CONTROLBOARDINSTRUCTION
POWER INPUT:
POWER ON/OFF:
Donwload2:
MIC:
MIN-MAX:
ADDRESS:
ILDA DB 25 F Connector
NOTE:
1. PC SIGNALIN ILDADB 25Fconnector s
2.
3.
PC SIGNALIN ILDADB 25FConnector
Input power, with inner fuse.
power on/off
Download method 2 used
Receive Music.
Musicsensitivity potentiometer
the 10 code is switch code. When the 10 code is OFF, 1~9 are
function codes. When function code is 0, the working mode is Music Active
(Master mode); when function code is 1, the working mode is Automatic (Master
mode); when function code is 2 or more, the working mode is Slave mode. When
the 10 code is ON,1~9 will be DMX address codes. The address code of first
light usually by1, the second light is 14 and so on.
: signal input connection port of the laser perform
software that in accordance withthe ILDAstandard.
When and connection port are free,
the lamp will drive by the inside program, temporality it can control by music or
DMX512 signal.
After connect the ILDA DB 25F, The lamp will change to ILDA connected port
drive mode ,this connection port can receive all the signal of laser perform
software that accord with the ILDA stand rd, such as LD-2000 of Pangolin
Company.
4.When the and the were connected, then
the system will at an abnormal statement, lamp still control by inside program ,
but not respond to the exterior input signal.
PCSIGNALIN/OUT:
DMXIN/OUT:
PC SIGNAL IN
USBconnection port signal input/output
DMX512 signal input/output
When connects with USB interfacial card, the lamp will be
control by software which wasinstalledin the computer.
a
th th
th
’
Power 120W Cla ss 1
Red Laser Class 3B 635nm >150mW
Green Laser Class 3B 532nm >60mW
Blue Laser Class 3B 473nm >100mW
RGB LASER
