9
Smoke detector
The smoke detector is always ON. If smoke is
detected, all trustees added to your home will
be notied and the alarm siren in sfty Sense will
sound until smoke is no longer detected. If you
trigger the smoke alarm by accident, you can
twist sfty Sense o from its bracket and blow
hard into the slits on its side to remove remain-
ing smoke from the chamber.
Testing your smoke detector is recommended
and can be done by using a smoke pen. Light
the pen and let it burn for a few seconds before
you blow out the ame and direct the smoke
towards your sfty Sense. Clear the smoke (if
needed, blow into the slits) to end the alarm.
We suggest notifying any trustees added to
your home before testing, so they know to
expect an alarm.
Test Button
The test button is found on top of the sfty
Sense and also doubles as an indicator that
emits colored light signals in various situations.
One push on the test button while all alarms
are OFF will give you a test alarm and the test
button will bright red. sfty Sense will sound its
siren for 5 seconds and trustees added will
receive an alarm.
Pressing the test button during a smoke alarm
will mute the siren for a 10 minutes so you can
clear the smoke more comfortably. If the sfty
Sense still detects smoke after 10 minutes the
alarm will go o again. If you have multiple
devices in your home all the devices will mute
while pressing the test button. If you mute one
of the devices that did not detect smoke the
alarm will go o again within seconds.
If a controlled re situation emerges you can
press the test button before it goes of, this will
give a 5 seconds test alarm and your trustees
will receive an alarm, the sfty Sense is then
muted for 10 minutes. Keep pressing the test
button for more time to clear smoke.
Test button
Slits
