skyvoe NXG-55 Manual de usuario
Deck Post & Tilt Mount
Assembly Manual
NXG-55
*This deck post is shown with the tilt mount for NXG 5550*
3
Deck Post ManualnXG 5550 |
Table of Contents
DECK POST INSTALLATION ............................................... 5
PARTS FOR POST ASSEMBLY ........................................ 5
TILT MOUNTS .................................................................. 6
POST TO PLATE ASSEMBLY ........................................... 7
PLATE POSITION AND ANCHORING............................... 9
POST TILT MOUNT ASSEMBLY ....................................... 13
PARTS FOR POST TILT MOUNT .................................... 15
TILT MOUNTS ................................................................ 16
U-BOLTS AND MOUNTING PLATE ASSEMBLY............. 17
5
Deck Post ManualnXG 5550 |
Parts for Post Assembly:
1. 1- Post
2. 1- Base Plate
3. 1 - Post Lock - Handle
front
back
this item is found in parts box
Not Included: Anchoring hardwear for Base Plate
Gather the following:
6All Rights Reserved. 2014 SkyVue®
Assembly Manual- Deck Post
Tools Required for Post Assembly:
Tilt Mounts:
The tilt mount portion of the deck post is provided in a separate box
labeled “PTM” and is size specic. See below for the appropriate sizes.
55” Class
Televisions
Ratchet
with 9/16” Socket
9/16”
7
Deck Post ManualnXG 5550 |
Post to Plate Assembly:
Set Screw
Preinstalled
Post Lock - Handle Hole
Located on side
Bottom of Post
Brass Fitting for
Friction Reduction
Lower Cable Exit Hole
Upper Cable Entry Hole
8All Rights Reserved. 2014 SkyVue®
Assembly Manual- Deck Post
Slide bottom of post over the
sleeve that is found towards the
back of the mounting plate.
Locate the post lock handle
hole on the side of the post.
Thread the handle into
the hole.
Do not tighten completely
until post is in the preferred
viewing position.
9
Deck Post ManualnXG 5550 |
Plate Position and
Anchoring your Deck Post:
Base Plate with post
Position the base plate with post in the
spot where it is going to be mounted.
Using the four holes indicated with
the red ciricles, drill the holes for the
hardwear you purchased to secure the
base plate to the deck or patio.
After the holes are drilled insert your
hardwear and tighten securely.
You have now completed the assembly portion of your Deck Post Mount.
You have now completed the assembly portion of your
Deck Post Mount.
Otros manuales para NXG-55
1
Tabla de contenidos
Otros manuales de Rack y soporte de skyvoe
