If you own a Simworx Chassis, the mounting kit is required for mounting the shifter in it’s recommended location. All
required holes in the alloy mounting plate are pre drilled to suit the SX02 Chassis, whether Left or Right Hand Side. The
alloy plate is offset to allow seat clearance when fitted up close to the seat. For mounting to a non Simworx simulator
chassis we have supplied drilling dimensions below.
For mounting to an SX02, all you are required to do is to take the four supplied 6mm button head bolts, align the
shifter mounting bracket & tighten them till firm with an Allen key. After that is firmly secured, take the shifter and mount
it to the risers with the supplied 8mm nuts, bolts & washers. The Risers can be mounted trending forward or back,
depending on preference.
For all other chassis, bolt the risers to the offset base in your preferred direction, take the shifter and mount
loosely on the risers, mark your preferred location. Drill a small pilot hole at each mark. Drill out to 8.5mm and bolt the
mounting base securely. Tighten the shifter mounting bolts
For direct shifter mounting without the offset base and risers, drill the holes out to 8.5mm using the base template
below and attach with the provided nuts & bolts.
