Sinclair AMC-09C Manual de usuario
USER'S MANUAL
AMC-09C
MOBILE SERIES
...............................................
1
.......................................
.
.....................................
.
..............................................
............................................
22
...........................................
.........................................
24
23
25
2
1
3
..................................
..................................
..................................
..................................
.
.................................
17-19
20-21
.........................................
11
13
14
15
16
.................
4-8
9-10
...............
CONTENTS
Summary
Working principle
Models & specifications
Structure
Operating methods
Names and Functions of the Remote Controller
COOL mode operation
DRY mode operation
SLEEP mode operation
AUTO mode operation
TIMER mode operation
Installation guide for castor, drainage pipe and air exhaust accessory
Care and Maintenance
Trouble shooting
User notices
After service
Circuit diagram
...................................
.........
.....................................
－2－
SUMMARY
－1－
This MOBILE AIR CONDITIONER is a small, moveable air conditioner. It possessed the
functions of COOL, HEAT, DRY and the Separate Ventilation, and depends on different places, it
canbemovedaswill.Itisfitforhome andofficeuse,especiallyfitforthehousewithmanyrooms.
Withthecompactconfiguration,excellentworkmanship,elegantappearance,itlookslikeastanding
Benzcar. Itisconvenientformoving,energysaving,andwith lownoise.
Note:Pleasereadthismanualcarefullybeforeoperatingtheunit,themanualisusedforreference,
andthetechnicalparameters aresubjecttochangewithoutnotice.
WORKING PRINCIPLE
With the help of upper motor, the airflow of indoor pass through the evaporator becomes the
cooled wind, but with the help of lower motor, the airflow of indoor pass through the condenser
becomes the heated wind. There is two duct systems designed in its structure.The heated wind is discharged
bytherearoutlet,thecooled windisdischargedbythefrontoutlet,flow-guidedbythelouver,andit
brings the gentle cooling airflow, and the low temperature environment is maintained.
The Working Principle
Cooled wind
Upper
motor
Lower
motor
Evaporator
Airflow 1
Airflow 2
Capillary
Heated wind
Condenser
－2－
MODELS AND SPECIFICATIONS
Note:
1.The
noisewastestedwhentheunitisrunningincooling windmode,1meterawayfromthefront
outlet, dehumidifying capacity.
2.The technical parameters are subject to be changedwithout notice. Please refer to those listed on
Model AMC-09C
Cooling Capacity(W) 2600W
Power Source 220－240V ～50Hz
Rated Input Current(A) 5.3
Rated Power Input(W) 1200
Flow Volume(m3/h) 430
Sound Press Level dB(A) 55
Refrigerant R407C
Net Weight（Kg）31
Dimension(Body)(H×W
×D）（mm）840×450×370
Dimension(Package)(H×
W×D）（mm）880×685×425
nameplate of the unit.
3. Device is not intended for continuous running
－3－
STRUCTURE
Control panel
Air outlet
Handle
Lower air inlet
Front
Rear
Upper air inlet grille
Power cable
Air exhaust outlet
Lower air inlet grille
OPERATING METHODS
５
０ｃ
ｍ
５０ｃｍ
－4－
The working range of COOL mode is 16℃-35℃, the working range of
DRYmode is 16℃-35℃．
When operating, the unit should be placed on the horizontal place and
more than 50cm away from the wall or other obstructions.
The working range of COOL
mode and DRYmode
Location conditions
Power supply Before the unit is power-on, please check the following:
The power supply voltage 6%.
● The lead wire is suitable for the start-up current of more than 20A,
to avoid the voltage decline when the unit starts suddenly.
● The power plugs and the
sockets can be supported by the current
that is more than 16A.
● The thread section of the lead wires and any continued use lead wire
is no less than 2.5mm2.
● If the power supply cord is damaged, replace it by the special
power supply cord.
●
If the power supply is needed to replace or maintain, please
contact with the dealer and ask for the professional personnel to do
the repairing work.
● The air conditioner must be safety earthed. Earth wire must be
connected to the special device of the building. That is for providing
good earthing for the air conditioner.
OPERATING METHODS
●Can not use steel wire or brass wire to replace fuse, the capability
of fuse must be appropriate.
In order to avoid damage to power cord
and electrical leakage, do not fix the power supply on the knife edge or
sharp object.
●The wiring must be operated by the professional
and according
to the national regulations. In fixed circuit, there must be electricity
leakage protection switch of enough power capacity and 16A
thermal-
magnetic breaker air switch with enough space, the earth wire can't be
connected to water pipe or gas pipe. When the air conditioner is not
used, please pull out the power plug or cut off power supply.
－5－
There must be reliable ground
wire in the power supply
Earthing
Water pipe
Gas pipe
－6－
OPERATING METHODS
LCD instruction (dynamic display)
Names and Functions- Remote Controller
ON/OFF
MODE
FAN SPEED
LCDscreen
SET TEMP.
SET TIMER
SET SLEEP
Remote Control window
－7－
OPERATING METHODS
Controlpanelandthefunction
1. "ON/ OFF "key
Press once to start and press once more to stop the unit.
2."MODE" key
Press this button to change operation mode in order of:
FAN → COOL → DRY →AUTO → FAN
3 "FAN SPEED" key
When the unit is running in "FAN", "COOL" and "HEAT" mode,there are 3 kinds of fan speeds to
be selected, press "FAN SPEED" key to choose between "LOW → MD → HIGH".
4."SET TEMP" key
When turn on the air conditioner, in the "COOL","HEAT" mode, the control panel will display the set
temp. Press "▲"""to increment or to decrement the set temperature.
5. "SET TIMER" key
Press"▲""" key to set the time for timer on or timer off. When the unit is running, you could set the
timer off, the unit will stop running; When the unit is stop running (not power off ), set timer on, andthe
time interval that being set will be 0.5-24 hour(s), press "▲""" key to adjust.
6. "SET SLEEP" key
When the unit is running, press once to set "SLEEP" operation, repress it, the unit will stop the "SLEEP"
operation.There is no "SLEEP" operation in "AUTO" mode.
Tabla de contenidos
Otros manuales de Acondicionador de aire de Sinclair
Sinclair
Sinclair ASH-18BIF Manual de usuario
Sinclair
Sinclair ASH-18AIN PT Manual de usuario
Sinclair
Sinclair FREE COMBI SERIES Manual de usuario
Sinclair
Sinclair ASH-09AIK Manual de usuario
Sinclair
Sinclair AMC-11P Manual de usuario
Sinclair
Sinclair FC-D09AI Instrucciones de funcionamiento
Sinclair
Sinclair SDV5 Series Manual de usuario
Sinclair
Sinclair KING ASH-09AK Manual de usuario
Sinclair
Sinclair MC-E36AI Manual de usuario
Sinclair
Sinclair MV-PBI Series Manual de usuario
Sinclair
Sinclair MS-H07AIC PT Manual de usuario
Sinclair
Sinclair KEYON Series Manual de usuario
Sinclair
Sinclair MATRIX ASH-18AIM PT Manual de usuario
Sinclair
Sinclair ASH-18AIE Manual de usuario
Sinclair
Sinclair ASH-09AIR2 Manual de usuario
Sinclair
Sinclair SDV IV Series Manual de usuario
Sinclair
Sinclair ASF-60AN Manual de usuario
Sinclair
Sinclair MS-E48AIN Manual de usuario
Sinclair
Sinclair SDV4-200EA Manual de funcionamiento
Sinclair
Sinclair SDV5 Series Manual de usuario
