- 3 -
uitability or not.
3. In ert the top of the DIN-Rail into the lot ju t below the
tiff metal pring.
4. The DIN-Rail attachment unit will nap into place a hown
below.
Wiring Requirements
Cable laying need to meet the following requirement ,
1. It i needed to check whether the type, quantity and
pecification of cable match the requirement before cable
laying;
2. It i needed to check the cable i damaged or not, factory
record and quality a urance booklet before cable laying;
3. The required cable pecification, quantity, direction and
laying po ition need to match con truction requirement , and
cable length depend on actual po ition;
4. All the cable cannot have break-down and terminal in the
middle;
5. Cable hould be traight in the hallway and turning;
6. Cable hould be traight in the groove, and cannot beyond the
groove in ca e of holding back the inlet and outlet hole .
Cable hould be banded and fixed when they are out of the
groove;
7. U er cable hould be eparated from the power line . Cable ,
power line and grounding line cannot be overlapped and
mixed when they are in the ame groove road. When cable i
too long, it cannot hold down other cable, but tructure in the
middle of alignment rack;
8. Pigtail cannot be tied and werved a le a po ible.
Swerving radiu cannot be too mall ( mall werving cau e
terrible lo of link). It banding hould be moderate, not too
tight, and hould be eparated from other cable ;
9. It hould have corre ponding imple ignal at both ide of the
cable for maintaining.
Specification
Technology
Standard: IEEE802.3, IEEE802.3u, IEEE802.3x, IEEE802.3ab
Flow control: IEEE802.3x, back pre ure control
Exchange attribute
100M forward peed: 148810pp
1000M forward peed: 1488100pp
Tran mit mode: tore and forward
Sy tem exchange bandwidth: 16Gbp
MAC addre table: 8K
Memory: 1Mbit
Interface
Gigabit Ethernet port: 10Ba e-T/100Ba e-TX/1000 Ba e-TX auto
peed control
Transfer distance
Twi ted cable: 100M ( tandard CAT5/CAT5e cable)
LED indicator
Interface indicator: Link/ACT (G1~G8)
Power upply indicator: PWR
Power supply
Input Voltage: 24VDC (12~48VDC)
Type of input: 3 bit 7.62mm terminal block
Support non-polarity
Overload current protect: 4.0A
Consumption
No-load power con umption: 0.82W@24VDC
Full-load power con umption: 3.65W@24VDC
Working environment
Working temperature: -25
70
Storage temperature: -40
85
Relative Humidity: 5%~95 %( no conden ation)
Mechanical Structure
Shell: IP40 protect grade, metal hell
In tallation: DIN-Rail
Weight: 0.62kg
Size (W×H×D): 53mm×138mm×110mm
Industry Standard
EMI: FCC Part 15, CISPR (EN55022) cla A
EMS: EN61000-4-2 (ESD), Level 2
EN61000-4-3 (RS), Level 2
EN61000-4-4 (EFT), Level 2
EN61000-4-5 (Surge), Level 2
EN61000-4-6 (CS), Level 2
EN61000-4-8, Level 2
Shock: IEC 60068-2-27
Free fall: IEC 60068-2-32
Vibration: IEC 60068-2-6
Certification
CE, FCC, RoHS, UL508 (Pending)
Warranty: 3 year
