicates a hazardous situation which, if not avoided, could result in death or serious injury.
CAUTION
Indicates a hazardous situation which, if not avoided, could result in minor or moderate injury.
1 Information on this Document
SMA Solar Technology AG
Operating manual EDML-10-BE-en-10 7
NOTICE
Indicates a situation which, if not avoided, can result in property damage.
1.5 Symbols in the Document
Symbol Explanation
Information that is important for a specific topic or goal, but is not safety-rele-
vant
☐
Indicates a requirement for meeting a specific goal
☑
Desired result
✖
A problem that might occur
Example
1.6 Typographies in the Document
Typography Use Example
bold • Messages
• Terminals
• Elements on a user interface
• Elements to be selected
• Elements to be entered
• Connect the insulated
conductors to the terminals
X703:1 to X703:6.
• Enter 10 in the field
Minutes.
>• Connects several elements to be
selected
• Select Settings > Date.
[Button]
[Key]
• Button or key to be selected or
pressed
• Select [Enter].
# • Placeholder for variable
components (e.g., parameter
names)
• Parameter WCtlHz.Hz#
1.7 Designation in the document
Complete designation Designation in this document
SMA Data Manager L Data Manager, product
1 Information on this Document SMA Solar Technology AG
Operating manualEDML-10-BE-en-108
1.8 Additional Information
Title and information content Type of information
"Plant Communication in Large-Scale PV Power Plants" Technical Information
"Direct Marketing Interface" Technical information
"PUBLIC CYBER SECURITY - Guidelines for a Secure PV System
Communication"
Technical information
"SMASPEEDWIRE FIELDBUS" Technical information
"SMA GRID GUARD 10.0 - Grid management services through
SMA Inverter"
Technical Information
Answers to frequently asked questions FAQ on product page
User information on the operation and features of the product User information on the user
interface
2 Safety
SMA Solar Technology AG
Operating manual EDML-10-BE-en-10 9
2 Safety
2.1 Intended Use
The SMADataManager L is the central communication unit for monitoring, control and grid-
compliant output regulation of large-scale PV power plants with central or string inverters. The
following is included into the SMA infrastructure via the Ethernet interface of the
SMADataManager L: system components and systems including energy generators and loads, I/
O systems and meters. At the same time, the SMADataManager L supports communication with
up to 200 devices.
The product is designed for indoor use only.
All components must remain within their permitted operating ranges and their installation
requirements at all times.
Use SMA products only in accordance with the information provided in the enclosed
documentation and with the locally applicable laws, regulations, standards and directives. Any
other application may cause personal injury or property damage.
Alterations to the SMA products, e.g., changes or modifications, are only permitted with the express
written permission of SMA Solar Technology AG. Unauthorized alterations will void guarantee and
warranty claims and in most cases terminate the operating license. SMA Solar Technology AG
shall not be held liable for any damage caused by such changes.
Any use of the product other than that described in the Intended Use section does not qualify as the
intended use.
The enclosed documentation is an integral part of this product. Keep the documentation in a
convenient, dry place for future reference and observe all instructions contained therein.
This document does not replace and is not intended to replace any local, state, provincial, federal
or national laws, regulations or codes applicable to the installation, electrical safety and use of the
product. SMA Solar Technology AG assumes no responsibility for the compliance or non-
compliance with such laws or codes in connection with the installation of the product.
The type label must remain permanently attached to the product.
2.2 IMPORTANT SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS
This section contains safety information that must be observed at all times when working.
The product has been designed and tested in accordance with international safety requirements. As
with all electrical or electronical devices, there are residual risks despite careful construction. To
prevent personal injury and property damage and to ensure long-term operation of the product,
read this section carefully and observe all safety information at all times.
2 Safety SMA Solar Technology AG
Operating manualEDML-10-BE-en-1010
DANGER
Danger to life due to electric shock from touching an ungrounded product in
the event of an error
A product that is not grounded may be energized in the event of an error. Touching an
ungrounded product results in death or serious injury due to electric shock in the event of an
error.
• Ensure that the product is integrated in the existing surge protection.
• Ground the enclosure of the product.
• Ensure that the voltage of the digital input does not exceed 30VDC in relation to ground
potential.
WARNING
Danger to life due to electric shock
Under fault conditions, when working on the power supply circuit there may be dangerous
voltages present on the product. This can result in death or serious injury.
• For power supply units with a fixed connection, make sure that a disconnection unit (e.g.
miniature circuit breaker) is present outside the power supply unit.
• For power supply units with a plug connection, make sure that the electrical outlet for the
power supply unit is close to the power supply unit.
• The disconnection unit and the electrical outlet for the power supply unit must be freely
accessible at all times.
CAUTION
Risk of burns due to hot enclosure parts
Some parts of the enclosure can get hot during operation. Touching hot enclosure parts can
result in burn injuries.
• Do not touch the enclosure during operation.
• Wear suitable personal protective equipment.
NOTICE
Damage to the product due to condensation
If the product is moved from a cold environment to a warm environment, condensation may form
in the product. This can damage the product or impair its functionality.
• When there are large temperature differences, wait until the product has reached room
temperature to connect the voltage supply.
• Make sure the product is dry.
Otros manuales para DATA MANAGER L
2
Este manual sirve para los siguientes modelos
1
Tabla de contenidos
Otros manuales de Sistema de conferencias de SMA
Manuales populares de Sistema de conferencias de otras marcas
Kramer
Kramer VIA GO Manual de usuario
AVT
AVT MAGIC AC1 Go Manual de usuario
ProSoft Technology
ProSoft Technology AN-X4-AB-DHRIO Manual de usuario
Sony
Sony PCS-I150 Manual de usuario
Middle Atlantic Products
Middle Atlantic Products VTC Series Manual de usuario
Prentke Romich Company
Prentke Romich Company Vanguard Plus Guía
