SereneLife PSLHTM34 Manual de usuario
PSLHTM34
ElectricGardenBlower,Vacuum&Shredder
Home Gardening & Backyard
Landscape System
www.SerenLifeHome.com
Please read these instructions carefully and make sure you
understand them before using.
Explanation of Symbols on your product
GENERAL POWER SOURCE SAFETY WARNINGS
WARNING! Read all safety warnings and instructions. Failure to follow
the warnings and instructions may result in electric shock, re and/or
serious injury.
SAVE ALL WARNINGS AND INSTRUCTIONS FOR FUTURE REFERENCE
1. Working Area
a. Keep working area clean and well lit.
Untidy and dark areas can lead to accidents.
2
Read the user manual before using the machine
Whenever the machine is in use, safety goggles must be worn to
safeguard against ying object, as must ear protectors, such as
soundproof helmet, in order to protect the operator’s hearing. If the
operator is working in an area where there is a risk of falling objects,
a safety helmet must be worn.
Wear gloves to protect your hands
Keep bystanders away
Do not expose to rain
WARNING! Danger
WARNING! Flying objects
Always switch OFF the device, disconnect the plug and wait until the
cutting disc stops.
Rotating impeller blades can cause serious injury
Danger-rotating blades
Switch o and unplug the device before cleaning or performing
maintenance on it
www.SerenLifeHome.com
b. Do not operate power tools in potentially explosive surroundings, for
example, in the presence of inammable liquids, gases or dust. Power
tools create sparks which may ignite the dust or fumes.
c. Keep children and bystanders at a distance when operating a power tool.
Distractions can cause you to lose control of it.
2. Electrical Safety
a. Always check that the power supply corresponds to the voltage on the
rating plate.
b. Power tool plugs must match the outlet. Never modify the plug in any
way. Do not use adapter plugs with earthed power tools. Unmodied
plugs and matching outlets will reduce the risk of an electric shock.
c. Avoid body contact with earthed surfaces such as pipes, radiators, kitchen
ranges and refrigerators. There is an increased risk of an electric shock if
your body is earthed.
d. Do not expose power tools to rain or wet conditions. If water gets
inside a power tool, it will increase the risk of an electric shock.
e. Do not damage the cord. Never use the cord for carrying, pulling or
unplugging the power tool. Keep the cord away from heat, oil, sharp
edges or moving parts. Damaged or entangled cords increase the risk of
an electric shock.
f. When operating a power tool outdoors, use an extension cable suitable
for outdoor use. using a cord suitable for outdoor use reduces the risk of
an electric shock.
g. If operating a power tool in a damp location is unavoidable, use a power
supply protected by a residual current device (RCD).
Using an RCD reduces the risk of an electric shock.
3. Personal Safety
a. Stay alert, watch what you are doing and use common sense when
operating a power tool. Do not use a power tool when you are tired or
under the inuence of drugs, alcohol or medication.
A moment of inattention when operating a power tool may result in
serious personal injury.
3
www.SerenLifeHome.com
b. Use safety equipment. Always wear eye protection. Using safety
equipment such as a dust mask, non- skid safety shoes, a hard hat, or
hearing protection whenever it is needed will reduce the risk of personal
injury.
c. Avoid accidental starts. Ensure the switch is in the o position before
inserting the plug. Carrying power tools with your nger on the switch or
plugging in power tools when the switch is in the on position makes
accidents more likely.
d. Remove any adjusting keys or spanners before tur- ning on the power
tool. A spanner or key left attached to a rotating part of the power tool
may result in personal injury.
e. Do not reach out too far. Keep your feet rmly on the ground at all times.
This will enable you retain cont- rol over the power tool in unexpected
situations.
f. Dress properly. Do not wear loose clothing or jewellery. Keep your hair,
clothing and gloves away from the power tool. Loose clothes, jewellery or
long hair can become entangled in the moving parts.
g. If there are devices for connecting dust extraction and collection
facilities, please ensure that they are attached and used correctly.
Using such devices can reduce dust-related hazards.
4. Power Tool Use and Care
a. Do not expect the power tool to do more than it can. Use the correct
power tool for what you want to do. A power tool will achieve better
results and be safer if used in the context for which it was designed.
b. Do not use the power tool if the switch cannot turn it on and o. A power
tool with a broken switch is dangerous and must be repaired.
c. Disconnect the plug from the power source before making adjustments,
changing accessories, or storing power tools. Such preventive safety
measures reduce the risk of starting the power tool accidentally.
d. Store power tools, when not in use, out of the reach of children and do
not allow people who are not fa- miliar with the power tool or these
instructions to operate it. Power tools are potentially dangerous in the
hands of untrained users.
4
www.SerenLifeHome.com
e. Maintain power tools. Check for misalignment or jammed moving parts,
breakages or any other feature that might aect the operation of the
power tool. If it is damaged, the power tool must be repaired. Many
accidents are caused by using poorly maintained power tools.
f. Keep cutting tools sharp and clean. Properly maintained cutting tools
with sharp cutting edges are less likely to jam and are easier to control.
g. Use the power tool, accessories and cutting tools, etc., in accordance with
these instructions and in the manner intended for the particular type of
power tool, taking into account the working conditions and the work
which needs to be done. Using a power tool in ways for which it was not
intended can lead to pote- ntially hazardous situations.
5. Service
Your power tool should be serviced by a qualied specialist using only
standard spare parts. This will ensure that it meets the required safety
standards.
