Doc. # DPB00006 3
Device Operating Manual
PT300D with SP300
In order to use your PT300D, you’ll need to
have the battery in your Sensor Pack fully
charged. To do this, simply plug the supplied AC
Adapter and cable into any standard electrical
receptacle. A full charge can take up to nine
hours.
SP300 Sensor
Pack
AC Adapter
Battery Tips
The Sensor Pack contains the PT300D battery.
Battery life depends on such factors as the
network, signal strength, temperature,
configuration, and the accessories you use.
a. Always use Sendum original batteries and
battery chargers. The warranty does not
cover damage caused by non-Sendum
batteries or chargers.
b. New batteries or batteries stored for a long
time may take more time to charge.
c. When charging your battery, keep it near
room temperature.
d. When storing your battery, keep it
uncharged in a cool, dark, dry place, such
as a refrigerator.
e. Never expose batteries to temperatures
below -20°C or above 65°C.
f. It is normal for batteries to lose capacity
over time. If you notice a change in your
battery life, it is probably time to purchase
a new battery.
Never dispose of batteries in a fire
because they may explode.
Before using your device, please read the
battery safety information in the “Safety, Care,
and Handling” section.
Safety, Care, and Handling
a. This device contains sensitive electronic
components.
b. Do not puncture or crush.
c. Do not drop or expose to violent impact or
shock. This can cause mechanical damage.
d. Do not place in contact with liquids.
e. Do not store or transport flammable liquids,
gases, or explosive materials in the same
compartment as your PT300D or any of its
accessories.
f. Never attempt to disassemble. If service or
repair is required, return the device to an
authorized Sendum service center.
g. Do not incinerate. Never attempt to dispose
of your device by throwing it into a fire.
h. Only charge with charger purchased with
device. Use of incompatible equipment could
result in fire, electric shock, or bodily injury.
i. Do not charge in moist environments or if
the charger cables are damaged.
j. Do not subject product to prolonged heat
or high temperatures. This can cause heat
damage to the plastic components, the
electronic components, and the battery.
k. Never use harsh chemicals, cleaning
solvents, or strong detergents to clean your
device.
