Tripod Set Up
Take the mast with attached tripod out of the bag and
stand it up vertically so that the three feet are on the
ground and the red ring on the opposite end of the mast is
towards the sky.
There are two collars that attach the tripod legs to
the mast. Each collar has a knob that loosens
allowing the mast to slide through the collars.
Leaving the lower collar knob tightened, loosen the
knob on the upper collar.
With the third leg on the ground, take hold of the
other two legs and pull straight out from the mast,
spreading all three legs simultaneously. This will
cause the upper collar to slide down the mast
towards the lower collar.
Once the three legs are spread at the desired width,
tighten the knob on the upper collar to lock them in
place. 4