5
WARNING: Take care not to expose this tool to rain and remove plug
from mains supply immediately if the supply cable is damaged.
WARNING: DO NOT OPERATE THIS TOOL WITH COLLECTION BAG
REMOVED. Serious injury from the fan or ying debris could result.
WARNING: DO NOT OPERATE THIS TOOL WITH VACUUM/BLOWER
TUBE REMOVED. Serious injury from the fan or ying debris could
result.
WARNING: Electric shock could occur if used on wet surfaces. Do not
expose to rain. Store indoors.
WARNING: Always wear eye protection to prevent rocks or debris
from being blown or ricocheting into the eyes or face which can
result in blindness or other serious injury.
www.SerenLifeHome.com
MACHINE SAFETY WARNINGS
1. Always direct the cable to the rear, away from the appliance.
2. If a cord becomes damaged during use, disconnect the supply cord from
the mains supply immediately.
3. Operate the appliance only in daylight or in good articial light.
4. Walk, never run.
5. Keep all cooling air inlets clear.
6. Do not attempt to modify the power tool in any way. The use of any
attachment or accessory over than those recommended in this
instruction manual could result in damage to the power tool and injury to
the operator.
7. Never feed hard objects such as stones, bottles, cans or pieces of metal
into the PSLHTM34. They can cause damage to the machine and possibly
injury to the operator and bystanders.
8. If a foreign body, or other debris, is accidentally feed into the PSLHTM34,
stop it immediately and do not use the unit until it has been checked and
you are sure that the entire unit is in a safe operating condition.
9. If the PSLHTM34 makes any unusual noise or starts to vibrate abnormally
STOP immediately remove the plug from the mains supply and investigate
the cause. Excessive vibration can cause damage to the unit and injury to
the operator.
10. Never operate the appliance while people, especially children, or pets
are nearby.
11. The operator or user is responsible for accidents or hazards occurring to
other people or their property.
12. Before using, always check the appliance including supply and
extension cord for signs of damage and aging.
13. Never operate the appliance with defective guards or shields, or without
safety devices, for example debris collector in place.
6
www.SerenLifeHome.com
Gerenal Information
7
Support
Frame
Cord Holder
Collection Bag
WheelRake
Rake Knob
Vacuum/Blower
Tube
Front Handle
Rear Handle
Strap Ring
Speed Controller
Angle Adjusting
Button
Switch Button
Vacuum/Blow
Selector Lever
Height Adjusting
Button
Window Knob
Shoulder Strap
www.SerenLifeHome.com
ASSEMBLY INSTRUCTIONS
HEIGHT ADJUSTMENT
1. Press the height adjusting button (A) and slide the Vacuum/Blower tube
(B) to desired length. (Fig. 1) It can be adjusted up to 300mm.
SHOULDER STRAP INSTALLATION
1. Attach the strap clip to the top of main body. (Fig. 2)
2. With machine on operation's right hand side, place shoulder strap across
chest and over left shoulder.
FITTING THE COLLECTION BAG
8
WARNING: Always switch o tool and unplug cord from outlet
before removing vacuum bag for emptying.
Fig. 2
Fig. 1
A
B
Before tting the collection bag ensure that the Vacuum/Blow
selector lever operates smoothly and that it is not obstructed by
debris from the previous use.
www.SerenLifeHome.com
To Install the Collection Bag
1. Insert the buckle (A) of support frame into the slot of the housing. Frame
will click into position when properly tted. (Fig. 3A)
To Dismantle the Collection Bag
1. Press the spring lever (B) to release the bag. (Fig. 3B)
FRONT HANDLE ADJUSTMENT
1. Press the angle adjusting buttons (A) on the front handle. (Fig. 4)
2. Adjust the front handle (B) to a comfortable angle.
3. Release the adjusting buttons and the handle will automatically reset to
lock position.
9
Fig. 3A
A
Fig. 3B
B
Fig. 4
A
B
www.SerenLifeHome.com
RAKE ADJUSTMENT
1. Rotate the rake knob (A) 90 anticlockwise and then the rake will
automatically pup-up. (Fig. 5A)
2. Lock the knob by rotating 90 clockwise. (Fig. 5B)
OPERATION INSTRUCTIONS
Before Starting
Plug the Blower/Vacuum/Shredder into the mains supply via the (R.C.D.)
and switch on. Check that the (R.C.D.) is operating correctly.
Starting the Blower/Vacuum/Shredder
To start the Blower/Vacuum/Shredder ensure that the Vacuum/Blower tube
is tted correctly and attach the collection bag. Without the collection bag
assembled, you cannot start the Blower/Vacuum/Shredder, since serious
injury from the fan or ying debris could result.
Select either the Vacuum or Blower function using the selector lever on the
side of the machine and press the switch button .If more power is required,
slide the speed controller from position 1 to position max.
Stopping the Blower/Vacuum/Shredder
To turn OFF the machine you can simply release the switch button.
Using the Blower/Vacuum/Shredder
Do not attempt to pick up wet debris, allow fallen leaves etc., to dry out
before using the Blower/Vacuum/Shred- der. The Blower/Vacuum/Shredder
can be used to blow debris from patios, paths, driveways, lawns, bushes
10
Fig. 5A
A
Fig. 5B
WARNING: Before selecting either Vacuum or Blower function
ensure that the selector lever operates smoothly and that it is not
obstructed by debris from the previous use.
Tabla de contenidos
Otros manuales de Soplador de SereneLife
