Sensio SA10372 Manual de usuario

Installation

Instructions Product #: SA10372

IMPORTANT: Please read these instructions before starting installation and retain for future reference.

Required Materials: Required Tools :

Important Safety Information

Drill

Bit

Driver

(Sold Separately)

Scissors

Pencil

Please read these instructions carefully before attempting to install this product.

It is advisable to keep these instructions in a safe place for further reference. These products must not be modified; if

any modifications are made, it may invalidate the warranty and may render the product unsafe. These LED lights

operate on low voltage (24V). Do not wire the individual LED light fixtures directly to line power. This product is for

indoor use only. Keep out of moisture and use only in dry rooms.

The National Electrical Code (NEC) does not permit cords to be concealed where damage to insulation may go

unnoticed. To prevent fire danger, do not run cord behind walls, ceilings, soffits, or cabinets where it may be

inaccessible for examination. Cords should be visually examined periodically and immediately replaced when any

damage is noted.

CAUTION -To reduce the risk of fire, electric shock, or injury to persons:

a) Use only insulated staples or plastic ties to secure cords

b) Route and secure cords so that they will not be pinched or damaged when the cabinet is pushed to the wall

c) Not intended for recessed installation in ceilings, or soffits.

Driver Lead

(Sold Separately)

Staple Gun

(optional)

Screwdrive

r Bit

Flexible 16.4’ (5 meter)

24W 300 Diode IP65

Strip Light

Flexible Strip

Safety Instructions

1. Turn off the main electrical supply for the appropriate circuit

at the fuse board.

2. This product is only suitable for connecting to a 24V DC power

source.

3. Position lights where they will not be exposed to persistent

steam, splashes, etc.

4. The LEDs in this fixture cannot be replaced.

5. Suitable for under cabinet lighting, attached to a mounting

surface such as wood or laminate.

6. Failure to use surge protection in problem areas will void the

warranty.

7. Use only approved accessories.

8. IMPORTANT: Fixture must NOT be covered by insulation.

Measuring

Tape

Flexible 16.4’ (5 Meter) 24W 300 Diode

IP65\Strip Light

Installation

Sensio America

877-501-5337

www.sensioamerica.com

•Ensure that the power is disconnected prior to cleaning.

•To keep the finish of this product, wipe over with soft cloth

periodically.

•Do not use harsh chemical solvents, it may discolor or

damage the finish.

Maintenance & Care Support

Drill 5/16" hole in bottom front

corner.

Connect driver to power.

Connect to driver.

Staple wire in place along inside

front edge of cabinet (optional).

Determine placement (front,

center, or back) and use pencil to

draw line.

Measure line drawn. Clean surface

with rubbing alcohol and let dry.

Feed driver lead wire through hole up

along inside front corner of cabinet.

Adhere strip along line, driver lead

on side of drilled hole.

Feed driver lead to LED driver.

Attach driver lead into strip.

Cut excess plastic off, cut strip on

scissor line indicator.

Peel off backing.

(FRONT OF CABINET)

Tabla de contenidos

Otros manuales de Equipo de iluminación de Sensio

Sensio

Sensio CONNEX SE100190 Manual de usuario

Sensio

Sensio SE10755P0 Manual de usuario

Sensio

Sensio Verso SE16092N0 Manual de usuario

Sensio

Sensio Gamma SE183720 Manual de usuario

Sensio

Sensio SA9007 Manual de usuario

Sensio

Sensio SE14092P0 Manual de usuario

Sensio

Sensio SE184720 Manual de usuario

Sensio

Sensio Ark TrioTone SE11192T0 Manual de usuario

Sensio

Sensio Treos SE11290N0 Manual de usuario

Sensio

Sensio Vector SE181700 Manual de usuario

Sensio

Sensio Beam SE982120 Manual de usuario

Sensio

Sensio Stellar Pro Manual de usuario

Sensio

Sensio SE14092N0 Manual de usuario

Sensio

Sensio Horizon Pro SE11095P0 Manual de usuario

Sensio

Sensio Polar Manual de usuario

Sensio

Sensio SE10615C0 Manual de usuario

Sensio

Sensio Sigma 2 Manual de usuario

Sensio

Sensio Blaze SE182720 Manual de usuario

Sensio

Sensio SIGMA S-BEND FLEXIBLE STRIP Manual de usuario

Sensio

Sensio SE9080HD Manual de usuario

Sensio

Sensio Linia SE980320 Manual de usuario

Sensio

Sensio Polar IP65 Manual de usuario

Sensio

Sensio Fino SE981320 Manual de usuario

Sensio

Sensio Dart/Primo 2 Manual de usuario

Manuales populares de Equipo de iluminación de otras marcas

Brizo

Brizo 8SP-MU-4 Manual de usuario

LUCE&LIGHT

LUCE&LIGHT BROM 1.0 Manual de usuario

IKEA

IKEA BJÖRKSPIREA Manual de usuario

Laserworld

Laserworld Evolution Series ES-400RGB Manual de usuario

Alien

Alien RG STAR Manual de usuario

EuroLite

EuroLite LED B-40 Manual de usuario

Qazqa

Qazqa Suplux SL 3 Black 103062 Manual de usuario

Commercial Electric

Commercial Electric 54568141 Manual de usuario

CREE LIGHTING

CREE LIGHTING 304 Series Manual de usuario

Goobay

Goobay 49867 Manual de usuario

ECOMAN ITALIA

ECOMAN ITALIA LED T8 Manual de usuario

Alkalite

Alkalite Krypton KT-81 Manual de usuario

Clas Ohlson

Clas Ohlson GU10 Manual de usuario

DTS

DTS DELTA 10 F Manual de usuario

ring

ring Solar Steplight Manual de usuario

One Stop Gardens

One Stop Gardens 57696 Instrucciones de montaje

Chauvet DJ

Chauvet DJ COREpar UV120 ILS Manual de usuario

SIREM

SIREM Swimeo A2 Manual de usuario