Page 4
2-1 Safety regulations
2-1-1 General safety rules
1. This electric winch is designed for lifting products only. Do not apply the electric
winch for lifting person.
2. The electric winch should be mounted on a flat solid place.
3. Installing the electric winch at a proper levelling condition to ensure the steel rope
arranged neatly. This may avoid steel rope friction against the winch body due to
regular winding.
4. Make sure your power source comply with the voltage indicated on the electric
winch before connecting the power wires to the power source.
5. Connect the power wires. Tighten the terminals securely.
6. Make sure the electric winch has been properly grounded. The power circuit should
be equipped with an electric shock breaker.
7. Before operating the electric winch, read and follow the instructions for allowable
lifting weight, speed and voltage etc. Indicated on the attached plate.
8. Do not exceed the rated lifting capacity of the electric winch. Allowable lifting
weight is indicated on the attached plate.
9. The electric winch should be operated by a skilled operator. Before operating the
electric winch check again if all lock screws are tightened securely without
loosening.
10. Before operating the electric winch check to see if the steel rope drum runs to the
correct direction and the brake works normally.
11. Do not allow any person approaches under the electric winch, bracket or weight.
12. Select a proper location for mounting the electric winch, to prevent the lifting weight
bumping against any construction, steel frame or construction beam etc while
lifting.
13. Always keep the steel rope in a good condition.When applying the electric winch
for lifting heavy load, keep the steel rope at least 3 turns wounded around the drum.
14. Lift weight vertically. Do not lift weight in a slant or horizontal direction. Do not have
weight hooked on the steel rope for a long time.
15. Do not use the electric winch to pull out any object fixed in the floor or any
construction.
16. When the electric winch is running, keep your hands or any object away from it to
avoid danger.
17. Prevent control wire or power wire from hooking or contacting by the wire rope. This
may avoid electric shock or any danger.
18. In case any malfunction or abnormal noise occurs during operation, stop the electric
